- 您現在的位置：買賣IC網 > PDF目錄371128 > MOC2R60-15 (MOTOROLA INC) OPTOISOLATOR 2 AMPS RANDOM-PHASE TRIAC OUTPUT 600 VOLTS PDF資料下載
參數資料
| 型號： | MOC2R60-15 |
| 廠商： | MOTOROLA INC |
| 元件分類： | 繼電器，輸入/輸出模塊 |
| 英文描述： | OPTOISOLATOR 2 AMPS RANDOM-PHASE TRIAC OUTPUT 600 VOLTS |
| 中文描述： | TRIGGER OUTPUT SOLID STATE RELAY, 3750 V ISOLATION-MAX |
| 文件頁數： | 5/8頁 |
| 文件大?。?/td> | 228K |
| 代理商： | MOC2R60-15 |
5
Motorola Optoelectronics Device Data
Figure 13. Delay Time, t(d), and Fall Time, t(f),
versus LED Trigger Current
IFT, LED TRIGGER CURRENT (mA)
100
0.1
10
20
30
40
50
60
10
t
s
μ
1
t(d)
t(f)
t(delay), t(f) versus IFT
The POWER OPTO Isolators turn on switching speed con-
sists of a turn on delay time t(d) and a fall time t(f). Figure 13
shows that the delay time depends on the LED trigger cur-
rent, while the actual trigger transition time t(f) stays constant
with about one micro second.
The delay time is important in very short pulsed operation
because it demands a higher trigger current at very short trig-
ger pulses. This dependency is shown in the graph IFT ver-
sus LED PW.
The turn on transition time t(f) combined with the power
triacs turn on time is important to the power dissipation of this
device.
SCOPE
IFT
VTM
t(d)
t(f)
ZERO CROSS
DETECTOR
EXT. SYNC
Vout
FUNCTION
GENERATOR
PHASE CTRL.
PW CTRL.
PERIOD CTRL.
Vo AMPL. CTRL.
IFT
VTM
10 k
DU
T
100
ISOL. TRANSF.
A
C
115
VAC
Figure 14. Switching Time Test Circuit
Figure 15. Typical Application Circuit
VCC
Load
MOV
R2
C1
R1
MOC2R60
Select the value of R1 according to the following formulas:
(1)
R1 = (VCC – VF) / Max. IFT (on) per spec.
(2)
R1 = (VCC – VF) / 0.050
Typical values for C1 and R2 are 0.01
μ
F and 39
,
respectively. You may adjust these values for specific
applications. The maximum recommended value of C1 is
0.022
μ
F. See application note AN1048 for additional
information on component values.
The MOV may or may not be needed depending upon the
characteristics of the applied AC line voltage. For
applications where line spikes may exceed the 600 volts
rating of the MOC2R60, an MOV is required.
相關PDF資料 |
PDF描述 |
|---|---|
| MOC2R6010 | OPTOISOLATOR 2 AMPS RANDOM-PHASE TRIAC OUTPUT 600 VOLTS |
| MOC3010 | 6-Pin DIP Random-Phase Optoisolators Triac Driver Output |
| MOC3010VM | 6-PIN DIP RANDOM-PHASE OPTOISOLATORS TRIAC DRIVER OUTPUT (250/400 VOLT PEAK) |
| MOC3010SM | 6-PIN DIP RANDOM-PHASE OPTOISOLATORS TRIAC DRIVER OUTPUT (250/400 VOLT PEAK) |
| MOC3010SR2M | 6-PIN DIP RANDOM-PHASE OPTOISOLATORS TRIAC DRIVER OUTPUT (250/400 VOLT PEAK) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MOC3009 | 制造商:Motorola Inc 功能描述:Triac-output Optocoupler, 1-channel, 7.5kv Isolation, Dip |
| MOC3009X | 制造商:ISOCOM 制造商全稱:ISOCOM 功能描述:OPTICALLY COUPLED BILATERAL SWITCH NON-ZERO CROSSING TRIAC |
| MOC3010 | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Isocom Components 功能描述:DIP6 Through Hole Single Channel 5300 Vrms Triac Non Zero Crossing Optocoupler 制造商:Distributed By MCM 功能描述:SUB ONLY TRANSISOR 6-PIN DIP OPTOISOLATOR 制造商:Freescale Semiconductor 功能描述:SUB ONLY MOTOROLA SEMICONDUCTO 制造商:Isocom Components 功能描述:Triac o/p opto-isolator,MOC3010 60mA |
| MOC3010/ROHS | 制造商:ISOCOM 功能描述: 制造商:Isocom Components 功能描述: |
| MOC3010FM | 功能描述:三極與 SCR 輸出光電耦合器 6Pin 250V Optocoupl Rand Phs Triac Drvr RoHS:否 制造商:Vishay Semiconductors 輸出設備:PhotoTriac 每芯片的通道數量: 絕緣電壓:3750 Vrms 正向電流:10 mA 正向電壓:1.2 V 最大觸發(fā)電流:10 mA 關斷狀態(tài)下輸出電壓-VDRM:600 V 最大連續(xù)輸出電流: 零交叉電路: 封裝:Reel |
發(fā)布緊急采購，3分鐘左右您將得到回復。