參數資料
型號: MAX932
廠商: Maxim Integrated Products, Inc.
英文描述: Ultra Low-Power, Low-Cost Comparators with 2eference
中文描述: 超低功耗、低成本比較器、內置2%電壓基準
文件頁數: 11/16頁
文件大?。?/td> 164K
代理商: MAX932
Board Layout and Bypassing
Power-supply bypass capacitors are not needed if the
supply impedance is low, but 100nF bypass capacitors
should be used when the supply impedance is high or
when the supply leads are long. Minimize signal lead
lengths to reduce stray capacitance between the input
and output that might cause instability. Do not bypass
the reference output.
_______________Typic al Applic ations
Auto-Off Power S ourc e
Figure 5 shows the schematic for a 40mA power supply
that has a timed auto power-off function. The
comparator output is the switched power-supply output.
With a 10mA load, it typically provides a voltage of
(V
BATT
- 0.12V), but draws only 3.5μA quiescent current.
This circuit takes advantage of the four key features of
the MAX931: 2.5μA supply current, an internal
reference, hysteresis, and high current output. Using
the component values shown, the three-resistor voltage
divider programs the maximum ±50mV of hysteresis
and sets the IN- voltage at 100mV. This gives an IN+
trip threshold of approximately 50mV for IN+ falling.
The RC time constant determines the maximum power-
on time of the OUT pin before power-down occurs.
This period can be approximated by:
R x C x 4.6sec
For example: 2M
x 10μF x 4.6 = 92sec. The actual
time will vary with both the leakage current of the
capacitor and the voltage applied to the circuit.
Window Detec tor
The MAX933 is ideal for making window detectors
(undervoltage/overvoltage detectors). The schematic
is shown in Figure 6, with component values selected
for an 4.5V undervoltage threshold, and a 5.5V
overvoltage threshold. Choose different thresholds by
changing the values of R1, R2, and R3. To prevent
chatter at the output when the supply voltage is close
to a threshold, hysteresis has been added using R4
and R5. OUTA provides an active-low undervoltage
indication, and OUTB gives an active-low overvoltage
indication. ANDing the two outputs provides an active-
high, power-good signal.
The design procedure is as follows:
1. Choose the required hysteresis level and calculate
values for R4 and R5 according to the formulas in
the Hysteresis (MAX931/MAX932/MAX933) section.
In this example, ±5mV of hysteresis has been added
at the comparator input (V
H
= V
HB
/2). This means
that the hysteresis apparent at V
IN
will be larger
because of the input resistor divider.
2. Select R1. The leakage current into INB- is normally
under 1nA, so the current through R1 should exceed
M
Ultra Low-Power, Low-Cost
Comparators with 2% Referenc e
______________________________________________________________________________________
11
IN+
MAX931
OUT
IN-
HYST
REF
V-
V+
VBATT -0.15V
10mA
2
1
4
5
6
8
3
100k
1.1M
47k
4.5V TO6.0V
MOMENTARY SWITCH
7
R
C
GND
Figure 5. Auto-off power switch operates on 2.5μA quiescent
current.
MAX933
INB-
REF
HYST
INA+
V-
V+
OUTA
OUTB
R5
10k
R1
R2
R3
UNDERVOLTAGE
V
IN
V
OTH
= 5.5V
V
UTH
= 4.5V
+5V
POWER GOOD
OVERVOLTAGE
R4
2.4M
Figure 6. Window Detector
相關PDF資料
PDF描述
MAX934 Ultra Low-Power, Low-Cost Comparators with 2eference
MAX934CPE Ultra Low-Power, Low-Cost Comparators with 2eference
MAX934CSE Ultra Low-Power, Low-Cost Comparators with 2eference
MAX934EPE Ultra Low-Power, Low-Cost Comparators with 2eference
MAX934ESE Ultra Low-Power, Low-Cost Comparators with 2eference
相關代理商/技術參數
參數描述
MAX9320AEKA 制造商:Maxim Integrated Products 功能描述:1:2 DIFFERENTIAL LVPECL/LVECL/HSTL - Rail/Tube
MAX9320AEKA-T 制造商:Maxim Integrated Products 功能描述:1:2 DIFFERENTIAL LVPECL/LVECL/HSTL CLOCK AND - Tape and Reel
MAX9320BESA 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:
MAX9320BESA+ 制造商:Maxim Integrated Products 功能描述:LINE TRANSMITTER 1TX 8SOIC N - Rail/Tube
MAX9320BESA+T 制造商:Maxim Integrated Products 功能描述:LINE TRANSMITTER 1TX 8SOIC N - Tape and Reel