- 您現在的位置：買賣IC網 > PDF目錄385550 > MAX786 (Maxim Integrated Products, Inc.) Dual-Output Power-Supply Controller for Notebook Computers(具有25μA關斷的,3.3V/5V筆記本型電腦電源) PDF資料下載
參數資料
| 型號： | MAX786 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | Dual-Output Power-Supply Controller for Notebook Computers(具有25μA關斷的,3.3V/5V筆記本型電腦電源) |
| 中文描述： | 雙輸出電源控制器，用于筆記本電腦 |
| 文件頁數： | 15/24頁 |
| 文件大?。?/td> | 301K |
| 代理商： | MAX786 |
M
Dual-Output Power-S upply
Controller for Notebook Computers
______________________________________________________________________________________
15
Be sure to select output capacitors that satisfy
both
the minimum capacitance and maximum ESR require-
ments. To achieve the low ESR required, it may be
appropriate to use a capacitance value 2 or 3 times
larger than the calculated minimum.
The output ripple in continuous-current mode is:
V
OUT(RPL)
= I
LPP(MAX)
x (ESR
CF
+ 1/(2 x
π
x f x C
F
) ).
In idle-mode, the ripple has a capacitive and resistive
component:
(4) (10
-4
) (L)
V
OUT(RPL)
(C) = ——————— x
(
(0.02) (ESR
)
V
OUT(RPL)
(R) = ———————- Volts
(R
CS2
) (C
F
)
1 1
——— + —————
)
Volts
V
OUT
V
IN
- V
OUT
R
CS
The total ripple, V
OUT(RPL)
, can be approximated as
follows:
if V
OUT(RPL)
(R) < 0.5 V
OUT(RPL)
(C),
then V
OUT(RPL)
= V
OUT(RPL)
(C),
otherwise, V
OUT(RPL)
= 0.5 V
OUT(RPL)
(C) +
V
OUT(RPL)
(R).
Diodes D1 and D3
Use 1N5819s or similar Schottky diodes. D1 and D3
conduct only about 3% of the time, so the 1N5819’s
1A current rating is conservative. The voltage rating
of D1 and D3 must exceed the maximum input supply
voltage from the battery. These diodes must
be Schottky diodes to prevent the lossy MOSFET
body diodes from turning on, and they must be
placed physically close to their associated synchro-
nous rectifier MOSFETs.
S oft-S tart Capac itors (C8, C9)
A capacitor connected from GND to either SS pin
causes that supply to ramp up slowly. The ramp time to
full current limit, t
, is approximately 1ms for every nF
of capacitance on SS_, with a minimum value of 10μs.
Typical capacitor values are in the 10nF to 100nF
range; a 5V rating is sufficient.
Because this ramp is applied to the current-limit circuit,
the actual time for the output voltage to ramp up
depends on the load current and output capacitor
value. Using Figure 1’s circuit with a 2A load and no SS
capacitor, full output voltage is reached about 600μs
after ON_ is driven high.
Boost Capac itors (C4, C5)
Capacitors C4 and C5 store the boost voltage and pro-
vide the supply for the DH3 and DH5 drivers. Use 0.1μF
and place each within 10mm of the BST_ and LX_ pins.
Boost Diodes (D1A, D1B)
Use high-speed signal diodes; e.g., 1N4148 or
equivalent.
Bypass Capac itors
Input Filter Capacitors (C1, C10)
Use at least 3μF/W of output power for the input filter
capacitors, C1 and C10. They should have less than
150m
ESR, and should be located no further than
10mm from N1 and N2 to prevent ringing. Connect the
negative terminals directly to PGND. Do not exceed the
surge current ratings of input bypass capacitors.
S hutdown Mode
Shutdown (
SHDN
= low) forces both PWMs off and dis-
ables the REF output and both comparators (Q1 = Q2
= 0V). Supply current in shutdown mode is typically
25μA. The VL supply remains active and can source
25mA for external loads. Note that the VL load capabili-
ty is higher in shutdown and standby modes than when
the PWMs are operating (25mA vs. 5mA). Standby
mode is achieved by holding ON3 and ON5 low while
SHDN
is high. This disables both PWMs, but keeps VL,
REF, and the precision comparators alive. Supply current
in standby mode is typically 70μA.
MAX786
KELVIN SENSE TRACES
SENSE RESISTOR
MAIN CURRENT PATH
FAT, HIGH-CURRENT TRACES
Figure 5. Kelvin Connections for the Current-Sense Resistors
相關PDF資料 |
PDF描述 |
|---|---|
| MAX787 | 5V/3.3V/3V 5A Step-Down, PWM, Switch-Mode DC-DC Regulators(5A,5V步降,PWM,開關型DC-DC變換器) |
| MAX788 | 5V/3.3V/3V 5A Step-Down, PWM, Switch-Mode DC-DC Regulators(5A,5V步降,PWM,開關型DC-DC變換器) |
| MAX789 | 5V/3.3V/3V 5A Step-Down, PWM, Switch-Mode DC-DC Regulators(5A,5V步降,PWM,開關型DC-DC變換器) |
| MAX791 | Microprocessor Supervisory Circuit(微處理器監控電路) |
| MAX792R | Microprocessor and Non-Volatile Memory Supervisory Circuits(復位門限2.61V,微處理器和非易失存儲器監控電路) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX78615+LMU/A01 | 制造商:Maxim Integrated Products 功能描述:IC ENERGY MEAS PROC LMU TQFN |
| MAX78615+LMU/A01T | 制造商:Maxim Integrated Products 功能描述:IC ENERGY MEAS PROC LMU TQFN |
| MAX78615+PSU/A00 | 制造商:Maxim Integrated Products 功能描述:IC ENERGY MEAS PROC LMU TQFN |
| MAX78615+PSU/A00T | 制造商:Maxim Integrated Products 功能描述:ISOLATED ENERGY MEAS PROCESSOR - PSU - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC ENERGY MEAS PROC LMU TQFN 制造商:Maxim Integrated Products 功能描述:Iso Measurement Processor for PSU |
| MAX78630+PPM/D00 | 制造商:Maxim Integrated Products 功能描述:ENERGY MEAS PROCESSOR - 3-PHASE - Rail/Tube 制造商:Maxim Integrated Products 功能描述:IC ENERGY MEAS PROC LMU TQFN |
發布緊急采購，3分鐘左右您將得到回復。