- 您現在的位置：買賣IC網 > PDF目錄2012 > MC92603VF (Freescale Semiconductor)IC TXRX ETH QUAD GIG 256-MAPBGA PDF資料下載
參數資料
| 型號： | MC92603VF |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 67/126頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX ETH QUAD GIG 256-MAPBGA |
| 標準包裝： | 1 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 4/4 |
| 規程： | 千兆位以太網 |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 256-LBGA |
| 供應商設備封裝： | 256-MAPBGA |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁當前第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁
Receiver
MC92603 Quad Gigabit Ethernet Transceiver Reference Manual, Rev. 1
Freescale Semiconductor
3-11
When word synchronization is lost it must be re-established before data flow through the receiver resumes.
The receiver interface is disabled during initial word alignment. No data is produced at its outputs until
word alignment is achieved and a word synchronization event has been detected. When establishing word
synchronization, or when word synchronization is lost, ‘not word sync’ error is reported as described in
Word synchronization is possible in byte interface mode and TBI mode. However, word synchronization
may be dependent on the detection of simultaneously transmitted word synchronization events that contain
Idle characters. Therefore, if operating in TBI mode, either the Idle character must be a supported member
of the code set or the ‘A’ character alignment must be used.
If WSE is high, then all enabled receivers (those that have XCVR_x_DISABLE negated low) will be
aligned into a 16-, 24-, or 32-bit word (depending on the states of the various XCVR_x_DISABLE
signals). If the receiver on channel A is disabled, then do not select the clock from channel A as the
recovered clock for all the channels.
3.6
Receiver Interface Timing Modes
The receiver interface is timed to the recovered clock (link partner’s clock) or to the reference clock (local
clock), depending on the state of the recovered clock enable, RCCE, signal. RCCE enables timing relative
to the recovered clock when asserted and enables timing relative to the reference clock when negated.
The receiver interface clock signals, RECV_x_RCLK, will always be present when the PLL is in lock. This
is true even if there is no signal present on the serial inputs or if the receiver has not achieved alignment
or byte sync. The frequency of the receiver clock will be the local reference clock until synchronization is
achieved. The RECV_x_RCLK clock signals, however, are not present during power up or when the
MC92603 is in reset mode and the PLL is not locked.
All receiver channels data outputs are source synchronous with their respective RECV_x_RCLK outputs.
They may be configured to be source aligned or source centered with their respective RECV_x_RCLK
outputs. The configuration signal, RECV_CLK_CENT, when asserted high, will center the receiver clocks
relative to the data and status outputs.
NOTE
The receiver clock complement, RECV_x_RCLK_B, is only provided in
the TBIE/RTBI Ethernet compliant application modes (TBIE and
COMPAT = high). If either TBIE or COMPAT is low, then
RECV_x_RCLK_B is always low.
3.6.1
Recovered Clock Timing Mode (RCCE = High)
With RCCE asserted, the receiver clock signal, RECV_x_RCLK, is generated by the receiver and, on
average, runs at the reference clock frequency of the transmitter (link partner’s clock) at the other end of
the link. The recovered clock is not generated by a clock recovery PLL but by monitoring the receive
FIFO.
相關PDF資料 |
PDF描述 |
|---|---|
| MC92604VM | IC ETH TXRX DUAL GIG 196-MAPBGA |
| MC92604ZT | IC TXRX ETH DUAL GIG 196-MAPBGA |
| MCP2120T-I/SL | IC ENCODR/DECODR 2.5V IR 14-SOIC |
| MCP2122-E/P | IC ENCODER/DECODER IRDA 8-DIP |
| MCP2122T-E/SNG | IC ENCODER/DECODR INFRARED 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC92603VM | 功能描述:IC ETH TXRX QUAD GIG 256-MAPBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC92604VM | 功能描述:IC ETH TXRX DUAL GIG 196-MAPBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC92604ZT | 功能描述:IC TXRX ETH DUAL GIG 196-MAPBGA RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件 |
| MC92610 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Quad 3.125 Gbaud SERDES |
| MC92610VF | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Quad 3.125 Gbaud SERDES |
發布緊急采購，3分鐘左右您將得到回復。