- 您現在的位置：買賣IC網 > PDF目錄359243 > MVTX2804 (Zarlink Semiconductor Inc.) 8-Port 1000 Mbps Ethernet Distributed Switch PDF資料下載
參數資料
| 型號： | MVTX2804 |
| 廠商： | Zarlink Semiconductor Inc. |
| 英文描述： | 8-Port 1000 Mbps Ethernet Distributed Switch |
| 中文描述： | 8端口1000 Mbps以太網交換機分布式 |
| 文件頁數： | 36/174頁 |
| 文件大?。?/td> | 2249K |
| 代理商： | MVTX2804 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁當前第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁
MVTX2804
Data Sheet
36
Zarlink Semiconductor Inc.
The search engine retrieves the VLAN member ports from the VLAN index table, which consists of 4K entries.
The search engine retrieves the VLAN member ports from the ingress port's VLAN map. Based on the
destination MAC address, the search engine determines the egress port from the MCT database. If the egress
port is a member of a trunk group, the packet can be distributed to the other members of that trunk group. The
VLAN map is used to check whether the egress port is a member of the VLAN, based on the ingress port. If it is
a member, the packet is forwarded otherwise it is discarded.
8.3 Multicast Packet Forwarding
For multicast packet forwarding, the device must determine the proper set of ports from which to transmit the
packet based on the VLAN index and hash key.
Two functions are required in order to distribute multicast packets to the appropriate destination ports in a port
trunking environment.
Determining one forwarding port per group.
For multicast packets, all but one port per group, the forwarding port, must be excluded.
8.4 Preventing Multicast Packets from Looping Back to the Source Trunk
The search engine needs to prevent a multicast packet from sending to a port that is in the same trunk group
with the source port. This is because, when we select the primary forwarding port for each group, we do not
take the source port into account. To prevent this, we simply apply one additional filter, so as to block that
forwarding port for this multicast packet.
9.0 LED Interface
9.1 Introduction
The MVTX2804 LED block provides two interfaces: a serial output channel, and a parallel time-division
interface. The serial output channel provides port status information from the MVTX2804 chip in a continuous
serial stream. This means that a low cost external device must be used to decode the serial data and to drive an
LED array for display.
By contrast, the parallel time-division interface supports a glueless LED module. Indeed, the parallel interface
can directly drive low-current LEDs without any extra logic. The pin LED_PM is used to select serial or parallel
mode.
For some LED signals, the interface also provides a blinking option. Blinking may be enabled for LED signals
TxD, RxD, COL, and FC (to be described later). The pin LED_BLINK is used to enable blinking, and the blinking
frequency is around 160 ms.
9.2 Serial Mode
In serial mode, the following pins are utilized:
LED_SYNCO - a sync pulse that defines the boundary between status frames
LED_CLKO - the clock signal
LED_DO - a continuous serial stream of data for all status LEDs that repeats once every frame time
In each cycle (one frame of status information, or one sync pulse), 16x8 bits of data are transmitted on the
LED_DO signal. The sequence of transmission of data bits is as shown in the figure below:
相關PDF資料 |
PDF描述 |
|---|---|
| MVTX2804AG | 8-Port 1000 Mbps Ethernet Distributed Switch |
| MVV200 | Analog IC |
| MW005A | DC-to-DC Voltage Converter |
| MW005AJ | DC-to-DC Voltage Converter |
| MW005AJ4 | DC-to-DC Voltage Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MVTX2804AG | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:8-Port 1000 Mbps Ethernet Distributed Switch |
| MVTX2804AG2 | 制造商:Microsemi Corporation 功能描述: |
| MVU10-10FBK | 功能描述:端子 D-10-1103K BS-33-10-P 85299 RoHS:否 制造商:AVX 產品:Junction Box - Wire to Wire 系列:9826 線規:26-18 接線柱/接頭大小: 絕緣: 顏色:Red 型式:Female 觸點電鍍:Tin over Nickel 觸點材料:Beryllium Copper, Phosphor Bronze 端接類型:Crimp |
| MVU10-10FBX | 功能描述:端子 BLOCK FORK VNYL INS BTL BS-33-10-P RoHS:否 制造商:AVX 產品:Junction Box - Wire to Wire 系列:9826 線規:26-18 接線柱/接頭大小: 絕緣: 顏色:Red 型式:Female 觸點電鍍:Tin over Nickel 觸點材料:Beryllium Copper, Phosphor Bronze 端接類型:Crimp |
| MVU10-10FBX-BOTTLE | 功能描述:CONN FORK BLOCK INSUL 50PC RoHS:是 類別:連接器，互連式 >> 端子 - 鏟形 系列:Scotchlok™ 標準包裝:1 系列:Scotchlok™ 端子類型:彈簧，壓接式 接線柱/接片尺寸:10 接線柱 寬度 - 外邊:0.320"（8.13mm） 長度 - 總體:1.030"（26.16mm） 安裝類型:自由懸掛 端子:壓接 線規:10-12 AWG 絕緣體:絕緣 特點:- 顏色:黃 包裝:散裝 觸點表面涂層:錫 觸點材料:銅，ETP 絕緣體直徑:0.250"（6.35mm） 材料 - 絕緣體:聚酰胺（PA），尼龍 長度 - 環心道末端:0.280"（7.11mm） 長度 - 末端:0.550"（13.97mm） 內部舌簧打開:- 相關產品:TR-490-ND - HAND CRIMP TOOL RACHET 10-22 AWGTH-450-ND - TOOL HAND CRIMP 6-26AWGTR-482-ND - TOOL RATCHETING 10-22AWG CRIMP920099-R-ND - TOOL 10-22AWG SCOTCHLOK CRIMP 其它名稱:000511285879115112858791180611464373 |
發布緊急采購，3分鐘左右您將得到回復。