- 您現在的位置：買賣IC網 > PDF目錄384688 > MAX5948 (Maxim Integrated Products, Inc.) AND-OR-invert Gates 14-CFP -55 to 125 PDF資料下載
參數資料
| 型號： | MAX5948 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | AND-OR-invert Gates 14-CFP -55 to 125 |
| 中文描述： | 的- 48V熱插拔控制器與外部檢測電阻 |
| 文件頁數： | 14/18頁 |
| 文件大?。?/td> | 685K |
| 代理商： | MAX5948 |
M
When the DRAIN voltage of the MAX5948B is high with
respect to V
EE
(Figure 12), the internal MOSFET Q3 is
turned off so that I1 and the internal MOSFET Q2 clamp
the PWRGD pin to the DRAIN pin. MOSFET Q2 sinks
the module’s pullup current, and the module turns off.
When the DRAIN voltage drops below V
PG
, MOSFET Q3
turns on, shorting I1 to V
EE
and turning Q2 off. The
pullup current in the module pulls PWRGD high,
enabling the module.
GATE Voltage Regulation
GATE goes high when the following startup conditions
are met: UV is high, OV is low, the supply voltage is
above V
UV,LH
, and (V
SENSE
- V
EE
) is less than 50mV.
GATE is pulled up with a 45μA current source and is
regulated at 13.5V above V
EE
. The MAX5948A/
MAX5948B include an internal clamp that ensures the
GATE voltage of the external MOSFET never exceeds
18V. During a fast-rising V
DD
, the clamp also keeps the
GATE and SENSE potentials as close as possible to
prevent the FET from accidentally turning on. When a
fault condition is detected, GATE is pulled low with a
50mA current.
DRAIN Pin Protection
The MAX5948’s DRAIN pin withstands negative volt-
ages (referenced to V
EE
); no external diode is required.
When the -48V backplane shorts to ground and V
EE
becomes 0V, the DRAIN pin is held at less than 1.5V
(sum of Q1’s body diode and voltage drop across R1)
below V
EE
due to the storage capacitor C3 (Figure 13).
The -1.5V results in a 50mA reverse DRAIN current,
which is within the capability of the MAX5948. A design
with R1 larger than 0.1
may require a resistor in series
with the DRAIN pin to avoid exceeding the 50mA drain
current maximum.
-48V Hot-Swap Controllers
with External R
SENSE
14
______________________________________________________________________________________
PWRGD
V
EE
V
PG
-48V
R1
R2
C1
Q1
R3
C2
MAX5948A
V
IN+
V
IN-
C4
V
OUT+
V
OUT-
ON/OFF
ACTIVE-HIGH
ENABLE MODULE
DRAIN
GATE
SENSE
V
EE
V
DD
R4
R5
R6
*
*DIODES INC. SMAT70A.
-48V RTN
-48V RTN
(SHORT PIN)
UV
OV
Q2
Figure 13. Active-Low Enable Module
相關PDF資料 |
PDF描述 |
|---|---|
| MAX5948A | -48V Hot-Swap Controllers with External RSENSE |
| MAX5948AESA | -48V Hot-Swap Controllers with External RSENSE |
| MAX5948B | 4-2-3-2 Input AND-OR-invert Gates 14-CDIP -55 to 125 |
| MAX5948BESA | -48V Hot-Swap Controllers with External RSENSE |
| MAX5949 | -48V Hot-Swap Controllers with External RSENSE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX5948AESA | 功能描述:熱插拔功率分布 RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| MAX5948AESA+ | 功能描述:熱插拔功率分布 48V- Hot-Swap Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| MAX5948AESA+T | 功能描述:熱插拔功率分布 48V- Hot-Swap Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| MAX5948AESA-T | 功能描述:熱插拔功率分布 RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| MAX5948BESA | 功能描述:熱插拔功率分布 RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。