• <thead id="wupsp"><noframes id="wupsp"><pre id="wupsp"></pre></noframes></thead>
  • 參數資料
    型號: MT8880CN-1
    廠商: Mitel Networks Corporation
    英文描述: ISO2-CMOS Integrated DTMFTransceiver
    中文描述: ISO2 - CMOS集成DTMFTransceiver
    文件頁數: 3/18頁
    文件大?。?/td> 312K
    代理商: MT8880CN-1
    ISO
    2
    -CMOS
    MT8880C/MT8880C-1
    4-35
    Functional Description
    The MT8880C/C-1 Integrated DTMF Transceiver
    architecture consists of a high performance DTMF
    receiver with internal gain setting amplifier and a
    DTMF generator which employs a burst counter such
    that precise tone bursts and pauses can be
    synthesized. A call progress mode can be selected
    such that frequencies within the specified passband
    can be detected. A standard microprocessor
    interface allows access to an internal status register,
    two control registers and two data registers.
    Input Configuration
    The input arrangement of the MT8880C/C-1 provides
    a differential-input operational amplifier as well as a
    bias source (V
    Ref
    ) which is used to bias the inputs at
    V
    DD
    /2. Provision is made for connection of a
    feedback resistor to the op-amp output (GS) for
    adjustment of gain. In a single-ended configuration,
    the input pins are connected as shown in Figure 3.
    Figure 4 shows the necessary connections for a
    differential input configuration.
    Figure 3 - Single-Ended Input Configuration
    Receiver Section
    Separation of the low and high group tones is
    achieved by applying the DTMF signal to the inputs
    of two sixth-order switched capacitor bandpass
    filters, the bandwidths of which correspond to the low
    and high group frequencies (see Fig. 7). These filters
    also incorporate notches at 350 Hz and 440 Hz for
    exceptional dial tone rejection. Each filter output is
    followed by a single order switched capacitor filter
    section which smooths the signals prior to limiting.
    Limiting is performed by high-gain comparators
    C
    R
    IN
    R
    F
    IN+
    IN-
    GS
    V
    Ref
    VOLTAGE GAIN
    (A
    V
    ) = R
    F
    / R
    IN
    MT8880C/C-1
    Figure 4 - Differential Input Configuration
    which are provided with hysteresis to prevent
    detection of unwanted low-level signals. The outputs
    of the comparators provide full rail logic swings at
    the frequencies of the incoming DTMF signals.
    Following the filter section is a decoder employing
    digital counting techniques to determine the
    frequencies of the incoming tones and to verify that
    they correspond to standard DTMF frequencies. A
    complex averaging algorithm protects against tone
    simulation by extraneous signals such as voice while
    providing tolerance to small frequency deviations
    and variations. This averaging algorithm has been
    developed to ensure an optimum combination of
    immunity to talk-off and tolerance to the presence of
    interfering frequencies (third tones) and noise. When
    the detector recognizes the presence of two valid
    tones (this is referred to as the “signal condition” in
    some industry specifications) the “Early Steering”
    (ESt) output will go to an active state. Any
    subsequent loss of signal condition will cause ESt to
    assume an inactive state.
    C1
    C2
    R1
    R2
    R3
    R4
    R5
    IN+
    IN-
    GS
    V
    Ref
    MT8880C/C-1
    DIFFERENTIAL INPUT AMPLIFIER
    C1 = C2 = 10 nF
    R1 = R4 = R5 = 100 k
    R2 = 60k
    , R3 = 37.5 k
    R3 = (R2R5)/(R2 + R5)
    VOLTAGE GAIN
    (A
    V
    diff) = R5/R1
    INPUT IMPEDANCE
    (Z
    IN
    diff) = 2
    R1
    2
    + (1/
    ω
    C)
    2
    相關PDF資料
    PDF描述
    MT8880CP-1 ISO2-CMOS Integrated DTMFTransceiver
    MT8880CS-1 ISO2-CMOS Integrated DTMFTransceiver
    MT8880C Integrated DTMF Transceiver(雙音多頻信號(DTMF)收發器(帶電話程序?yàn)V波器))
    MT8885AE Integrated DTMFTransceiver with Power Down & Adaptive Micro Interface
    MT8885AN Integrated DTMFTransceiver with Power Down & Adaptive Micro Interface
    相關代理商/技術參數
    參數描述
    MT8880CP 制造商:Microsemi Corporation 功能描述:
    MT8880CP/CP-1 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:Integrated DTMFTransceiver
    MT8880CP1 制造商:Microsemi Corporation 功能描述: 制造商:Microsemi Corporation 功能描述:DTMF TXRX 3.58MHZ CMOS 5V 28PLCC - Rail/Tube 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TXRX DTMF 28PLCC 制造商:Microsemi Corporation 功能描述:IC TXRX DTMF 28PLCC
    MT8880CP-1 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:ISO2-CMOS Integrated DTMFTransceiver
    MT8880CPR 制造商:Microsemi Corporation 功能描述: 制造商:Microsemi Corporation 功能描述:DTMF TXRX 3.58MHZ CMOS 5V 28PLCC - Tape and Reel
    <thead id="ph4th"><xmp id="ph4th"><em id="ph4th"></em>
  • <thead id="ph4th"><sup id="ph4th"></sup></thead>