
Appendix A Electrical Characteristics
MC9S12E128 Data Sheet, Rev. 1.07
Freescale Semiconductor
581
A.4
Flash NVM
A.4.1
NVM Timing
The time base for all NVM program or erase operations is derived from the oscillator. A minimum
oscillator frequency fNVMOSC is required for performing program or erase operations. The NVM modules
do not have any means to monitor the frequency and will not prevent program or erase operation at
frequencies above or below the specied minimum. Attempting to program or erase the NVM modules at
a lower frequency a full program or erase transition is not assured.
The Flash program and erase operations are timed using a clock derived from the oscillator using the
FCLKDIV register. The frequency of this clock must be set within the limits specied as fNVMOP.
The minimum program and erase times shown in Table A-14 are calculated for maximum fNVMOP and maximum fbus. The maximum times are calculated for minimum fNVMOP and a fbus of 2MHz.
A.4.1.1
Single Word Programming
The programming time for single word programming is dependent on the bus frequency as a well as on the
frequency f¨NVMOP and can be calculated according to the following formula.
A.4.1.2
Row Programming
Flash programming where up to 64 words in a row can be programmed consecutively by keeping the
command pipeline lled. The time to program a consecutive word can be calculated as:
The time to program a whole row is:
Row programming is more than 2 times faster than single word programming.
A.4.1.3
Sector Erase
Erasing a 1024 byte Flash sector takes:
The setup times can be ignored for this operation.
t
swpgm
9
1
f
NVMOP
-------------------------
25
1
f
bus
------------
+
=
t
bwpgm
4
1
f
NVMOP
-------------------------
9
1
f
bus
------------
+
=
t
brpgm
t
swpgm
63 t
bwpgm
+
=
t
era
4000
1
f
NVMOP
-------------------------
≈