參數資料
型號: MICRF211AYQS
廠商: MICREL INC
元件分類: 消費家電
英文描述: 3V, QwikRadio㈢ 433.92 MHz Receiver
中文描述: SPECIALTY CONSUMER CIRCUIT, PDSO16
封裝: QSOP-16
文件頁數: 6/18頁
文件大?。?/td> 815K
代理商: MICRF211AYQS
Micrel
MICRF211
Functional Diagram
March 2007
6
M9999-030107
(408) 944-0800
Figure 1. Simplified Block Diagram.
Functional Description
Figure 1. Simplified Block Diagram that illustrates the
basic structure of the MICRF211. It is made of three
sub-blocks; Image Rejection UHF Down-converter, the
OOK Demodulator, and Reference and Control Logics.
Outside the device, the MICRF211 requires only three
components to operate: two capacitors (CTH, and
CAGC) and the reference frequency device, usually a
quartz crystal. An additional five components may be
used to improve performance. These are: power supply
decoupling capacitor, two components for the matching
network, and two components for the pre-selector band
pass filter.
Receiver Operation
LNA
The RF input signal is AC-coupled into the gate circuit of
the grounded source LNA input stage. The LNA is a
Cascoded NMOS.
Mixers and Synthesizer
The LO ports of the Mixers are driven by quadrature
local oscillator outputs from the synthesizer block. The
local oscillator signal from the synthesizer is placed on
the low side of the desired RF signal to allow
suppression of the image frequency at twice the IF
frequency below the wanted signal. The local oscillator
is set to 32 times the crystal reference frequency via a
phase-locked loop synthesizer with a fully integrated
loop filter.
Image Reject Filter and Band-Pass Filter
The IF ports of the mixer produce quadrature down
converted IF signals. These IF signals are low-pass
filtered to remove higher frequency products prior to the
image reject filter where they are combined to reject the
image frequencies. The IF signal then passes through a
third order band pass filter. The IF center frequency is
1.2MHz. The IF BW is 330kHz @ 433.92MHz, and this
varies with RF operating frequency. The IF BW can be
calculated via direct scaling:
Operating
BW
IF
= BW
IF@433.92 MHz
×
433.92
(MHz)
Freq
These filters are fully integrated inside the MICRF211.
After filtering, four active gain controlled amplifier stages
enhance the IF signal to proper level for demodulation.
OOK Demodulator
The demodulator section is comprised of detector,
programmable low pass filter, slicer, and AGC
comparator.
Detector and Programmable Low-Pass Filter
The demodulation starts with the detector removing the
相關PDF資料
PDF描述
MICRF213 1.8 V single UART, 20 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA), and XScale VLIO bus interface, SOT617-1 (HVQFN32), Tray Pack, Bakeable, Multiple
MICRF213AYQS 1.8 V dual UART, 20 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA), and XScale VLIO bus interface, SOT912-1 (TFBGA36), Tray Pack, Bakeable, Multiple
MIIC5271 Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection
MIIC5271-5.0BM5 Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection
MIIC5271BM5 Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection
相關代理商/技術參數
參數描述
MICRF211AYQS TR 功能描述:射頻接收器 380MHz to 450MHz, 3.0V to 3.6V, 6mA, 10kbps, ASK Receiver with RSSI and Shutdown in 16-Lead QSOP (Lead-Free) RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel
MICRF213 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V, QwikRadio㈢ 315MHz Receiver
MICRF213_11 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V, QwikRadio 315MHz Receiver
MICRF213AYQS 功能描述:射頻接收器 300MHz to 350MHz, 3.0V to 3.6V, 7.2kbps, 4mA, ASK Receiver with RSSI, Shutdown in 16-Lead QSOP (Lead-Free) RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel
MICRF213AYQS TR 功能描述:射頻接收器 300MHz to 350MHz, 3.0V to 3.6V, 7.2kbps, 4mA, ASK Receiver with RSSI, Shutdown in 16-Lead QSOP (Lead-Free) RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel