- 您現在的位置：買賣IC網 > PDF目錄383642 > MT88L89AC (Mitel Networks Corporation) 3V Integrated DTMFTransceiver with Adaptive Micro Interface PDF資料下載
參數資料
| 型號： | MT88L89AC |
| 廠商： | Mitel Networks Corporation |
| 英文描述： | 3V Integrated DTMFTransceiver with Adaptive Micro Interface |
| 中文描述： | 3V的綜合DTMFTransceiver自適應微型接口 |
| 文件頁數： | 6/20頁 |
| 文件大?。?/td> | 352K |
| 代理商： | MT88L89AC |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
MT88L89
Advance Information
4-130
Figure 9 - Description of Timing Events
EXPLANATION OF EVENTS
A)
TONE BURSTS DETECTED, TONE DURATION INVALID, RX DATA REGISTER NOT UPDATED.
B)
TONE #n DETECTED, TONE DURATION VALID, TONE DECODED AND LATCHED IN RX DATA REGISTER.
C)
END OF TONE #n DETECTED, TONE ABSENT DURATION VALID, INFORMATION IN RX DATA REGISTER
RETAINED UNTIL NEXT VALID TONE PAIR.
D)
TONE #n+1 DETECTED, TONE DURATION VALID, TONE DECODED AND LATCHED IN RX DATA REGISTER.
E)
ACCEPTABLE DROPOUT OF TONE #n+1, TONE ABSENT DURATION INVALID, DATA REMAINS UNCHANGED.
F)
END OF TONE #n+1 DETECTED, TONE ABSENT DURATION VALID, INFORMATION IN RX DATA REGISTER
RETAINED UNTIL NEXT VALID TONE PAIR.
EXPLANATION OF SYMBOLS
V
in
DTMF COMPOSITE INPUT SIGNAL.
ESt
EARLY STEERING OUTPUT. INDICATES DETECTION OF VALID TONE FREQUENCIES.
St/GT
STEERING INPUT/GUARD TIME OUTPUT. DRIVES EXTERNAL RC TIMING CIRCUIT.
RX
0
-RX
3
4-BIT DECODED DATA IN RECEIVE DATA REGISTER
b3
DELAYED STEERING. INDICATES THAT VALID FREQUENCIES HAVE BEEN PRESENT/ABSENT FOR THE
REQUIRED GUARD TIME THUS CONSTITUTING A VALID SIGNAL. ACTIVE LOW FOR THE DURATION OF A
VALID DTMF SIGNAL.
b2
INDICATES THAT VALID DATA IS IN THE RECEIVE DATA REGISTER. THE BIT IS CLEARED AFTER THE STATUS
REGISTER IS READ.
IRQ/CP
INTERRUPT IS ACTIVE INDICATING THAT NEW DATA IS IN THE RX DATA REGISTER. THE INTERRUPT IS
CLEARED AFTER THE STATUS REGISTER IS READ.
t
REC
MAXIMUM DTMF SIGNAL DURATION NOT DETECTED AS VALID.
t
REC
MINIMUM DTMF SIGNAL DURATION REQUIRED FOR VALID RECOGNITION.
t
ID
MINIMUM TIME BETWEEN VALID SEQUENTIAL DTMF SIGNALS.
t
DO
MAXIMUM ALLOWABLE DROPOUT DURING VALID DTMF SIGNAL.
t
DP
TIME TO DETECT VALID FREQUENCIES PRESENT.
t
DA
TIME TO DETECT VALID FREQUENCIES ABSENT.
t
GTP
GUARD TIME, TONE PRESENT.
t
GTA
GUARD TIME, TONE ABSENT.
DTMF signals cannot be detected if CP mode has
been selected (see Table 7). Figure 8 indicates the
useful detect bandwidth of the call progress filter.
Frequencies presented to the input, which are within
the ‘a(chǎn)ccept’ bandwidth limits of the filter, are hard-
limited by a high gain comparator with the IRQ/CP
pin serving as the output. The squarewave output
obtained from the schmitt trigger can be analyzed by
a microprocessor or counter arrangement to
determine the nature of the call progress tone being
detected. Frequencies which are in the ‘reject’ area
will not be detected and consequently the IRQ/CP
pin will remain low.
DTMF Generator
The DTMF transmitter employed in the MT88L89 is
capable of generating all sixteen standard DTMF
tone pairs with low distortion and high accuracy. All
frequencies are derived from an external 3.579545
MHz crystal. The sinusoidal waveforms for the
individual tones are digitally synthesized using row
and column programmable dividers and switched
capacitor D/A converters. The row and column tones
are mixed and filtered providing a DTMF signal with
low total harmonic distortion and high accuracy. To
specify a DTMF signal, data conforming to the
encoding format shown in Table 1 must be written to
the transmit Data Register. Note that this is the
same as the receiver output code. The individual
tones which are generated (f
LOW
and f
HIGH
) are
referred to as Low Group and High Group tones. As
seen from the table, the low group frequencies are
697, 770, 852 and 941 Hz. The high group
frequencies are 1209, 1336, 1477 and 1633 Hz.
Typically, the high group to low group amplitude ratio
(twist) is 2 dB to com-pensate for high group
attenuation on long loops.
Figure 8 - Call Progress Response
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
A
A
A
A
A
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AA
AA
AA
AA
LEVEL
(dBm)
FREQUENCY (Hz)
-25
0
250
500
750
= Reject
= May Accept
= Accept
相關PDF資料 |
PDF描述 |
|---|---|
| MT88L89AE | 3V Integrated DTMFTransceiver with Adaptive Micro Interface |
| MT88L89AN | 3V Integrated DTMFTransceiver with Adaptive Micro Interface |
| MT88L89AP | 3V Integrated DTMFTransceiver with Adaptive Micro Interface |
| MT88L89AS | 3V Integrated DTMFTransceiver with Adaptive Micro Interface |
| MT88V32 | 8 x 4 High Performance Video Switch Array |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT88L89AE | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:3V Integrated DTMFTransceiver with Adaptive Micro Interface |
| MT88L89AN | 制造商:Microsemi Corporation 功能描述: |
| MT88L89AN1 | 制造商:Microsemi Corporation 功能描述:DTMF TXRX 3.58MHZ CMOS 3V 24SSOP - Rail/Tube |
| MT88L89ANR1 | 制造商:Microsemi Corporation 功能描述:DTMF TXRX 3.58MHZ CMOS 3V 24SSOP - Tape and Reel 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TXRX DTMF 3V 24SSOP 制造商:Microsemi Corporation 功能描述:IC TXRX DTMF 3V 24SSOP |
| MT88L89AP | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:3V Integrated DTMFTransceiver with Adaptive Micro Interface |
發布緊急采購，3分鐘左右您將得到回復。