- 您現在的位置：買賣IC網 > PDF目錄383704 > OPT209 Photodiode with On-Chip Amplifier PDF資料下載
參數資料
| 型號： | OPT209 |
| 英文描述： | Photodiode with On-Chip Amplifier |
| 中文描述： | 光電二極管帶有片上放大器 |
| 文件頁數： | 8/11頁 |
| 文件大?。?/td> | 183K |
| 代理商： | OPT209 |
8
OPT201
When used with very large feedback resistors, tiny leakage
currents on the circuit board can degrade the performance of
the OPT201. Careful circuit board design and clean assembly
procedures will help achieve best performance. A “guard
ring” on the circuit board can help minimize leakage to the
critical non-inverting input (pin 2). This guard ring should
encircle pin 2 and connect to Common, pin 8.
DYNAMIC RESPONSE
Using the internal 1M
resistor, the dynamic response of
the photodiode/op amp combination can be modeled as a
simple R/C circuit with a –3dB cutoff frequency of 4kHz.
This yields a rise time of approximately 90
μ
s (10% to 90%).
Dynamic response is not limited by op amp slew rate. This
is demonstrated by the dynamic response oscilloscope
photographs showing virtually identical large-signal and
small-signal response.
Dynamic response will vary with feedback resistor value as
shown in the typical performance curve “Voltage Output
Responsivity vs Frequency.” Rise time (10% to 90%) will
vary according to the –3dB bandwidth produced by a given
feedback resistor value—
t
R
≈
0.35
where:
t
R
is the rise time (10% to 90%)
f
C
is the –3dB bandwidth
LINEARITY PERFORMANCE
Current output of the photodiode is very linear with radiant
power throughout a wide range. Nonlinearity remains below
approximately 0.02% up to 100
μ
A photodiode current. The
photodiode can produce output currents of 1mA or greater
with high radiant power, but nonlinearity increases to several
percent in this region.
This very linear performance at high radiant power assumes
that the full photodiode area is uniformly illuminated. If the
light source is focused to a small area of the photodiode,
nonlinearity will occur at lower radiant power.
NOISE PERFORMANCE
Noise performance of the OPT201 is determined by the op
amp characteristics in conjunction with the feedback
components and photodiode capacitance. The typical
performance curve “Output Noise Voltage vs Measurement
Bandwidth” shows how the noise varies with R
F
and measured
bandwidth (1Hz to the indicated frequency). The signal
bandwidth of the OPT201 is indicated on the curves. Noise
can be reduced by filtering the output with a cutoff frequency
equal to the signal bandwidth.
Output noise increases in proportion to the square-root of the
feedback resistance, while responsivity increases linearly
with feedback resistance. So best signal-to-noise ratio is
achieved with large feedback resistance. This comes with
the trade-off of decreased bandwidth.
The noise performance of a photodetector is sometimes
characterized by Noise Effective Power (NEP). This is the
radiant power which would produce an output signal equal
to the noise level. NEP has the units of radiant power
(watts). The typical performance curve “Noise Effective
Power vs Measurement Bandwidth” shows how NEP varies
with R
F
and measurement bandwidth.
f
C
(1)
FIGURE 3. Dark Error (Offset) Adjustment Circuit.
1M
OPT201
3
40pF
75
2
8
5
4
1
V
O
V–
λ
V+
0.01μF
500
V+
V–
100μA
1/2 REF200
100
100
100μA
1/2 REF200
Adjust dark output for 0V.
Trim Range: ±7mV
FIGURE 4. Responsivity (Gain) Adjustment Circuit.
1M
OPT201
3
40pF
75
2
8
5
4
1
V
O
V–
λ
V+
10k
5k
Gain Adjustment
+50%; –0%
R
F
相關PDF資料 |
PDF描述 |
|---|---|
| OPT400002 | 16-BIT I/O EXPANDERS WITH I2C & SPI INTERFACE, -40C to +125C, 28-QFN, T/R |
| OPT400003 | 16-BIT I/O EXPANDERS WITH I2C & SPI INTERFACE, -40C to +125C, 28-SSOP 208mil, T/R |
| OPT49LP | Filter Response |
| OPTEK-XREF | Optoelectronic |
| OPTI82C463-33 | Digital CAN I/O Exp, one wire capable, -40C to +85C, 14-PDIP, TUBE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OPT209P | 制造商:BB 制造商全稱:BB 功能描述:PHOTODIODE WITH ON-CHIP AMPLIFIER |
| OPT209P-J | 制造商:BB 制造商全稱:BB 功能描述:PHOTODIODE WITH ON-CHIP AMPLIFIER |
| OPT-20A | 制造商:Payne Engineering Company 功能描述:OPTION-20 CARD CONTROL INPUT 制造商:Payne Engineering Company 功能描述:OPTION-20 CARD CONTROL INPUT; Series:18; Features:For use with Payne Engineerings 18D Series Single-Phase, Variable-Voltage Solid-State SCR AC Power Control ; For Use With:Payne 18D Series Solid State AC Power Control ;RoHS Compliant: NA |
| OPT-20C | 制造商:Payne Engineering Company 功能描述:OPTION-20 CARD CONTROL INPUT 制造商:Payne Engineering Company 功能描述:OPTION-20 CARD CONTROL INPUT; Series:18; Features:For use with Payne Engineerings 18D Series Single-Phase, Variable-Voltage Solid-State SCR AC Power Control ; For Use With:Payne 18D Series Solid State AC Power Control ;RoHS Compliant: NA |
| OPT210 | 制造商:BB 制造商全稱:BB 功能描述:MONOLITHIC PHOTODIODE AND AMPLIFIER 300kHz Bandwidth at RF = 1MW |
發布緊急采購，3分鐘左右您將得到回復。