參數資料
型號: PIC16F872-I/SO
廠商: Microchip Technology
文件頁數: 97/167頁
文件大?。?/td> 0K
描述: IC MCU FLASH 2KX14 EE 28SOIC
產品培訓模塊: Asynchronous Stimulus
8-bit PIC® Microcontroller Portfolio
標準包裝: 27
系列: PIC® 16F
核心處理器: PIC
芯體尺寸: 8-位
速度: 20MHz
連通性: I²C,SPI
外圍設備: 欠壓檢測/復位,POR,PWM,WDT
輸入/輸出數: 22
程序存儲器容量: 3.5KB(2K x 14)
程序存儲器類型: 閃存
EEPROM 大?。?/td> 64 x 8
RAM 容量: 128 x 8
電壓 - 電源 (Vcc/Vdd): 4 V ~ 5.5 V
數據轉換器: A/D 5x10b
振蕩器型: 外部
工作溫度: -40°C ~ 85°C
封裝/外殼: 28-SOIC(0.295",7.50mm 寬)
包裝: 管件
產品目錄頁面: 639 (CN2011-ZH PDF)
配用: XLT28SO-1-ND - SOCKET TRANSITION 28SOIC 300MIL
309-1073-ND - ADAPTER 28-SOIC TO 28-SOIC
309-1024-ND - ADAPTER 28-SOIC TO 28-DIP
309-1023-ND - ADAPTER 28-SOIC TO 28-DIP
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁當前第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁
35
8048C–AVR–02/12
ATtiny43U
8.
Power Supply and On-Chip Boost Converter
In order to work properly microcontrollers typically require a supply voltage level that can not be
provided by battery packs of less than two or three battery cells. This constraint adds to size,
cost and complexity of the design. The integrated boost converter of ATtiny43U bridges the gap
between minimum supply voltage of the device and typical output voltages of single-cell stan-
dard, alkaline, Lithium, NiCd or NiMH batteries. The boost converter enables the device to be
powered from a source with a supply voltage well below 1V.
A block diagram illustrating the use of the boost converter is shown in Figure 8-1, below.
Figure 8-1.
Block Diagram of Boost Converter Usage.
8.1
Overview
A boost converter is a device that converts a DC voltage to a higher level. The integrated boost
converter of ATtiny43U provides the microcontroller (and its peripherals) with a fixed supply volt-
age, generated from an external supply of lower voltage.
The ATtiny43U boost converter is a switching type, step-up converter that uses an external
inductor, a diode and bypass capacitors. The boost converter is self-sufficient, completely inde-
pendent and does not need any control from the MCU. The converter starts automatically as
soon as there is sufficient voltage at the V
BAT pin. See Table 20-7 on page 162 for electrical
characteristics.
The microcontroller starts as soon as the regulated output of the boost converter rises above
power-on and brown-out reset levels (if enabled), as described in section “System Control and
Reset” on page 49. After the MCU is released from reset and has started running the application
software can then measure the battery voltage and decide if there is sufficient voltage to con-
tinue operation.
The boost converter continuously switches between storing energy in and draining energy from
the external inductor. During the charge phase the current through the inductor ramps up at a
rate determined by the converter input voltage. During the discharge phase energy stored in the
inductor is released to the load and the current in the inductor ramps down at a rate determined
by the difference between the input and output voltages.
The boost converter requires some external components to operate. See Figure 8-2 on page 36
for component placement. The circuit is completed by inserting an inductor between node VIN
and pin LSW, and a Schottky diode between pins LSW and V
CC. In addition, an input capacitor
and external bypass capacitor from V
CC to GND are typically required. See “Characteristics” on
page 45 for more details.
REGULATOR
MCU
EXTERNAL
COMPONENTS
VBAT
LSW
16
ATtiny43U
I/O
VCC
GND
VIN
相關PDF資料
PDF描述
PIC16F872-I/SP IC MCU FLASH 2KX14 EE 28DIP
ATTINY11-6SC IC AVR MCU 1K FLASH 6MHZ SO8
PIC16C711-04I/P IC MCU OTP 1KX14 A/D 18DIP
PIC16F870-I/SP IC MCU FLASH 2KX14 EE 28DIP
ATTINY11-6PI IC AVR MCU 1K FLASH 6MHZ IT 8DIP
相關代理商/技術參數
參數描述
PIC16F872T-E/SO 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 22 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC16F872T-E/SS 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 22 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC16F872T-I/SO 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 22 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC16F872T-I/SS 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 22 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC16F872T-I/SS033 制造商:Microchip Technology Inc 功能描述: