- 您現在的位置：買賣IC網 > PDF目錄45317 > MQ80C154-L16/883R (TEMIC SEMICONDUCTORS) 8-BIT, 16 MHz, MICROCONTROLLER, CQFP44 PDF資料下載
參數資料
| 型號： | MQ80C154-L16/883R |
| 廠商： | TEMIC SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, 16 MHz, MICROCONTROLLER, CQFP44 |
| 文件頁數： | 36/49頁 |
| 文件大?。?/td> | 61013K |
| 代理商： | MQ80C154-L16/883R |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁當前第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁
130
ATmega165A/PA/325A/PA/3250A/PA/645A/P/6450A/P [DATASHEET]
8285E–AVR–02/2013
Figure 18-4. Compare Match Output Unit, schematic.
The general I/O port function is overridden by the Output Compare (OC2A) from the Waveform Generator if either
of the COM2A[1:0] bits are set. However, the OC2A pin direction (input or output) is still controlled by the Data
Direction Register (DDR) for the port pin. The Data Direction Register bit for the OC2A pin (DDR_OC2A) must be
set as output before the OC2A value is visible on the pin. The port override function is independent of the Wave-
form Generation mode.
The design of the Output Compare pin logic allows initialization of the OC2A state before the output is enabled.
Note that some COM2A[1:0] bits settings are reserved for certain modes of operation. See ”Register description”
18.6.1
Compare Output Mode and Waveform Generation
The Waveform Generator uses the COM2A[1:0] bits differently in normal, CTC, and PWM modes. For all modes,
setting the COM2A[1:0] = 0 tells the Waveform Generator that no action on the OC2A Register is to be performed
on the next compare match. For compare output actions in the non-PWM modes refer to Table 18-3 on page 138.
For fast PWM mode, refer to Table 18-4 on page 139, and for phase correct PWM refer to Table 18-5 on page 139.
A change of the COM2A[1:0] bits state will have effect at the first compare match after the bits are written. For non-
PWM modes, the action can be forced to have immediate effect by using the FOC2A strobe bits.
18.7
Modes of Operation
The mode of operation, i.e., the behavior of the Timer/Counter and the Output Compare pins, is defined by the
combination of the Waveform Generation mode (WGM2[1:0]) and Compare Output mode (COM2A[1:0]) bits. The
Compare Output mode bits do not affect the counting sequence, while the Waveform Generation mode bits do.
The COM2A[1:0] bits control whether the PWM output generated should be inverted or not (inverted or non-
inverted PWM). For non-PWM modes the COM2A[1:0] bits control whether the output should be set, cleared, or
toggled at a compare match (See ”Compare Match Output Unit” on page 129.).
For detailed timing information refer to ”Timer/Counter Timing Diagrams” on page 134.
PORT
DDR
DQ
OCnx
Pin
OCnx
DQ
Waveform
Generator
COMnx1
COMnx0
0
1
D
ATA
B
U
S
FOCnx
clk
I/O
相關PDF資料 |
PDF描述 |
|---|---|
| MD83C154XXX-30/883D | 8-BIT, MROM, 30 MHz, MICROCONTROLLER, CDIP40 |
| MQ80C154-16P883 | 8-BIT, 16 MHz, MICROCONTROLLER, CQFP44 |
| MQ83C154XXX-L16/883D | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQFP44 |
| MQ83C154CXXX-25/883R | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQFP44 |
| MR80C154-L16/883R | 8-BIT, 16 MHz, MICROCONTROLLER, CQCC44 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MQ80C186-10/BYA | 制造商:Rochester Electronics LLC 功能描述: |
| MQ80C186-12/BYA | 制造商:Rochester Electronics LLC 功能描述: |
| MQ80C186-12/BYC | 制造商:Rochester Electronics LLC 功能描述: |
| MQ80C186-12/R | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MQ80C196KB-12 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。