參數資料
型號： OPA3681U
英文描述： Triple Wideband, Current-Feedback OPERATIONAL AMPLIFIER With Disable
中文描述： 三寬帶，電流反饋運算放大器，禁用
文件頁數： 14/21頁
文件大?。?/td> 234K
代理商： OPA3681U
14
OPA3681
termination for the DAC, R
T
. It is very useful from a
distortion standpoint to scale the characteristic impedance
up for the filter. This reduces the loading at the first stage
amplifier output, typically improving 3rd-order terms di-
rectly, as well as some improvement in 2nd-order terms.
Figure 7 assumes a 100
characteristic impedance for the
filter. The filter is driven from a 100
source resistor into a
100
load that is formed by the input gain resistor of the
inverting amplifier channel. The other non-inverting input is
isolated by a series 50
resistor—principally to isolate that
input from the out-of-band source impedance of the filter. In
this example, the output stage is set up for a differential gain
of 8. The total gain from the output of the bandpass filter to
the line will be 4 n, where n is the turns ratio used in the
transformer. Very broad bandwidths at high power levels are
possible using the OPA3681 in the circuit of Figure 7.
Recognize also, that the output is in fact bandlimited by the
filter. Very high dynamic range is possible inside the filter
bandwidth due to the significant performance margin pro-
vided by the OPA3681.
WIDEBAND DIFFERENTIAL AMPLIFIER
The differential amplifier (three amplifier instrumentation
topology) on the front page of this data sheet shows a
common application applied to this triple current feedback
op amp. The two input stage amplifiers are configured for a
relatively high differential gain of 10. Lowering the feed-
back resistor values in this input stage provides > 120MHz
bandwidth, even at this high gain setting. The signal is
applied to the high impedance, non-inverting inputs at the
input stage. The differential gain is set by (1 + 2R
F
/R
G
) = 10
using the values shown on the front page. The third amplifier
performs the differential-to-single-ended conversion in a
standard single op amp differential stage. This differential
stage, built using the 3rd wideband current-feedback op
amp, in the OPA3681 will give lower CMRR at DC than
using a voltage feedback part, but higher CMRR at higher
frequencies. Measured performance, with no resistor value
tuning, gave approximately 75dB at DC and > 55dB CMRR
(input referred) through 10MHz. To maintain good distor-
tion performance for the input stage amplifiers, the loading
at each output has been matched while achieving the gain of
1 and differential characteristic of the output stage. To
improve DC CMRR, tune the resistor to ground at the non-
inverting input of the output stage amplifier.
WIDEBAND PROGRAMMABLE GAIN
By tying all three inputs together from a single source, and
all three outputs together to drive a common load, a very
wideband, programmable gain function may be implemented.
Figure 8 shows an example of this application where the
three channels have been set up for gains of 2, 4, and 8 to
their output pins. When driving a doubly-terminated 50
load, this gives a user-selectable gain of 1, 2 and 4 to the
matched load. The feedback resistor value has been opti-
mized for maximum flat bandwidth in each channel. This
will give an almost constant > 200MHz bandwidth at any of
the three gain settings. The desired gain is selected by using
the disable control lines to choose one of the three possible
amplifiers as the active channel. An additional 10
resistor
was included inside the loop on each output stage to limit
output stage currents if more than one output is on during
gain select transition. This will reduce the maximum avail-
able output voltage swing into the 100
total load shown in
Figure 8 to approximately
±
3.2V, but will provide surge
current protection during channel switching. The 20
series
resistors on each non-inverting input serves to isolate the
input parasitic capacitance from the source.
FIGURE 7. Single-to-Differential xDSL Line Driver.
1/3
OPA3681
50
R
S
R
S
1:n
1/3
OPA3681
400
400
100
Bandpass
Filter
133
1/3
OPA3681
100
R
G
R
T
DSL
AFE
400
+5V
–5V
Supply De-Coupling
Not Shown
相關PDF資料
PDF描述
OPA3682 Triple, Wideband, Fixed Gain BUFFER AMPLIFIER With Disable
OPA3682E Triple, Wideband, Fixed Gain BUFFER AMPLIFIER With Disable
OPA3682U Triple, Wideband, Fixed Gain BUFFER AMPLIFIER With Disable
OPA404KU 256K, 32K X 8, 2.5V HI-SPEED SER EE, -40C to +85C, 8-PDIP, TUBE
OPA4650 Wideband, Low Power, Quad Voltage Feedback OPERATIONAL AMPLIFIER
相關代理商/技術參數
參數描述
OPA3681U/2K5 制造商:Rochester Electronics LLC 功能描述:- Bulk
OPA3682 制造商:BB 制造商全稱:BB 功能描述:Triple, Wideband, Fixed Gain BUFFER AMPLIFIER With Disable
OPA3682E 制造商:BB 制造商全稱:BB 功能描述:Triple, Wideband, Fixed Gain BUFFER AMPLIFIER With Disable
OPA3682E/250 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog Buffer/Voltage Follower
OPA3682E/2K5 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog Buffer/Voltage Follower
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*