- 您現在的位置：買賣IC網 > PDF目錄359155 > MCZ33285EF (飛思卡爾半導體(中國)有限公司) Dual High-Side TMOS Driver PDF資料下載
參數資料
| 型號： | MCZ33285EF |
| 廠商： | 飛思卡爾半導體(中國)有限公司 |
| 英文描述： | Dual High-Side TMOS Driver |
| 中文描述： | 雙高邊的TMOS驅動器 |
| 文件頁數： | 8/13頁 |
| 文件大小： | 173K |
| 代理商： | MCZ33285EF |
Analog Integrated Circuit Device Data
Freescale Semiconductor
8
33285
FUNCTIONAL DEVICE OPERATION
OPERATIONAL MODES
FUNCTIONAL DEVICE OPERATION
OPERATIONAL MODES
INTRODUCTION
The 33285 contains only one charge pump for two
outputs.The outputs, OUT1 and OUT2, are switched ON and
OFF by the input (IN) .There are three ways to control the
outputs:
OUT1 can be switched alone
OUT1 and OUT2 can be switched together
OUT2 can be switched when OUT1 is already on
In the last case, the voltage drop on OUT1 when charging
OUT2 is limited.
The external capacitor (C
CP
) connected to the CHARGE
PUMP (CP) pin is used to store the charge continuously
delivered by the charge pump. The voltage on this pin is
limited to a maximum value V
CPMAX
. Both outputs are
sourced with a constant current from C
CP
to switch them ON.
Additionally, the gates of the power FETs are precharged
from voltage power supply (V
CC
)
to prevent C
CP
from being
discharged by a voltage on OUT1 or OUT2, is still lower than
V
VCC
. The values of the output voltages are limited to
V
OUT1MAX
and V
OUT2MAX
.
The power FET on OUT1 is protected against an
exceeded gate-source voltage by an internal zener diode.
Channel One protects the N-Channel power FET on OUT1
undercurrent and short-circuit conditions. The drain-source
voltage of the FET on OUT1 is checked if Channel One is
switched ON. The internal error voltage threshold determines
the maximum drain-source voltage allowing the power FET to
stay in the ON state. If the measured drain-source voltage
exceeds the internal error voltage threshold, the output of the
short-circuit protection comparator (SCPC) is enabled. If the
output of the SCPC is active longer than t
OCDET
, output
OUT1 is switched OFF.
After switching OFF the power FET on OUT1 by an short-
circuit condition, the power FET can only be turned ON again
by the input IN.
When switching OFF the power FETs their gate capacities
are discharged by a constant current, I
OUTOFF
.
If the input IN is disconnected, the 33285 outputs, OUT1
and OUT2, are in the OFF state.
If overvoltage occurs on the
DRAIN (DRN) pin for a time
period longer than t
LDDET
, OUT2 is switched ON for the time
t
OUT2ACT
. In an overvoltage condition OUT1 is OFF if IN is
below V
IH
.
INTERNAL ZENER DIODE
An on-chip zener diode is placed between OUT1 and The
SOURCE (SRC). Design guarantees V
Z
> V
TH1
. Zener
clamping voltage between OUT1 and SRC is V
TH1
< V
Z
<
20 V
PWM CAPABILITY
The C
PIC2
is PWM capable on OUT2. The loss of charge
ON C
CP
when switching ON OUT2 is refreshed until the Start
on the next PWM cycle to a value sufficient to guarantee the
specified turn ON behavior.
The PWM capability is measured with a test circuit and
load conditions:
PWM cycle is period T = 20 ms ; OUT2 is switched ON
from 10 to 90 percent of T
Test condition V
IN
ramps 2.5 V
≤
5.0 V according to PWM
cycle defined above
CROSS TALK BETWEEN OUT1 AND OUT2
If output OUT2 is switched ON while OUT1 is already ON,
the voltage drop occurring on OUT1 is limited.
Voltage drop on OUT1:
10 V < V
VCC
< 20 V : OUT1 not below V
VCC
+ 7.0 V
7.0 V < V
VCC
< 20 V : OUT1 not below V
VCC
+ 7.0 V
Each time OUT1 is switched ON, a current I
LCDET
is
sourced out of the SRC pin for the time t
LCDET
to check if
there is an external leakage current on that node in the
application. The high-side switch on OUT1 is turned ON only
if the test is successful.
相關PDF資料 |
PDF描述 |
|---|---|
| MCZ33287EG | Contact Monitoring and Dual Low-Side Protected Driver |
| MCZ33291EG | Eight-Output Switch with Serial Peripheral Interface I/O |
| MCZ33291LEG | Eight-Output Switch with Serial Peripheral Interface I/O |
| MCZ33390EF | Class B Serial Transceiver |
| MCZ33395EW | Three-Phase Gate Driver IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCZ33285EFR2 | 功能描述:功率驅動器IC DUAL HIGH SIDE TMOS DRIV RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| MCZ33287EG | 功能描述:功率驅動器IC CONTACT MONITOR DUAL LO RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| MCZ33287EGR2 | 功能描述:功率驅動器IC CONTACT MONITOR DUAL LO RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| MCZ33287R2 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Contact Monitoring and Dual Low-Side Protected Driver |
| MCZ33290EF | 功能描述:外圍驅動器與原件 - PCI ISO LINK RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。