參數資料
型號： MAX782SCBX
廠商： MAXIM INTEGRATED PRODUCTS INC
元件分類： 穩壓器
英文描述： Triple-Output Power-Supply Controller for Notebook Computers
中文描述： DUAL SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO36
封裝： PLASTIC, SSOP-36
文件頁數： 23/32頁
文件大?。?/td> 497K
代理商： MAX782SCBX
M
Triple-Output Power-S upply
Controller for Notebook Computers
______________________________________________________________________________________
23
The MAX782 has three comparators/level-shifters that
can be used for this purpose, and two that are needed for
each PCMCIA port. Two transistors can be used as
shown in Figure 11 to provide two additional TTL-input
MOSFET gate drivers for a second PCMCIA slot. The
component values have been carefully chosen to provide
smooth switching from 5V to 3.3V without make-before-
break glitches, and without a break in the VCC supply.
Low-V oltage (6-Cell) Operation
Low input voltages, such as the 6V end-of-life voltage of
a 6-cell NiCd battery, place extra demands on the +5V
buck regulator because of the very low input-output dif-
ferential voltage. The standard application circuit works
well with supply voltages down to 6.5V; at input voltages
less than 6.5V, some component changes are needed
(see Table 5), and the operating frequency must be set
to 200kHz. The two main issues are load-transient
response and load capability of the +15V VDD supply.
The +5V supply’s load-transient response is impaired due
to reduced inductor-current slew rate, which is in turn
caused by reduced voltage applied across the buck induc-
tor during the high-side switch-on time. So, the +5V output
sags when hit with an abrupt load current change, unless
the +5V filter capacitor value is increased. Note that only the
capacitance is affected and ESR requirements don’t
change. Therefore, the added capacitance can be sup-
plied by an additional low-cost bulk capacitor in parallel with
the normal low-ESR switching-regulator capacitor. The
equation for voltage sag under a step-load change follows:
I
STEP2
x L
V
SAG
= —————————————————
2 x C
F
x (V
IN(MIN)
x DMAX - V
OUT
)
where DMAX is the maximum duty cycle. Higher duty
cycles are possible when the oscillator frequency is
reduced to 200kHz, due to fixed propagation delays
through the PWM comparator becoming a lesser part of
the whole period. The tested worst-case limit for DMAX
is 92% at 200kHz. Lower inductance values can reduce
the filter capacitance requirement, but only at the
expense of increased noise at high input voltages (due
to higher peak currents).
The components shown in Table 5 allow the main +5V
supply to deliver 2A from V
IN
= 5.5V, or alternatively
allow the +15V supply to deliver 70mA while simultane-
ously providing +5V at 2A from V
IN
= 5.7V. Note:
Components for +3.3V don’t need to be changed.
The +15V supply’s load capability is also affected by
low input voltages, especially under heavy loads. When
the +5V supply is heavily loaded, there simply isn’t
enough extra duty cycle left for the flyback winding
controller to deliver energy to the secondary. VDD load-
current limitations are thus determined by the worst-
case duty-cycle limits, and also by any parasitic resis-
tance or inductance on the transformer secondary.
These parasitics, most notably the transformer leakage
inductance and the forward impedance of the +15V
rectifier diode, limit the rate-of-rise of current in the sec-
ondary during the brief interval when primary current
reverses and the transformer conducts in the forward
mode. See the Typical Operating Characteristics. For
low-voltage applications that require heavy +15V load
currents (for example, 6-cell circuits where +12V VPP
must deliver 120mA or more), see the MAX783 data
sheet. This device is similar to the MAX782 except the
+15V flyback winding controller has been shifted from
the +5V side to the +3.3V side.
Table 5. Components for Low-Voltage
Operation
(Circuit of Figure 1, f = 200kHz, V
IN
Range = 5.5V to 12V)
Transformer L2:
Filter Capacitor C6:
Sense Resistor:
660μF
25m
Flyback Rectifier D2:
1N5819 or equivalent
Schottky diode
Coiltronics CTX03-12062
(low-leakage inductance,
10μH primary)
PCMCIA 2.0
DIGITAL
CONTROLLER
VCC_EN0
VCC_EN1
MAX782
100
μ
F
SLOT
VCC
+5V
VDD
FB5
FB3
1M
1M
+3.3V
1M
2N3904
2N3904
510k
NOTE:
MOSFET BODY DIODES SHOWN FOR CLARITY.
Figure 11. Using Discrete Circuitry to Switch PCMCIA 2.0 Slot VCC
相關PDF資料
PDF描述
MAX789CCK 5V/3.3V/3V 5A Step-Down, PWM, Switch-Mode DC-DC Regulators
MAX726 Octal Buffers And Line Drivers With 3-State Outputs 20-CFP -55 to 125
MAX787CCK 5V/3.3V/3V 5A Step-Down, PWM, Switch-Mode DC-DC Regulators
MAX788CCK Hex Inverters With Open-Collector Outputs 14-CFP -55 to 125
MAX788ECK 5V/3.3V/3V 5A Step-Down, PWM, Switch-Mode DC-DC Regulators
相關代理商/技術參數
參數描述
MAX782SCBX-T 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
MAX782SEBX 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
MAX782SEBX-T 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
MAX783CBX 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
MAX783CBX-T 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*