參數資料
型號: MICRF102
廠商: MICREL INC
元件分類: 消費家電
英文描述: QwikRadio UHF ASK Transmitter
中文描述: SPECIALTY CONSUMER CIRCUIT, PDSO8
封裝: SOIC-8
文件頁數: 4/12頁
文件大?。?/td> 61K
代理商: MICRF102
MICRF102
Micrel
MICRF102
4
September 2002
Parameter
Condition
Min
Typ
Max
Unit
Digital / Control Section
Calibration Time
Note 8, ASK=HIGH
25
ms
Power Amplifier Output Hold Off
Time from STBY
Note 9, STDBY transition from LOW to HIGH
Crystal, ESR < 20
6
ms
Transmitter Stabilization Time
from STBY
From External Reference (500mVpp)
10
ms
Crystal, ESR < 20
19
ms
Maximum Data Rate
ASK modulation
Duty cycle of the modulating signal = 50%
20
kbits/s
V
STBY
STBY Sink Current
Enable voltage
0.75V
DD
0.6V
DD
V
I
STBY
= V
DD
V
IH
, input high voltage
V
IL
, input low voltage
ASK = 0V, 5.0V input current
5
6.5
μ
A
ASK pin
0.75V
DD
0.6V
DD
V
0.3V
DD
0.25V
DD
0.1
V
ASK input current
10
10
μ
A
Note 1.
Note 2.
Note 3.
Note 4.
Exceeding the absolute maximum rating may damage the device.
The device is not guaranteed to function outside its operating rating.
Devices are ESD sensitive. Handling precautions recommended. Human body model, 1.5k in series with 100pF.
Supply current and output power are a function of the voltage input on the PC (power control) pin. All specifications in the Electrical Charac-
teristics table applies for condition V
= 350mV. Increasing the voltage on the PC pin will increase transmit power and also increase MARK
supply current. Refer to the graphs "Output Power Versus PC Pin Voltage" and "Mark Current Versus PC Pin Voltage."
Output power specified into a 50
equivalent load using the test circuit in Figure 5.
Transmitted power measured 3 meters from the antenna using transmitter board TX102-2A in Figure 6.
The Varactor capacitance tuning range indicates the allowable external antenna component variation to maintain tune over normal production
tolerances of external components. Guaranteed by design not tested in production.
When the device is first powered up or it loses power momentarily, it goes into the calibration mode to tune up the transmit antenna.
After the release of the STDBY, the device requires an initialization time to settle the REFOSC and the internal PLL. The first MARK state
(ASK HIGH) after exit from STDBY needs to be longer than the initialization time. The subsequent low to high transitions will be treated as
data modulation whereby the envelope transition time will apply.
Note 10.
The MICRF102 was tested to be Compliant to Part 15.231 for maximum allowable TX power, when operated in accordance with a loop
antenna described in Figure 6.
Note 5.
Note 6.
Note 7.
Note 8.
Note 9.
相關PDF資料
PDF描述
MICRF102BM QwikRadio UHF ASK Transmitter
MICRF103 QwikRadio UHF ASK Transmitter
MICRF103BM QwikRadio UHF ASK Transmitter
MICRF104 1.8V, QwikRadio⑩ UHF ASK Transmitter
MICRF104BM 1.8V, QwikRadio⑩ UHF ASK Transmitter
相關代理商/技術參數
參數描述
MICRF102_06 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:QwikRadio? UHF ASK Transmitter
MICRF102BM 功能描述:IC ASK TRANSMITTER UHF 8SOIC RoHS:否 類別:RF/IF 和 RFID >> RF 發射器 系列:- 標準包裝:4,000 系列:- 頻率:310MHz ~ 440MHz 應用:- 調制或協議:UHF,ASK 數據傳輸率 - 最大:20 kBaud 功率 - 輸出:1dBm ~ 5dBm 電流 - 傳輸:10mA 數據接口:PCB,表面貼裝 天線連接器:PCB,表面貼裝 存儲容量:- 特點:- 電源電壓:2.2 V ~ 4 V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-LSSOP(0.154",3.90mm 寬) 包裝:帶卷 (TR)
MICRF102BM TR 功能描述:IC TRANSMITTER ASK UHF 8-SOIC RoHS:否 類別:RF/IF 和 RFID >> RF 發射器 系列:- 標準包裝:4,000 系列:- 頻率:310MHz ~ 440MHz 應用:- 調制或協議:UHF,ASK 數據傳輸率 - 最大:20 kBaud 功率 - 輸出:1dBm ~ 5dBm 電流 - 傳輸:10mA 數據接口:PCB,表面貼裝 天線連接器:PCB,表面貼裝 存儲容量:- 特點:- 電源電壓:2.2 V ~ 4 V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-LSSOP(0.154",3.90mm 寬) 包裝:帶卷 (TR)
MICRF102YM 功能描述:射頻發射器 300-460MHz, 5V Transmitter( Lead Free) RoHS:否 制造商:Micrel 類型:ASK Transmitter 封裝 / 箱體:SOT-23-6 工作頻率:300 MHz to 450 MHz 封裝:Reel
MICRF102YM TR 功能描述:射頻發射器 300-460MHz, 5V Transmitter( Lead Free) RoHS:否 制造商:Micrel 類型:ASK Transmitter 封裝 / 箱體:SOT-23-6 工作頻率:300 MHz to 450 MHz 封裝:Reel