參數資料
型號: PI2EQX3211BHEX
廠商: Pericom
文件頁數: 3/5頁
文件大?。?/td> 0K
描述: IC REPEATER/EQUALIZER 2CH 20SSOP
標準包裝: 2,000
系列: *
3
PS8901B
05/16/08
PI2EQX3211B
3.2Gbps 2 Differential Channel Serial Re-driver
Equalization, Squelch and Flow-Through Pinout
Storage Temperature........................................................ –65°C to +150°C
Supply Voltage to Ground Potential................................... –0.5V to +2.5V
DC SIG Voltage.......................................................... –0.5V to VCC +0.5V
Current Output ................................................................-25mA to +25mA
Power Dissipation Continous ......................................................... 500mW
Operating Temperature.............................................................. 0 to +70°C
Note:
Stresses greater than those listed under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is
a stress rating only and functional operation of the device
at these or any other conditions above those indicated in
the operational sections of this specication is not implied.
Exposure to absolute maximum rating conditions for ex-
tended periods may affect reliability.
Maximum Ratings
(Above which useful life may be impaired. For user guidelines, not tested.)
AC/DC Electrical Characteristics
Symbol
Parameter
Conditions
Min.
Typ.
Max.
Units
Ps
Supply Power
EN = LVCMOS Low
0.1
W
EN = LVCMOS High
0.3
Latency
From input to output
2.0
ns
CML Receiver Input
VRX-DIFFP-P
Differential Input Peak-to-
peak Voltage
0.200
V
VRX-CM-ACP
AC Peak Common Mode
Input Voltage
150
mV
VTHSD
Signal Detect Threshold
EN = High
50
200
ZRX-DIFF-DC
DC Differential Input
Impedance
80
100
120
Ω
ZRX-DC
DC Input Impedance
40
50
60
Equalization
JRS
Residual Jitter(1,2)
Total Jitter
0.3
Ulp-p
Deterministic jitter
0.2
JRM
Random Jitter(1,2)
1.5
psrms
Notes
1.
K28.7 pattern is applied differentially at point A as shown in Figure 1.
2.
Total jitter does not include the signal source jitter. Total jitter (TJ) = (14.1 × RJ + DJ) where RJ is random RMS jitter and DJ is maximum
deterministic jitter. Signal source is a K28.5 ± pattern (00 1111 1010 11 0000 0101) for the deterministic jitter test and K28.7 (0011111000) or
equivalent for random jitter test. Residual jitter is that which remains after equalizing media-induced losses of the environment of Figure 1 or
its equivalent. The deterministic jitter at point B must be from media-induced loss, and not from clock source modulation. JItter is measured at
0V at point C of Figure 1.
08-0113
相關PDF資料
PDF描述
PI2EQX4401DZFEX IC PCI-E REPEATER/EQUALZR 36TQFN
PI2EQX4401ZFE IC PCI-EXPRESS REPEATER 36TQFN
PI2EQX4402DNBEX IC PCI-E REPEATER/EQUALR 84LFBGA
PI2EQX4402NBE IC PCI-EXPRESS REPEATER 84-LFBGA
PI2EQX4432DZDEX IC PCI-E REPEATER/EQUALR 48TQFN
相關代理商/技術參數
參數描述
PI2EQX3231BLZHE 功能描述:緩沖器和線路驅動器 3.0 Gbps 1-port SATA i/m ReDriver RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel
PI2EQX3231BLZHEX 功能描述:緩沖器和線路驅動器 3.0 Gbps 1-port SATA i/m ReDriver RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel
PI2EQX3232AZDE 功能描述:緩沖器和線路驅動器 3.2Gbps 4 Channel SAS/SATA RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel
PI2EQX3232AZDEX 功能描述:緩沖器和線路驅動器 3.2Gbps 4 Channel SAS/SATA RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel
PI2EQX3232B 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:3.2Gbps, 2-Port, SATAi/m, Serial Re-Driver