
2
PS8510
12/12/00
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012
PI3V330
3.3V, Low ON ResistanceWideband/
Video Quad 2-Channel Mux/Demux
DC Electrical Characteristics (Over the Operating Range, TA = 40°C to +85°C, VCC = 3.3V ±5%)
Parameters Description
TestConditions(1)
Min.
Typ(2)
Max.
Units
VANALOG Analog Signal Range
0
2.0
V
VIH
InputHIGHVoltage
GuaranteedLogicHIGHLevel
2.0
V
VIL
Input LOW Voltage
GuaranteedLogicLOWLevel
0.5
0.8
V
IIH
InputHIGHCurrent
VCC=Max.,VIN=VCC
±1
A
IIL
Input LOW Current
VCC=Max.,VIN=GND
±1
A
IO
Analog Output Leakage Current
0 ≤≤≤≤≤S1, S2 or D ≤≤≤≤≤VCC, Switch Off
±1
A
VIK
ClampDiodeVoltage
VCC = Min., IIN = 18mA
0.8
V
IOS
Short Circuit Current(3)
S1,S2,D=0V VCC
100
mA
VH
Input Hysteresis at Control Pins
150
mV
RON
Switch On Resistance(4)
VCC=Min.,VIN=1.0V
8
11
RL = 75, ION = 13mA
VCC=MIN.,VIN=2.0V
10
14
RL = 75, ION = 26mA
Storage Temperature ........................................................... 65°Cto+150°C
Ambient Temperature with Power Applied ........................... 40°Cto+85°C
Supply Voltage to Ground Potential (Inputs & Vcc Only) ..... 0.5Vto+4.6V
Supply Voltage to Ground Potential (Outputs & D/O Only) .. 0.5Vto+4.6V
DC Input Voltage ................................................................... 0.5Vto+4.6V
DC Output Current ............................................................................. 120mA
Power Dissipation ................................................................................. 0.5W
Note:
Stresses greater than those listed under MAXIMUM
RATINGSmaycausepermanentdamagetothedevice.
This is a stress rating only and functional operation of
the device at these or any other conditions above
those indicated in the operational sections of this
specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may
affectreliability.
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loading.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. Measured by the voltage drop between S1, S2, and D I/O pins at indicated current through the switch. ON resistance is determined
by the lower of the voltages on the S1, S2, and D I/O pins.
MaximumRatings
(Above which the useful life may be impaired. For user guidelines, not tested.)