參數資料
型號: MCF5213CAF66
廠商: 飛思卡爾半導體(中國)有限公司
英文描述: ColdFire Microcontroller
中文描述: ColdFire微控制器
文件頁數: 33/56頁
文件大?。?/td> 608K
代理商: MCF5213CAF66
Electrical Characteristics
MCF5213 ColdFire Microcontroller, Rev. 3
Freescale Semiconductor
33
2.8
General Purpose I/O Timing
GPIO can be configured for certain pins of the QSPI, DDR Control, timer, UART, and Interrupt interfaces. When in GPIO mode,
the timing specification for these pins is given in
Table 28
and
Figure 5
.
The GPIO timing is met under the following load test conditions:
50 pF / 50
Ω
for high drive
25 pF / 25
Ω
for low drive
Frequency un-LOCK range
f
UL
–1.5
1.5
% f
ref
Frequency LOCK range
f
LCK
–0.75
0.75
% f
ref
CLKOUT period jitter
4, 5, 8 ,9
, measured at f
SYS
Max
Peak-to-peak (clock edge to clock edge)
Long term (averaged over 2 ms interval)
C
jitter
10
.01
% f
sys
On-chip oscillator frequency
f
oco
7.84
8.16
MHz
1
All internal registers retain data at 0 Hz.
2
Depending on packaging; see
Table 2
.
3
Loss of Reference Frequency is the reference frequency detected internally, which transitions the PLL into self clocked mode.
4
Self clocked mode frequency is the frequency at which the PLL operates when the reference frequency falls below f
LOR
with
default MFD/RFD settings.
5
This parameter is characterized before qualification rather than 100% tested.
6
Proper PC board layout procedures must be followed to achieve specifications.
7
This specification applies to the period required for the PLL to relock after changing the MFD frequency control bits in the
synthesizer control register (SYNCR).
8
Jitter is the average deviation from the programmed frequency measured over the specified interval at maximum f
sys
.
Measurements are made with the device powered by filtered supplies and clocked by a stable external clock signal. Noise
injected into the PLL circuitry via V
DDPLL
and V
SSPLL
and variation in crystal oscillator frequency increase the C
jitter
percentage
for a given interval.
9
Based on slow system clock of 40 MHz measured at f
sys
max.
Table 28. GPIO Timing
NUM
Characteristic
Symbol
Min
Max
Unit
G1
CLKOUT High to GPIO Output Valid
t
CHPOV
10
ns
G2
CLKOUT High to GPIO Output Invalid
t
CHPOI
1.5
ns
G3
GPIO Input Valid to CLKOUT High
t
PVCH
9
ns
G4
CLKOUT High to GPIO Input Invalid
t
CHPI
1.5
ns
Table 27. PLL Electrical Specifications (continued)
(V
DD
and V
DDPLL
= 2.7 to 3.6 V, V
SS
= V
SSPLL
= 0 V)
Characteristic
Symbol
Min
Max
Unit
相關PDF資料
PDF描述
MCF5213CAF80 ColdFire Microcontroller
MCF5213LCVM66 ColdFire Microcontroller
MCF5213LCVM80 ColdFire Microcontroller
MCF52223_07 ColdFire Microcontroller
MMA7450LR1 【2g/【4g/【8g Three Axis Low-g Digital Output Accelerometer
相關代理商/技術參數
參數描述
MCF5213CAF80 功能描述:32位微控制器 - MCU MCF5213 KIRIN RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
MCF5213LCVM66 功能描述:32位微控制器 - MCU MCF5213 KIRIN RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
MCF5213LCVM66J 功能描述:32位微控制器 - MCU ColdFire Micro- Controller RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
MCF5213LCVM80 功能描述:32位微控制器 - MCU MCF5213 KIRIN RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
MCF5213LCVM80J 功能描述:32位微控制器 - MCU ColdFire Micro- Controller RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT