- 您現在的位置：買賣IC網 > PDF目錄371129 > MOC3051 (MOTOROLA INC) 6-Pin DIP Random-Phase Optoisolators Triac Drivers PDF資料下載
參數資料
| 型號： | MOC3051 |
| 廠商： | MOTOROLA INC |
| 元件分類： | 光電耦合器 |
| 英文描述： | 6-Pin DIP Random-Phase Optoisolators Triac Drivers |
| 中文描述： | 1 CHANNEL TRIAC OUTPUT OPTOCOUPLER |
| 封裝： | PLASTIC, DIP-6 |
| 文件頁數： | 3/8頁 |
| 文件大?。?/td> | 329K |
| 代理商： | MOC3051 |
3
Motorola Optoelectronics Device Data
TYPICAL ELECTRICAL CHARACTERISTICS
TA = 25
°
C
Figure 3. Trigger Current versus Temperature
TA, AMBIENT TEMPERATURE (
°
C)
–40
1.6
1.4
1.2
1
0.8
0.6
–30 –20 –10
0
10
20
30
40
50
60
70
80
NORMALIZED TO
TA = 25
°
C
I
Figure 4. LED Current Required to Trigger
versus LED Pulse Width
PWin, LED TRIGGER PULSE WIDTH (
μ
s)
1
25
20
15
10
5
0
2
5
10
20
50
100
NORMALIZED TO:
PWin
≥
100
μ
s
I
Figure 5. Minimum Time for LED Turn–Off to Zero
Cross of AC Trailing Edge
AC SINE
0
°
180
°
LED PW
LED CURRENT
LED TURN OFF MIN 200
μ
s
IFT versus Temperature (normalized)
This graph shows the increase of the trigger current when
the device is expected to operate at an ambient temperature
below 25
°
C. Multiply the normalized IFT shown on this graph
with the data sheet guaranteed IFT.
Example:
TA = –40
°
C, IFT = 10 mA
IFT @ –40
°
C = 10 mA x 1.4 = 14 mA
Phase Control Considerations
LED Trigger Current versus PW (normalized)
Random Phase Triac drivers are designed to be phase
controllable. They may be triggered at any phase angle with-
in the AC sine wave. Phase control may be accomplished by
an AC line zero cross detector and a variable pulse delay
generator which is synchronized to the zero cross detector.
The same task can be accomplished by a microprocessor
which is synchronized to the AC zero crossing. The phase
controlled trigger current may be a very short pulse which
saves energy delivered to the input LED. LED trigger pulse
currents shorter than 100
μ
s must have an increased ampli-
tude as shown on Figure 4. This graph shows the dependen-
cy of the trigger current IFT versus the pulse width t (PW).
The reason for the IFT dependency on the pulse width can be
seen on the chart delay t(d) versus the LED trigger current.
IFT in the graph IFT versus (PW) is normalized in respect to
the minimum specified IFT for static condition, which is speci-
fied in the device characteristic. The normalized IFT has to be
multiplied with the devices guaranteed static trigger current.
Example:
Guaranteed IFT = 10 mA, Trigger pulse width PW = 3
μ
s
IFT (pulsed) = 10 mA x 5 = 50 mA
Minimum LED Off Time in Phase Control Applications
In Phase control applications one intends to be able to
control each AC sine half wave from 0 to 180 degrees. Turn
on at zero degrees means full power and turn on at 180 de-
gree means zero power. This is not quite possible in reality
because triac driver and triac have a fixed turn on time when
activated at zero degrees. At a phase control angle close to
180 degrees the driver’s turn on pulse at the trailing edge of
the AC sine wave must be limited to end 200
μ
s before AC
zero cross as shown in Figure 5. This assures that the triac
driver has time to switch off. Shorter times may cause loss of
control at the following half cycle.
相關PDF資料 |
PDF描述 |
|---|---|
| MOC3052 | 6-Pin DIP Random-Phase Optoisolators Triac Drivers |
| MOC3052TV-M | 6-PIN DIP RANDOM-PHASE OPTOISOLATORS TRIAC DRIVERS (600 VOLT PEAK) |
| MOC3052SR2-M | 6-PIN DIP RANDOM-PHASE OPTOISOLATORS TRIAC DRIVERS (600 VOLT PEAK) |
| MOC3052S-M | 6-PIN DIP RANDOM-PHASE OPTOISOLATORS TRIAC DRIVERS (600 VOLT PEAK) |
| MOC3052-M | 6-PIN DIP RANDOM-PHASE OPTOISOLATORS TRIAC DRIVERS (600 VOLT PEAK) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MOC3051FM | 功能描述:三極與 SCR 輸出光電耦合器 6Pin 600V Optocoupl Rand Phs Triac Drvr RoHS:否 制造商:Vishay Semiconductors 輸出設備:PhotoTriac 每芯片的通道數量: 絕緣電壓:3750 Vrms 正向電流:10 mA 正向電壓:1.2 V 最大觸發電流:10 mA 關斷狀態下輸出電壓-VDRM:600 V 最大連續輸出電流: 零交叉電路: 封裝:Reel |
| MOC3051FR2M | 功能描述:三極與 SCR 輸出光電耦合器 6Pin 600V Optocoupl Rand Phs Triac Drvr RoHS:否 制造商:Vishay Semiconductors 輸出設備:PhotoTriac 每芯片的通道數量: 絕緣電壓:3750 Vrms 正向電流:10 mA 正向電壓:1.2 V 最大觸發電流:10 mA 關斷狀態下輸出電壓-VDRM:600 V 最大連續輸出電流: 零交叉電路: 封裝:Reel |
| MOC3051FR2VM | 功能描述:三極與 SCR 輸出光電耦合器 6Pin 600V Optocoupl Rand Phs Triac Drvr RoHS:否 制造商:Vishay Semiconductors 輸出設備:PhotoTriac 每芯片的通道數量: 絕緣電壓:3750 Vrms 正向電流:10 mA 正向電壓:1.2 V 最大觸發電流:10 mA 關斷狀態下輸出電壓-VDRM:600 V 最大連續輸出電流: 零交叉電路: 封裝:Reel |
| MOC3051FVM | 功能描述:三極與 SCR 輸出光電耦合器 6Pin 600V Optocoupl Rand Phs Triac Drvr RoHS:否 制造商:Vishay Semiconductors 輸出設備:PhotoTriac 每芯片的通道數量: 絕緣電壓:3750 Vrms 正向電流:10 mA 正向電壓:1.2 V 最大觸發電流:10 mA 關斷狀態下輸出電壓-VDRM:600 V 最大連續輸出電流: 零交叉電路: 封裝:Reel |
| MOC3051M | 功能描述:三極與 SCR 輸出光電耦合器 DIP-6 OPTO TRIAC RoHS:否 制造商:Vishay Semiconductors 輸出設備:PhotoTriac 每芯片的通道數量: 絕緣電壓:3750 Vrms 正向電流:10 mA 正向電壓:1.2 V 最大觸發電流:10 mA 關斷狀態下輸出電壓-VDRM:600 V 最大連續輸出電流: 零交叉電路: 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。