- 您現在的位置：買賣IC網 > PDF目錄383617 > MICRF213 (Micrel Semiconductor,Inc.) 1.8 V single UART, 20 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA), and XScale VLIO bus interface, SOT617-1 (HVQFN32), Tray Pack, Bakeable, Multiple PDF資料下載
參數資料
| 型號： | MICRF213 |
| 廠商： | Micrel Semiconductor,Inc. |
| 英文描述： | 1.8 V single UART, 20 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA), and XScale VLIO bus interface, SOT617-1 (HVQFN32), Tray Pack, Bakeable, Multiple |
| 中文描述： | 3.3，QwikRadio系列㈢315MHz的接收器 |
| 文件頁數： | 7/16頁 |
| 文件大?。?/td> | 850K |
| 代理商： | MICRF213 |
Micrel, Inc.
MICRF213
Detector and Programmable Low-Pass Filter
The demodulation starts with the detector removing the
carrier from the IF signal. Post detection, the signal
becomes base band information. The programmable
low-pass filter further enhances the base band
information. There are four programmable low-pass filter
BW settings: 1180Hz, 2360Hz, 4270Hz, 9400Hz for
315MHz operation. Low pass filter BW will vary with RF
Operating Frequency. Filter BW values can be easily
calculated by direct scaling. See the equation below for
the filter BW calculation:
May 2007
7
M9999-052307-A
(408) 944-0800
BW
Operating Freq
= BW
@315MHz
×
315
(MHz)
Freq
Operating
It is very important to choose filter setting that best fits
the intended data rate as this will minimize data
distortion.
Demod BW is set at 9700Hz @ 315MHz as default
(assuming both SEL0 and SEL1 pins are floating). The
low pass filter can be hardware set by external pins
SEL0 and SEL1.
SEL0
0
1
0
1
SEL1
0
0
1
1
Demod BW (@ 315MHz)
1180Hz
2360Hz
4270Hz
9400Hz - default
Table 1. Demodulation BW Selection
Slicer, Slicing Level and Squelch
The signal, prior to slicer, is still linear demodulated AM.
Data slicer converts this signal into digital “1”s and “0”s
by comparing with the threshold voltage built up on the
CTH capacitor. This threshold is determined by
detecting the positive and negative peaks of the data
signal and storing the mean value. Slicing threshold
default is 50%. After the slicer, the signal becomes
digital OOK data.
During long periods of “0”s or no data period at all,
threshold voltage on the CTH capacitor may be very
low. Large random noise spikes during this time may
cause erroneous “1”s at DO pin. Squelch pin when pull
down low will suppress these errors.
AGC Comparator
The AGC comparator monitors the signal amplitude
from the output of the programmable low-pass filter.
When the output signal is less than 750mV threshold,
1.5μA current is then sourced into the external CAGC
capacitor. When the output signal is greater than
750mV, a 15μA current sink discharges the CAGC
capacitor. The voltage, developed on the CAGC
capacitor, acts to adjust the gain of the mixer and the IF
amplifier to compensate for RF input signal level
variation.
Reference Control
There are two components in Reference and Control
sub-block: 1) Reference Oscillator and, 2) Control Logic
through parallel Inputs: SEL0, SEL1, SHDN.
Reference Oscillator
V
BIAS
C
C1
C
C2
R
2
R
1
M1
gm
M2
M3
I
BIAS
RO1
M4
RO2
Normally on
C
0
1
C
1
Startup
Circuit
Figure 2. Reference Oscillator Circuit
The reference oscillator in the MICRF213 (reference
Figure 2) uses a basic Colpitts crystal oscillator
configuration with a MOS transconductor to provide
negative resistance. All capacitors shown in the figure
are integrated inside MICRF213. R01 and R02 are
external pins of MICRF213. The user only need connect
the reference oscillation crystal.
Reference oscillator crystal frequency can be calculated
thus as:
F
REFOSC
= F
RF
/(32 + 1.1/12)
For 315MHz, F
REFOSC
= 9.81563 MHz.
To operate the MICRF213 with minimum offset, crystal
frequencies should be specified with 10pF loading
capacitance.
相關PDF資料 |
PDF描述 |
|---|---|
| MICRF213AYQS | 1.8 V dual UART, 20 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA), and XScale VLIO bus interface, SOT912-1 (TFBGA36), Tray Pack, Bakeable, Multiple |
| MIIC5271 | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| MIIC5271-5.0BM5 | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| MIIC5271BM5 | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| MIIC5271-3.0BM5 | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MICRF213_11 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V, QwikRadio 315MHz Receiver |
| MICRF213AYQS | 功能描述:射頻接收器 300MHz to 350MHz, 3.0V to 3.6V, 7.2kbps, 4mA, ASK Receiver with RSSI, Shutdown in 16-Lead QSOP (Lead-Free) RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| MICRF213AYQS TR | 功能描述:射頻接收器 300MHz to 350MHz, 3.0V to 3.6V, 7.2kbps, 4mA, ASK Receiver with RSSI, Shutdown in 16-Lead QSOP (Lead-Free) RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| MICRF218 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V, 315/433MHz Wide-IF Bandwidth ASK Receiver |
| MICRF218_11 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V, 315/433MHz Wide-IF Bandwidth ASK Receiver |
發布緊急采購，3分鐘左右您將得到回復。