- 您現在的位置：買賣IC網 > PDF目錄371023 > MC34160 (ON SEMICONDUCTOR) Single Output LDO, 250mA, Fixed(5.0V), Low Noise, Fast Transient Response 6-SOT-223 -40 to 85 PDF資料下載
參數資料
| 型號： | MC34160 |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Single Output LDO, 250mA, Fixed(5.0V), Low Noise, Fast Transient Response 6-SOT-223 -40 to 85 |
| 中文描述： | 微處理器電壓調節器/監控電路 |
| 文件頁數： | 5/8頁 |
| 文件大?。?/td> | 188K |
| 代理商： | MC34160 |
MC34160 MC33160
5
MOTOROLA ANALOG IC DEVICE DATA
Figure 9. DW Suffix (SOP–16L) Thermal Resistance and
Maximum Power Dissipation versus P.C.B. Copper Length
100
PD(max) for TA = 50
°
C
30
40
50
60
70
80
90
0
0.4
0.8
1.2
1.6
2.0
2.4
0
20
30
50
40
10
L, LENGTH OF COPPER (mm)
2.8
R
θ
JA
PD
R
θ
,
J
J
°
,
Graph represents symmetrical layout
L
PIN FUNCTION DESCRIPTION
Pin
1
Function
Description
Comparator Inverting Input
This is the Uncommitted Comparator Inverting input. It is typically connected to a resistor
divider to monitor a voltage.
2
Comparator Noninverting Input
This is the Uncommitted Comparator Noninverting input. It is typically connected to a
reference voltage.
3
N.C.
No connection. This pin is not internally connected.
4, 5, 12, 13
Gnd
These pins are the control circuit grounds and are connected to the source and load
ground returns. They are part of the IC lead frame and can be used for heatsinking.
6
Comparator Output
This is the Uncommitted Comparator output. It is an open collector sink–only output
requiring a pull–up resistor.
7
Reset
This is the Reset Comparator output. It is an open collector sink–only output requiring a
pull–up resistor.
8
Power Warning
This is the Power Warning Comparator output. It is an open collector sink–only output
requiring a pull–up resistor.
9
Power Sense
This is the Power Warning Comparator noninverting input. It is typically connected to a
resistor divider to monitor the input power source voltage.
10
Hysteresis Adjust
The Power Warning Comparator hysteresis is programmed by a resistor connected from
this pin to ground.
11
Regulator Output
This is the 5.0 V Regulator output.
14
VCC
Chip Disable
This pin is the positive supply input of the control IC.
15
This input is used to switch the IC into a standby mode turning off all outputs.
16
Vref
This is the 2.6 V Reference output. It is intended to be used in conjunction with the Power
Warning and Uncommitted comparators.
OPERATING DESCRIPTION
The MC34160 series is a monolithic voltage regulator and
supervisory circuit containing many of the necessary
monitoring functions required in microprocessor based
systems. It is specifically designed for appliance and
industrial applications, offering the designer a cost effective
solution with minimal external components. These devices
are specified for operation over an input voltage of 7.0 V to
40 V, and with a junction temperature of –40
°
to +150
°
C. A
typical microprocessor application is shown in Figure 10.
Regulator
The 5.0 V regulator is designed to source in excess of
100 mA output current and is short circuit protected. The
output has a guaranteed tolerance of
±
5.0% over line, load,
and temperature. Internal thermal shutdown circuitry is
included to limit the maximum junction temperature to a safe
level. When activated, typically at 170
°
C, the regulator output
turns off.
In specific situations a combination of input and output
bypass capacitors may be required for regulator stability. If
the regulator is located an appreciable distance (
≥
4
″
) from
the supply filter, an input bypass capacitor (Cin) of 0.33
μ
F or
greater is suggested. Output capacitance values of less than
5.0 nF may cause regulator instability at light load (
≤
1.0 mA)
and cold temperature. An output bypass capacitor of 0.1
μ
F
or greater is recommended to ensure stability under all load
conditions. The capacitors selected must provide good high
frequency characteristics.
Good construction techniques should be used to minimize
ground loops and lead resistance drops since the regulator
does not have external sense inputs.
相關PDF資料 |
PDF描述 |
|---|---|
| MC34160DW | Single Output LDO, 250mA, Fixed(5.0V), Low Noise, Fast Transient Response 6-SOT-223 -40 to 85 |
| MC34160P | MICROPROCESSOR VOLTAGE REGULATOR/ SUPERVISORY CIRCUIT |
| MC33160DW | Tag-it(TM) HF-I Standard Transponder Inlays Square 0-RFIDN -25 to 70 |
| MC33160P | MICROPROCESSOR VOLTAGE REGULATOR/ SUPERVISORY CIRCUIT |
| MC34160DW | MICROPROCESSOR VOLTAGE REGULATOR/ SUPERVISORY CIRCUIT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC34160_06 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:100 mA, 5.0 V Voltage Regulator and Supervisory Circuit for Microprocessors |
| MC34160DW | 功能描述:線性穩壓器 - 標準 5V 100mA REG RoHS:否 制造商:STMicroelectronics 輸出類型: 極性: 輸出電壓:1.8 V 輸出電流:150 mA 負載調節: 最大輸入電壓:5.5 V 線路調整率: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-323-5L |
| MC34160DWG | 功能描述:線性穩壓器 - 標準 5V 100mA REG w/Supervisor RoHS:否 制造商:STMicroelectronics 輸出類型: 極性: 輸出電壓:1.8 V 輸出電流:150 mA 負載調節: 最大輸入電壓:5.5 V 線路調整率: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-323-5L |
| MC34160DWR2 | 功能描述:線性穩壓器 - 標準 5V 100mA REG RoHS:否 制造商:STMicroelectronics 輸出類型: 極性: 輸出電壓:1.8 V 輸出電流:150 mA 負載調節: 最大輸入電壓:5.5 V 線路調整率: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-323-5L |
| MC34160DWR2G | 功能描述:線性穩壓器 - 標準 5V 100mA REG w/Supervisor RoHS:否 制造商:STMicroelectronics 輸出類型: 極性: 輸出電壓:1.8 V 輸出電流:150 mA 負載調節: 最大輸入電壓:5.5 V 線路調整率: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-323-5L |
發布緊急采購，3分鐘左右您將得到回復。