參數資料
型號: MC7660
廠商: ON SEMICONDUCTOR
英文描述: Charge Pump DC-to-DC Voltage Converter
中文描述: 電荷泵型DC - DC電壓轉換器
文件頁數: 4/12頁
文件大小: 191K
代理商: MC7660
MC7660
http://onsemi.com
4
Simple Negative Voltage Converter
Figure 3 shows typical connections to provide a negative
supply where a positive supply is available. A similar
scheme may be employed for supply voltages anywhere in
the operating range of +1.5V to +10V, keeping in mind that
pin 6 (LV) is tied to the supply negative (GND) only for
supply voltages below 3.5V.
The output characteristics of the circuit in Figure 3 are
those of a nearly ideal voltage source in series with 70 .
Thus, for a load current of –10mA and a supply voltage of
+5V, the output voltage would be –4.3V.
The dynamic output impedance of the MC7660 is due,
primarily, to capacitive reactance of the charge transfer
capacitor (C
1
). Since this capacitor is connected to the output
for only 1/2 of the cycle, the equation is:
XC
2
2 f C1
3.18 ,
where f = 10kHz and C
1
= 10
μ
F.
Figure 3. Simple Negative Converter
MC7660
1
2
3
4
8
7
6
5
+
+
V+
C1
10 F
C2
10 F
VOUT
Parallel Devices
Any number of MC7660 voltage converters may be
paralleled to reduce output resistance (Figure 4). The
reservoir capacitor, C
2
, serves all devices, while each device
requires its own pump capacitor, C
1
. The resultant output
resistance would be approximately:
ROUT
ROUT(of MC7660)
n (number of devices)
Figure 4. Paralleling Devices Lowers Output Impedance
MC7660
1
2
3
4
8
7
6
5
V+
C1
MC7660
1
2
3
4
8
7
6
5
+
C1
C2
RL
Cascading Devices
The MC7660 may be cascaded as shown (Figure 5) to
produce larger negative multiplication of the initial supply
voltage. However, due to the finite efficiency of each device,
the practical limit is 10 devices for light loads. The output
voltage is defined by:
V
OUT
= –n (V
IN
)
where n is an integer representing the number of devices
cascaded. The resulting output resistance would be
approximately the weighted sum of the individual MC7660
R
OUT
values.
Changing the MC7660 Oscillator Frequency
It may be desirable in some applications (due to noise or
other considerations) to increase the oscillator frequency.
This is achieved by overdriving the oscillator from an
external clock, as shown in Figure 6. In order to prevent
possible device latch–up, a 1k resistor must be used in
series with the clock output. In a situation where the designer
has generated the external clock frequency using TTL logic,
the addition of a 10k pull–up resistor to V
+
supply is
required. Note that the pump frequency with external
clocking, as with internal clocking, will be 1/2 of the clock
frequency. Output transitions occur on the positive–going
edge of the clock.
It is also possible to increase the conversion efficiency of
the MC7660 at low load levels by lowering the oscillator
frequency. This reduces the switching losses, and is
achieved by connecting an additional capacitor, C
OSC
, as
shown in Figure 7. Lowering the oscillator frequency will
cause an undesirable increase in the impedance of the pump
(C
1
) and the reservoir (C
2
) capacitors. To overcome this,
increase the values of C
1
and C
2
by the same factor that the
frequency has been reduced. For example, the addition of a
100pF capacitor between pin 7 (OSC) and pin 8 (V
+
) will
lower the oscillator frequency to 1kHz from its nominal
frequency of 10kHz (a multiple of 10), and necessitate a
corresponding increase in the values of C
1
and C
2
(from
10
μ
F to 100
μ
F).
相關PDF資料
PDF描述
MC78BC31NTR Micropower Voltage Regulator
MC78BC43NTR Micropower Voltage Regulator
MC78BC45NTR Micropower Voltage Regulator
MC78L00D 5.0 AMP POSITIVE VOLTAGE REGULATOR
MC78L08ABPG 5.0 AMP POSITIVE VOLTAGE REGULATOR
相關代理商/技術參數
參數描述
MC7660DR2 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:ON Semiconductor 功能描述:
MC7700_1101346 制造商:Sierra Wireless 功能描述:4G/LTE MINI CARD
MC7700_1101366 制造商:Sierra Wireless 功能描述:4G/LTE MINI CARD
MC7700_1101367 制造商:Sierra Wireless 功能描述:4G/LTE MINI CARD
MC7700_1101404 制造商:Sierra Wireless 功能描述:4G/LTE MINI CARD