- 您現在的位置：買賣IC網 > PDF目錄2013 > MK5818SLF (IDT, Integrated Device Technology Inc)IC CLK GEN SPREAD SPECTRUM 8SOIC PDF資料下載
參數資料
| 型號： | MK5818SLF |
| 廠商： | IDT, Integrated Device Technology Inc |
| 文件頁數： | 3/8頁 |
| 文件大小： | 0K |
| 描述： | IC CLK GEN SPREAD SPECTRUM 8SOIC |
| 標準包裝： | 97 |
| 類型： | 時鐘發生器 |
| PLL： | 是 |
| 輸入： | 時鐘，晶體 |
| 輸出： | LVCMOS |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 2:2 |
| 差分 - 輸入:輸出： | 無/無 |
| 頻率 - 最大： | 16MHz |
| 除法器/乘法器： | 是/無 |
| 電源電壓： | 2.97 V ~ 3.63 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 管件 |
MK5818
SPREAD SPECTRUM CLOCK GENERATOR
SSCG
IDT SPREAD SPECTRUM CLOCK GENERATOR
3
MK5818
REV C 051310
External Components
The MK5818 requires a minimum number of external
components for proper operation.
Decoupling Capacitor
A decoupling capacitor of 0.01F must be connected
between VDD and GND, as close to these pins as possible.
For optimum device performance, the decoupling capacitor
should be mounted on the component side of the PCB.
Avoid the use of vias in the decoupling circuit.
PCB Layout Recommendations
For optimum device performance and lowest output phase
noise, the following guidelines should be observed.
1) The 0.01F decoupling capacitor should be mounted on
the component side of the board as close to the VDD pin as
possible. No vias should be used between the decoupling
capacitor and VDD pin. The PCB trace to VDD pin should
be kept as short as possible, as should the PCB trace to the
ground via.
2) An optimum layout is one with all components on the
same side of the board, minimizing vias through other signal
layers. Other signal traces should be routed away from the
MK5818. This includes signal traces just underneath the
device, or on layers adjacent to the ground plane layer used
by the device.
Crystal Information
The crystal used should be a fundamental mode (do not use
third overtone), parallel resonant. Crystal capacitors should
be connected from pins X1 to ground and X2 to ground to
optimize the initial accuracy. The value of these capacitors
is given by the following equation:
Crystal caps (pF) = (CL - 6) x 2
In the equation, CL is the crystal load capacitance. So, for a
crystal with a 16pF load capacitance, two 20 pF [(16-6) x 2]
capacitors should be used.
Spread Spectrum Profile
The MK5818 low EMI clock generator uses an optimized
frequency slew rate algorithm to facilitate down stream
tracking of zero delay buffers and other PLL devices. The
frequency modulation amplitude is constant with variations
of the input frequency.
Modulation Rate
The time required to transition from fMIN (minimum
frequency of the clock) to fMAX (maximum frequency of the
clock) and back to fMIN is the period of the modulation rate,
TMOD. The modulation rates of spread spectrum clock
generators are generally referred to in terms of frequency,
and fMOD = 1/TMOD.
The input clock frequency (fIN) and the internal divider
determine the modulation rate.
The spread spectrum modulation rate (fMOD) is given by the
formula fMOD = fIN/DR, where:
fMOD is the modulation rate, fIN is the input frequency, and
DR is the divider ratio (see table below).
Input Frequency Range
Divider Ratio (DR)
8 to 16 MHz
256
Ti m e
F
requen
c
y
Modulation Rate
相關PDF資料 |
PDF描述 |
|---|---|
| MPC9239EI | IC CLK SYNTH LV PECL 28-PLCC |
| MPC92433AER2 | IC SYNTHESIZER LVPECL 48-LQFP |
| MPC92439EI | IC SYNTHESIZER LVPECL 28-PLCC |
| MPC9330AC | IC PLL CLOCK GENERATOR 32-LQFP |
| MPC9331AC | IC PLL CLOCK GEN 1:6 32-LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MK5818SLFTR | 功能描述:時鐘發生器及支持產品 RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
| MK5818STR | 功能描述:IC CLK GEN SPREAD SPECTRUM 8SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:39 系列:- 類型:* PLL:帶旁路 輸入:時鐘 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:10 差分 - 輸入:輸出:是/是 頻率 - 最大:170MHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| MK5901F | 制造商:Ohmite Mfg Co 功能描述: |
| MK6 | 制造商:HellermannTyton 功能描述: |
| MK-6000 | 功能描述:KIT SURFBOARD DISCRETE 46PCS RoHS:是 類別:套件 >> 原型開發板 - 未穿孔 系列:6000 標準包裝:1 系列:1000, 2000, 3000, 4000, 5000 套件類型:SIP 試驗電路板 值:52 件 - 26 種型號各 2 件 包裝:每個值的包數 工具箱內容:(2) 3010CA-ND - PROTO-BOARD 10PIN THRU-HOLE SIP(2) 1010CA-ND - PROTO-BOARD 10PIN THRU-HOLE SIP(2) 2007CA-ND - PROTO-BOARD 7PIN THRU-HOLE SIP(2) 2008CA-ND - PROTO-BOARD 8PIN THRU-HOLE SIP(2) 1009CA-ND - PROTO-BOARD 9PIN THRU-HOLE SIP(2) 3012CA-ND - PROTO-BOARD 12PIN THRU-HOLE SIP(2) 4007CA-ND - PROTO-BOARD 7PIN THRU-HOLE SIP(2) 1007CA-ND - PROTO-BOARD 7PIN THRU-HOLE SIP(2) 5020CA-ND - PROTO-BOARD 20PIN THRU-HOLE SIP(2) 1006CA-ND - PROTO-BOARD 6PIN THRU-HOLE SIP更多... 其它名稱:MK-260CAMK260CA |
發布緊急采購，3分鐘左右您將得到回復。