- 您現在的位置：買賣IC網 > PDF目錄383545 > MAX997ESA (MAXIM INTEGRATED PRODUCTS INC) Hex 2-Input NAND Drivers 20-CDIP -55 to 125 PDF資料下載
參數資料
| 型號： | MAX997ESA |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 運動控制電子 |
| 英文描述： | Hex 2-Input NAND Drivers 20-CDIP -55 to 125 |
| 中文描述： | COMPARATOR, 2000 uV OFFSET-MAX, 4.5 ns RESPONSE TIME, PDSO8 |
| 封裝： | 0.150 INCH, MS-012AA, SOIC-8 |
| 文件頁數： | 9/12頁 |
| 文件大小： | 371K |
| 代理商： | MAX997ESA |
M
Single/Dual/Quad, Ultra-High-Speed, +3V/+5V,
Beyond-the-Rails Comparators
_______________________________________________________________________________________
9
Output Stage Circuitry
The MAX961–MAX964/MAX997/MAX999 contain a cur-
rent-driven output stage, as shown in Figure 4. During an
output transition, I
SOURCE
or I
SINK
is pushed or pulled to
the output pin. The output source or sink current is high
during the transition, creating a rapid slew rate. Once the
output voltage reaches V
OH
or V
OL
, the source or sink
current decreases to a small value, capable of maintain-
ing the V
OH
or V
OL
in static condition. This decrease in
current conserves power after an output transition has
occurred.
One consequence of a current-driven output stage is a
linear dependence between the slew rate and the load
capacitance. A heavy capacitive load slows down the
voltage output transition.
Shutdown Mode
When SHDN is high, the MAX961/MAX963/MAX964/
MAX997 shut down. When shut down, the supply cur-
rent drops to 270μA per comparator, and the outputs
become high impedance. SHDN has a high input
impedance. Connect SHDN to GND for normal opera-
tion. Exit shutdown with LE low; otherwise, the output is
indeterminate.
__________Applications Information
Circuit Layout and Bypassing
The MAX961–MAX964/MAX997/MAX999’s high band-
width requires a high-speed layout. Follow these layout
guidelines:
1) Use a printed circuit board with a good, unbroken,
low-inductance ground plane.
2) Place a decoupling capacitor (a 0.1μF ceramic sur-
face-mount capacitor is a good choice) as close to
V
CC
as possible.
3) On the inputs and outputs, keep lead lengths short
to avoid unwanted parasitic feedback around the
comparators. Keep inputs away from outputs. Keep
impedance between the inputs low.
4) Solder the device directly to the printed circuit board
rather than using a socket.
5) Refer to Figure 5 for a recommended circuit layout.
6) For slow-moving input signals, take care to prevent
parasitic feedback. A small capacitor (1000pF or
less) placed between the inputs can help eliminate
oscillations in the transition region. This capacitor
causes negligible degradation to t
PD
when the
source impedance is low.
Figure 4. Output Stage Circuitry
MAX961-MAX964
MAX997
MAX999
I
SOURCE
Q, Q
V
CC
GND
I
SINK
Figure 5. MAX961 PC Board Layout
相關PDF資料 |
PDF描述 |
|---|---|
| MAX961 | Octal Buffers/Drivers With 3-State Outputs 20-LCCC -55 to 125 |
| MAX961ESA | Octal Buffers/Drivers With 3-State Outputs 20-CDIP -55 to 125 |
| MAX962 | Octal Buffers/Drivers With 3-State Outputs 20-CFP -55 to 125 |
| MAX962ESA | Octal Registered Transceivers With 3-State Outputs 28-LCCC -55 to 125 |
| MAX962EUA | Octal Registered Transceivers With 3-State Outputs 24-CFP -55 to 125 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX997ESA+ | 功能描述:校驗器 IC Single uPower Comparator RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
| MAX997ESA+T | 功能描述:校驗器 IC Single uPower Comparator RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
| MAX997ESA-T | 功能描述:校驗器 IC Single uPower Comparator RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
| MAX997EUA | 功能描述:校驗器 IC Single uPower Comparator RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
| MAX997EUA+ | 功能描述:校驗器 IC Single uPower Comparator RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
發(fā)布緊急采購，3分鐘左右您將得到回復。