- 您現在的位置：買賣IC網 > PDF目錄367814 > PCF1171C (NXP Semiconductors N.V.) 4-digit LCD car clock(4數字LCD汽車時鐘) PDF資料下載
參數資料
| 型號： | PCF1171C |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | 4-digit LCD car clock(4數字LCD汽車時鐘) |
| 中文描述： | 4位LCD汽車時鐘（4數字液晶汽車時鐘） |
| 文件頁數： | 5/16頁 |
| 文件大?。?/td> | 112K |
| 代理商： | PCF1171C |
1997 Apr 16
5
Philips Semiconductors
Product specification
4-digit LCD car clock
PCF1171C
Time correction
±
2 minutes, switch S3
This switch operates in two ranges:
Displayed time
≥
58 minutes 00 seconds
Displayed time
≤
1 minute 59 seconds.
When switch S3 is pressed in these ranges, the minutes
and seconds are reset to zero. For displayed
time
≥
58 minutes 00 seconds, the hour is also
incremented by one.
INPUT OPTIONS
In the description below S4, S5 and S6 refer to the external
switches shown in Fig.5 rather than to the corresponding
inputs.
In a real application, these inputs will normally be bonded
to the appropriate level to give the required function mode.
Internal/external regulation, switch S4
For internal regulation, S4 is closed, the internal voltage
regulator is active and the voltage supply for the LCD is
regulated to 5 V. For external regulation, S4 is open and
the circuit has to be supplied with an externally regulated
voltage.
12/24-hour mode, switch S5
For 12-hour display mode, S5 is connected to V
DD
.
For 24-hour display mode, S5 is connected to V
SS
.
Single/continuous correction mode, switch S6
For single-set correction mode, S6 is connected to V
DD
.
Each closure of S1 or S2 advances the counter by one.
For continuous-set correction mode, S6 is connected to
V
SS
. Momentary closure of S1 or S2 causes single
increments as for single-set correction mode. If S1 or S2 is
kept closed for more than 1s, the counter is automatically
incremented by 1 for each full second that S1 or S2 is kept
closed.
TESTING
In normal operation the test inputs TR (pin 38) and TS
(pin 39) have to be connected to V
DD
(pin 23). A test
frequency (64 Hz) is available at BP (pin 5). The test mode
is activated by connecting TS to V
SS
(pin 20). All output
frequencies are then increased by a factor of 65536.
In this mode the maximum input frequency is 100 kHz
(external generator at OSC IN). By connecting TR to V
SS
all counters (seconds, minutes and hours) are stopped.
After connecting TR to V
DD
all counters start from an initial
state.
The switches/inputs described above also operate in the
test mode.
LIMITING VALUES
In accordance with the Absolute Maximum Rating System (IEC 134).
Note
1.
Connecting the supply voltage with reverse polarity, will not harm the circuit, provided the current is limited to 10 mA
by the external resistor.
HANDLING
Inputs and outputs are protected against electrostatic discharges in normal handling. However, to be totally safe, it is
advisable to take handling precautions appropriate to handling MOS devices. Advice can be found in
“Data Handbook IC16, General, Handling MOS Devices”
SYMBOL
PARAMETER
CONDITIONS
MIN.
MAX.
UNIT
V
DD
supply voltage with respect to V
SS
with internal
regulation disconnected;
all input voltages
operating ambient temperature
storage temperature
note 1
8
V
V
I
T
amb
T
stg
V
SS
0.3
40
55
V
DD
+ 0.3
+85
+125
V
°
C
°
C
相關PDF資料 |
PDF描述 |
|---|---|
| PCF1171CT | 4-digit LCD car clock |
| PCF1171CU | 4-digit LCD car clock |
| PCF1172C | 3 1 /2 -digit LCD car clock(3 1 /2 數字 LCD汽車時鐘) |
| PCF1172CT | 31/2-digit LCD car clock |
| PCF1172CU | 31/2-digit LCD car clock |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCF1171CT | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:4-digit LCD car clock |
| PCF1171CU | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:4-digit LCD car clock |
| PCF1172C | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:31/2-digit LCD car clock |
| PCF1172CT | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:31/2-digit LCD car clock |
| PCF1172CU | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:31/2-digit LCD car clock |
發布緊急采購，3分鐘左右您將得到回復。