- 您現在的位置：買賣IC網 > PDF目錄385711 > PDSP16515AA0GC (Mitel Networks Corporation) Stand Alone FFT Processor PDF資料下載
參數資料
| 型號： | PDSP16515AA0GC |
| 廠商： | Mitel Networks Corporation |
| 英文描述： | Stand Alone FFT Processor |
| 中文描述： | 攻殼機動隊FFT處理器 |
| 文件頁數： | 23/27頁 |
| 文件大?。?/td> | 289K |
| 代理商： | PDSP16515AA0GC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁
PDSP16515A
23
DOS can now be switched on for at least one pulse (but may
be more), and the sequence of events as described earlier
(from point No 3.3) will start. DEN can then be made active,
whereby a further 4 DEN-Enabled DOS pulses will be required
before data is seen on the output pins. This is the situation
shown in table 3.
Alternatively, DEN and DOS could be made to operate on the
same cycle. In this case data will appear on the output pins on
the 5th DOS pulse (the first would not actually require the
presence of DEN, but the 2nd, 3rd, 4th and 5th would)
(4.3) 1024 point transforms, single device mode.
In the case of 1024 point transforms, the internal RAM is no
longer operated in the manner described in section 2. The
RAM is instead totally dedicated to one operation at a time.
Thus data for a transform will be loaded, and all 12 out of 12
SCLK cycles will be available for the transfer of input data to
the RAMs. During the transfrom no transfers from the input to
the RAM or from the RAM to the output are possible. This is
why DIS and DOS can be equal to SCLK for 1024 point
transforms.
If 1024 point transforms are being performed and the
device is programmed as a single device, then
"asynchronous" operation of DAV is possible as described
earlier for transform sizes less than 1024 points. If DEN is
inactive at the time the transform has finished calculating, then
DAV will be made to go active regardless of the state of DOS.
Although 6 SCLK cycles do not have to be waited for as in
section 3.2, a transition has to be made from the transform
controlling the internal RAM to the output circuits cntrolling it.
This operation plus the time taken to advance data from the
RAMs to the output buffer takes exactly 4 SCLK cycles.
Hence the sequence of events is exactly as described in
section 3, except that section 3.3 should read 4 SCLK cycles
rather than 6. The analysis of sections 4.1 nad 4.2 are also true
if the 6 SCLK cycle time is substituted with 4 SCLK cycles.
Dummy DOS Strobes After DEF
In addition to the dummy DOS strobes needed prior to
dumping data, it is necessary to provide at least 4 DOS strobes
after DEF has gone inactive, but before DAV goes active.
These initialise the internal address counters and do not rely
on DEN also being active. They are needed every time DEF
has been used to change the operating mode.
相關PDF資料 |
PDF描述 |
|---|---|
| PDSP16515AC0AC | Stand Alone FFT Processor |
| PDSP16515AC0GC | Stand Alone FFT Processor |
| PDSP16515A | Stand Alone FFT Processor |
| PDSP16515MA | Stand Alone FFT Processor |
| PDSP16515AB0AC | Stand Alone FFT Processor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PDSP16515AA0GCPR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Fast Fourier Transform Processor |
| PDSP16515AB0AC | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:Stand Alone FFT Processor |
| PDSP16515AB0ACBR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Fast Fourier Transform Processor |
| PDSP16515AB0GC | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:Stand Alone FFT Processor |
| PDSP16515AB0GCPR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Fast Fourier Transform Processor |
發布緊急采購，3分鐘左右您將得到回復。