- 您現在的位置：買賣IC網 > PDF目錄1947 > MC145017P (Freescale Semiconductor)IC SMOKE DETECT PHOTOELEC 16-DIP PDF資料下載
參數資料
| 型號： | MC145017P |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 5/10頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SMOKE DETECT PHOTOELEC 16-DIP |
| 標準包裝： | 25 |
| 類型： | 煙霧探測器 |
| 輸入類型： | 離子化 |
| 輸出類型： | 電壓 |
| 電流 - 電源： | 12µA |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 16-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 16-PDIP |
| 包裝： | 管件 |
Sensors
4
Freescale Semiconductor
MC145017
Archived by Freescale Semiconductor, Inc., 2009
Archive
Information
Archive
Information
Figure 3. Typical LED Output I–V Characteristic
Figure 4. Typical Comparator Output I–V Characteristic
Figure 5. Typical P Horn Driver Output I–V Characteristic
DEVICE OPERATION
Timing
The internal oscillator of the MC145017 operates with a
period of 1.65 seconds during no-smoke conditions. Each
1.65 seconds, internal power is applied to the entire IC and a
check is made for smoke, except during LED pulse, Low
Battery Alarm Chirp, or Horn Modulation (in smoke). Every 24
clock cycles a check is made for low battery by comparing
VDD to an internal zener voltage. Since very small currents
are used in the oscillator, the oscillator capacitor should be of
a low leakage type.
Detect Circuitry
If smoke is detected, the oscillator period becomes
41.67 ms and the piezoelectric horn oscillator circuit is
enabled. The horn output is modulated 500 ms on, 500 ms
off. During the off time, smoke is again checked and will
inhibit further horn output if no smoke is sensed. During
smoke conditions the low battery alarm is inhibited, but the
LED pulses at a 1.0 Hz rate.
An active guard is provided on both pins adjacent to the
detect input. The voltage at these pins will be within 100 mV
of the input signal. This will keep surface leakage currents to
a minimum and provide a method of measuring the input
voltage without loading the ionization chamber. The active
guard op amp is not power strobed and thus gives constant
protection from surface leakage currents. Pin 15 (the Detect
input) has internal diode protection against static damage.
Sensitivity/Low Battery Thresholds
Both the sensitivity threshold and the low battery voltage
levels are set internally by a common voltage divider (please
see Figure 2) connected between VDD and VSS. These
voltages can be altered by external resistors connected from
pins 3 or 13 to either VDD or VSS. There will be a slight
interaction here due to the common voltage divider network.
The sensitivity threshold can also be set by adjusting the
smoke chamber ionization source.
Test Mode
Since the internal op amps and comparators are power
strobed, adjustments for sensitivity or low battery level could
be difficult and/or time-consuming. By forcing Pin 12 to VSS,
the power strobing is bypassed and the outputs, Pins 1 and
4, constantly show smoke/no smoke and good battery/low
0
1
2
3
4
5
678
9
10
0.1
1.0
10.0
100.0
VDS, Drain To Source Voltage (Vdc)
I D
,D
rai
nC
urre
nt
(m
A)
01
2
3
4
5
6
7
8
9
10
0.01
0.1
1.0
10.0
VDS, Drain To Source Voltage (Vdc)
I D
,Drain
Curren
t(mA)
VDD = 9.0 Vdc
VDD = 7.2 Vdc
TA = 25°C
VDD = 9.0 Vdc or 7.2 Vdc
TA = 25°C
P-CH Source
And N-CH Sink
Current
0
1
2
3
4
5
678
9
10
1.0
10.0
100.0
1000.0
I D
,Drain
Cu
rrent
(mA)
VDS, Drain To Source Voltage (Vdc)
VDD = 9.0 Vdc
TA = 25°C
VDD = 7.2 Vdc
P-CH Source Current
0
1
2
3
4
5
678
9
10
1.0
10.0
100.0
1000.0
VDS, Drain To Source Voltage (Vdc)
I D
,Drain
Curre
nt
(mA)
VDD = 9.0 Vdc
VDD = 7.2 Vdc
TA = 25°C
N-CH Sink Current
相關PDF資料 |
PDF描述 |
|---|---|
| MC145018P | IC SMOKE DETECT PHOTOELEC 16-DIP |
| MC14551BFELG | IC MUX/DEMUX QUAD 2X1 16SOEIAJ |
| MC14578P | IC SMOKE COMPARATOR MPWR 16-DIP |
| MC14600P | IC ALARM GENERAL MONO 16-DIP |
| MC1488DR2G | IC LINE DRIVER QUAD MONO 14-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC145018P | 功能描述:IC SMOKE DETECT PHOTOELEC 16-DIP RoHS:否 類別:集成電路 (IC) >> 接口 - 傳感器和探測器接口 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:74 系列:- 類型:觸控式傳感器 輸入類型:數字 輸出類型:數字 接口:JTAG，串行 電流 - 電源:100µA 安裝類型:表面貼裝 封裝/外殼:20-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:20-TSSOP 包裝:管件 |
| MC145026D | 功能描述:鎖相環 - PLL Encoder RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray |
| MC145026DR2 | 功能描述:IC ENCODER 9 LINE SMPLX 16-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 編碼器，解碼器，轉換器 系列:4000 產品變化通告:Development Systems Discontinuation 26/Apr/2011 標準包裝:1 系列:- 類型:編碼器 應用:DVB-S.2 系統 電壓 - 電源，模擬:- 電壓 - 電源，數字:- 安裝類型:- 封裝/外殼:模塊 供應商設備封裝:模塊 包裝:散裝 其它名稱:Q4645799 |
| MC145026P | 功能描述:IC ENCODER 9LINE SIMPLEX 16-DIP RoHS:否 類別:集成電路 (IC) >> 接口 - 編碼器，解碼器，轉換器 系列:4000 產品變化通告:Development Systems Discontinuation 26/Apr/2011 標準包裝:1 系列:- 類型:編碼器 應用:DVB-S.2 系統 電壓 - 電源，模擬:- 電壓 - 電源，數字:- 安裝類型:- 封裝/外殼:模塊 供應商設備封裝:模塊 包裝:散裝 其它名稱:Q4645799 |
| MC145027DW | 功能描述:鎖相環 - PLL Decoder RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。