參數資料
型號: MAX864EEE
廠商: MAXIM INTEGRATED PRODUCTS INC
元件分類: 穩壓器
英文描述: Dual-Output Charge Pump with Shutdown
中文描述: SWITCHED CAPACITOR CONVERTER, 185 kHz SWITCHING FREQ-MAX, PDSO16
封裝: 0.150 INCH, 0.025 INCH PITCH, QSOP-16
文件頁數: 7/12頁
文件大?。?/td> 122K
代理商: MAX864EEE
M
Dual-Output Charge Pump with S hutdown
_______________________________________________________________________________________
7
Charge-Pump Output
The MAX864 is not a voltage regulator: the output
source resistance of either charge pump is approxi-
mately 55
at room temperature (with V
IN
= 5V); and V+
and V- approach +10V and -10V, respectively, when
lightly loaded. Both V+ and V- will droop toward GND as
the current draw from either V+ or V- increases, since V-
is derived from V+. Treating each converter separately,
the droop of the negative supply (V
DROOP-
) is the prod-
uct of the current draw from V- (I
V-
) and the source
resistance of the negative converter (RS-):
The droop of the positive supply (V
DROOP+
) is the
product of the current draw from the positive supply
(I
LOAD+
) and the source resistance of the positive con-
verter (RS+), where I
LOAD+
is the combination of I
V-
and the external load on V+ (I
V+
):
Determine V+ and V- as follows:
The output resistances for the positive and negative
charge pumps are tested and specified separately. The
positive charge pump is tested with V- unloaded. The
negative charge pump is tested with V+ supplied from
an external source, isolating the negative charge pump.
Current draw from either V+ or V- is supplied by the
reservoir capacitor alone during one half cycle of the
clock. Calculate the resulting ripple voltage on either
output as follows:
where I
LOAD
is the load on either V+ or V-. For exam-
ple, with an f
PUMP
of 33kHz and 6.8μF reservoir capaci-
tors, the ripple is 26mV when I
LOAD
is 12mA.
Remember that, in most applications, the total load on
V+ is the V+ load current (I
V+
) and the current taken by
the negative charge pump (I
V-
).
S hutdown
The MAX864 features a shutdown mode that reduces
the maximum supply current to 1μA over temperature.
The
SHDN
pin is an active-low TTL logic-level input. If
the shutdown feature is unused, connect
SHDN
to IN.
In shutdown mode, V+ connects to IN through a 22
switch and V- connects to GND through a 6
switch.
_________Effic ienc y Considerations
Theoretically, a charge-pump voltage multiplier can
approach 100% efficiency under the following condi-
tions:
The charge-pump switches have virtually no offset,
and extremely low on-resistance.
The drive circuitry consumes minimal power.
The impedances of the reservoir and pump capaci-
tors are negligible.
For the MAX864, the energy loss per clock cycle is the
sum of the energy loss in the positive and negative
converters, as follows:
where V+ and V- are the actual measured output volt-
ages.
The average power loss is simply:
Resulting in an efficiency of:
P
= LOSS
LOSS
There will be a substantial voltage difference between
(V+ - V
IN
) and V
IN
for the positive pump, and between
V+ and V- if the impedances of the pump capacitors
(C1 and C2) are large with respect to their respective
output loads.
Larger reservoir capacitor (C3 and C4) values will
reduce output ripple. Larger values of both pump and
reservoir capacitors will improve efficiency.
V
= I
x RS -
DROOP-
V-
V
= I
x RS+ = I
+ I
x RS+
DROOP+
LOAD+
V+
V-
(
)
V+ = 2V - V
V- = (V+ - V
= -(2V
)
- V
- V
)
DROOP+
DROOP
IN
DROOP+
DROOP-
V
= I
(1 / f
) (1 / C
)
RIPPLE
PUMP
RESERVOIR
LOSS
= LOSS
+ LOSS
)
=
C1
CYCLE
POS
(
NEG
1
2
1
2
V
V
V
C
V
V
IN
+
+
(
) (
)
+
+
(
)
(
)
2
2
2
2
2
x f
CYCLE
PUMP
η =
)
Total Output Power Total Output Power
/
P
LOSS
相關PDF資料
PDF描述
MAX865 Compact, Dual-Output Charge Pump
MAX865EUA Compact, Dual-Output Charge Pump
MAX866 Hex Inverters 20-LCCC -55 to 125
MAX866ESA Hex Inverters 14-CDIP -55 to 125
MAX867 Hex Inverters 14-CFP -55 to 125
相關代理商/技術參數
參數描述
MAX864EEE+ 功能描述:電荷泵 Dual-Output Charge Pump RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube
MAX864EEE+T 功能描述:電荷泵 Dual-Output Charge Pump RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube
MAX864EEE-T 功能描述:電荷泵 Dual-Output Charge Pump RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube
MAX8650EEG+ 功能描述:DC/DC 開關控制器 4.5-28V Current-Mode Step-Down Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
MAX8650EEG+T 功能描述:DC/DC 開關控制器 4.5-28V Current-Mode Step-Down Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK