
MLX902xx Name of Sensor Rev Y.X 22/Aug/98 Page 9
MLX90804 Speed regulator for universal motors Page 9 Rev 1.0 30/Jun/00
MLX90804
Speed regulator for universal motors
the maximum angle with the triac on (fired). This
happens when the triac is fired with minimum delay
from the zero cross. MIN corresponds to the
minimum time the triac is fired. This happens when
the triac is fired with maximum delay from the zero
cross.
If the IGN < MAX ,then IGN = MAX, thus firing with
max angle. If MAX < IGN, then firing is done with
IGN angle. The IGN value is compared with the
value of a down counter, which is clocked by DCLK
= 100kHz and is cleared at the beginning of every
half period of the AC line. When this counter value
gets equal to IGN a firing circuit produces an ignition
pulse GATE with a duration selected with option
DUTS[1:0].
After each firing pulse the ignition detector is
activated. This will check whether the triac is fired
correctly and thus no additional firing pulses are
required. If there is no current flowing in the triac
additional pulses will be generated.
Options
The following table lists all mask options of the
90804 chip:
Pinout
Standard package is 8-pin dual inline package.
(Known as DIP-8, PDIP-8, DIL-8 and PDIL-8)
MIN
MAX
IGN
MAINS*2
GATE
MAINS
DUTS1
DUTS0
Duration in us
0
0
320
0
1
80
1
0
40
1
1
20
Name
Description
MULT[7:0]
multiplication coefficient of
Fspd
FPB
Gate of frequency meter
SFT[1:0]
startup time
PX[3:1]
Proportional coefficient Kp
SSE[1:0]
Integral coefficient Ki
SPE[1:0]
Start speed
LD[9:0]
Preload of Integrator
DWR[4:0]
SETP integrator down
UPR[4:0]
SETP integrator up
DUTS[1:0]
duration of firing pulse
MULT9
Enable retriggering
MIN[9:0]
mn allowed firing angle
MAX[9:0]
max allowed firing angle
SLIM[9:0]
mnimumspeed limtation
SLIMA[4:0]
maximumspeed limtation
Pin
Name
Type
Description
1
SET
Input
Speed setting input
2
SPD
Input
Speed measurement
3
TEST
Input
Test pin
4
SYN
Input
Zero cross input
5
TRG
Output Triac driver output
6
VSS
Supply Ground
7
VDD1
Supply Supply, high level
8
VDD
Output Reference voltage