- 您現在的位置：買賣IC網 > PDF目錄383444 > MAX5941A (Maxim Integrated Products, Inc.) IEEE 802.3af-Compliant Power-Over-Ethernet Interface/PWM Controller for Power Devices PDF資料下載
參數資料
| 型號： | MAX5941A |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | IEEE 802.3af-Compliant Power-Over-Ethernet Interface/PWM Controller for Power Devices |
| 中文描述： | 符合IEEE 802.3af標準的以太網供電接口/PWM控制器，適用于用電設備 |
| 文件頁數： | 13/24頁 |
| 文件大?。?/td> | 453K |
| 代理商： | MAX5941A |
IEEE 802.3af-Compliant Power-Over-Ethernet
Interface/PWM Controller for Power Devices
______________________________________________________________________________________
13
M
The PSE determines the class of a PD by applying a volt-
age at the PD input and measures the current sourced
out of the PSE. When the PSE applies a voltage between
12.6V and 20V, the MAX5941A/MAX5941B exhibit a cur-
rent characteristic with values indicated in Table 2. The
PSE uses the classification current information to classify
the power requirement of the PD. The classification cur-
rent includes the current drawn by the 25.5k
detection
signature resistor and the supply current of the
MAX5941A/MAX5941B so that the total current drawn by
the PD is within the IEEE 802.3af standard figures. The
classification current is turned off whenever the device is
in power mode.
Power Mode
During power mode, when V
IN
rises above the
undervoltage lockout threshold (V
UVLO,ON
), the
MAX5941A/ MAX5941B gradually turn on the internal N-
channel MOSFET Q1 (see Figure 2). The MAX5941A/
MAX5941B charge the gate of Q1 with a constant current
source (10μA, typ). The drain-to-gate capacitance of Q1
limits the voltage rise rate at the drain of MOSFET, there-
by limiting the inrush current. To reduce the inrush cur-
rent, add external drain-to-gate capacitance (see the
Inrush Current
section). When the drain of Q1 is within
1.2V of its source voltage and its gate-to-source voltage is
above 5V, the MAX5941A/MAX5941B assert the PGOOD/
PGOOD
outputs. The MAX5941A/MAX5941B have a wide
UVLO hysteresis and turn-off deglitch time to compensate
for the high impedance of the twisted-pair cable.
Undervoltage Lockout
The MAX5941A/MAX5941B operate up to a 67V supply
voltage with a default UVLO turn-on set at 39V and a
UVLO turn-off set at 30V. Adjust the UVLO threshold
using a resistor-divider connected to UVLO (see Figure
3). When the input voltage is above the UVLO threshold
(V
UVLO,ON
), the IC is in power mode and the MOSFET is
on. When the input voltage goes below the UVLO thresh-
old (V
UVLO,OFF
) for more than t
OFF_DLY
, the MOSFET
turns off.
To adjust the UVLO threshold, connect an external
resistor-divider from GND to UVLO and from UVLO to
V
EE
. Use the following equations to calculate R1 and
R2 for a desired UVLO threshold:
R1 = 25.5k
- R2
where V
IN, EX
is the desired UVLO threshold. Since the
resistor-divider replaces the 25.5k
PD detection resis-
tor, ensure that the sum of R1 and R2 equals 25.5k
±1%. When using the external resistor-divider, the
MAX5941 has an external reference voltage hysteresis of
20% (typ). In other words, when UVLO is programmed
externally, the turn-off threshold is 80% (typ) of the new
UVLO turn-on threshold.
Inrush Current Limit
The MAX5941A/MAX5941B charge the gate of the inter-
nal MOSFET with a constant current source (10μA, typ).
The drain-to-gate capacitance of the MOSFET limits the
voltage rise rate at the drain, thereby limiting the inrush
current. Add an external capacitor from GATE to OUT
to further reduce the inrush current. Use the following
equation to calculate the inrush current:
The recommended inrush current for a PoE application
is 100mA.
PGOOD/
PGOOD
Outputs
PGOOD is an open-drain, active-high logic output.
PGOOD goes high impedance when V
OUT
is within 1.2V
of V
EE
and when GATE is 5V above V
EE
. Otherwise,
PGOOD is pulled to V
OUT
(given that V
OUT
is at least 5V
below GND). Connect PGOOD to SS_
SHDN
to enable the
PWM controller. No external pullup resistor is required.
PGOOD
is an open-drain, active-low logic output.
PGOOD
is pulled to V
EE
when V
OUT
is within 1.2V of V
EE
and when GATE is 5V above V
EE
. Otherwise,
PGOOD
goes high impedance.
I
I
x
C
C
INRUSH
G
OUT
GATE
=
R
k
xV
V
REF UVLO
IN EX
,
2
25 5
=
.
,
R1
UVLO
GND
V
EE
R2
V
IN
= 24V TO 60V
MAX5941A
MAX5941B
Figure 3. Setting Undervoltage Lockout with an External
Resistor-Divider
相關PDF資料 |
PDF描述 |
|---|---|
| MAX5941 | IEEE 802.3af-Compliant Power-Over-Ethernet Interface/PWM Controller for Power Devices |
| MAX5941ACSE | ECONOLINE: RBM - New Micro Size SIP 6 Package- Industry Standard Pinout- 3kVDC Isolation- UL94V-0 Package Material- Efficiency to 85% |
| MAX5941A-MAX5941B | Octal D-Type Transparent Latches with 3-state Outputs 20-LCCC -55 to 125 |
| MAX5941AESE | Octal D-Type Transparent Latches with 3-state Outputs 20-CDIP -55 to 125 |
| MAX5941BCSE | Octal D-Type Positive Edge Triggered Flip-Flops with 3-State Outputs 20-CDIP -55 to 125 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX5941ACSE | 功能描述:電源開關 IC - POE / LAN RoHS:否 制造商:Fairchild Semiconductor 開關數量:Single 開關配置:SPST 開啟電阻（最大值）:7.3 Ohms 串話: 帶寬: 開啟時間（最大值）:13 ns 關閉時間（最大值）:20 ns 切換電壓（最大）: 工作電源電壓:8 V to 26 V 最大工作溫度:+ 125 C 安裝風格:Through Hole 封裝 / 箱體:TO-220F-6 |
| MAX5941ACSE+ | 功能描述:輸入/輸出控制器接口集成電路 IEEE 802.3af POE Int/PWM Controller RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| MAX5941ACSE+T | 功能描述:輸入/輸出控制器接口集成電路 IEEE 802.3af POE Int/PWM Controller RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| MAX5941ACSE-T | 功能描述:電源開關 IC - POE / LAN RoHS:否 制造商:Fairchild Semiconductor 開關數量:Single 開關配置:SPST 開啟電阻（最大值）:7.3 Ohms 串話: 帶寬: 開啟時間（最大值）:13 ns 關閉時間（最大值）:20 ns 切換電壓（最大）: 工作電源電壓:8 V to 26 V 最大工作溫度:+ 125 C 安裝風格:Through Hole 封裝 / 箱體:TO-220F-6 |
| MAX5941AESE | 功能描述:電源開關 IC - POE / LAN RoHS:否 制造商:Fairchild Semiconductor 開關數量:Single 開關配置:SPST 開啟電阻（最大值）:7.3 Ohms 串話: 帶寬: 開啟時間（最大值）:13 ns 關閉時間（最大值）:20 ns 切換電壓（最大）: 工作電源電壓:8 V to 26 V 最大工作溫度:+ 125 C 安裝風格:Through Hole 封裝 / 箱體:TO-220F-6 |
發布緊急采購，3分鐘左右您將得到回復。