- 您現在的位置：買賣IC網 > PDF目錄385530 > MAX458 (MAXIM INTEGRATED PRODUCTS INC) 8x4 Video Crosspoint Switches with Buffers(8*4,100MHz,具緩沖器,交叉視頻開關矩陣) PDF資料下載
參數資料
| 型號： | MAX458 |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 運動控制電子 |
| 英文描述： | 8x4 Video Crosspoint Switches with Buffers(8*4,100MHz,具緩沖器,交叉視頻開關矩陣) |
| 中文描述： | 8-CHANNEL, CROSS POINT SWITCH |
| 文件頁數： | 10/16頁 |
| 文件大?。?/td> | 185K |
| 代理商： | MAX458 |
M
8x4 Video Crosspoint S witc hes with Buffers
10
______________________________________________________________________________________
to their switch registers. As long as either –W—–or –—is
high, the input register will not change. The switch reg-
ister will pass any new data on the falling transition of
Each register of the switch-register bank controls the
registers are transparent and switch connection is con-
high, the switch register is latched and any change in
data by the input register will not affect the amplifier
output state. Two register banks are used so that data
can be loaded into input registers without affecting the
switch/amplifier selection. This allows amplifiers to be
programmed and then changed simultaneously. When
the registers are not latched, they are made transparent.
Use data bit D3 to disable the amplifier selected by
A0–A1 and place its output in high-impedance mode.
As an example, the code to disable OUT0 is as follows:
Pin Name: D3 D2 D1 D0 A1 A0
Input Code: 1 X X X 0 0
When operating in parallel mode, C—must be wired high
and SCLK and DIN should be grounded, as shown in
Figure 3. Refer to Figure 4 for the correct timing rela-
tionships.
Digital S ec tion—S erial Mode
The MAX458/MAX459 use a three-wire serial interface
that is compatible with SPI, QPSI and Microwire inter-
faces. Serial mode, shown in Figure 5, is enabled
low. Figures 6 and 7 show serial-mode timing. Figure 8
shows the MAX458/MAX459 configured for serial oper-
ation. Figure 9 shows the Microwire connection, and
Figure 10 shows the SPI/QSPI connection.
The serial output, DOUT, allows cascading of two or
more crosspoint switches to create larger arrays. The
data at DOUT is delayed by 16 cycles plus one clock
pulse width at DIN. DOUT changes on SCLK’s falling
in the state of the last data bit.
The MAX458/MAX459 input data in 16-bit blocks. SPI
and Microwire interfaces output data in 8-bit blocks,
thereby requiring two write cycles to input data. The
QSPI interface allows variable word lengths from 8 to 16
bits and can be loaded into the crosspoint in one write
cycle. SPI and Microwire limit clock rates to 2MHz, while
the QSPI maximum clock rate is 4MHz.
ADDRESS VALID
A0/A1
CE
WR
UPDATE
t
ADS
t
CES
t
WR
t
CEH
t
DS
t
ADH
DATA VALID
D0–D3
t
DH
t
WRS
t
UP
t
UPS
Figure 4. Parallel-Mode Timing
相關PDF資料 |
PDF描述 |
|---|---|
| MAX459 | 8x4 Video Crosspoint Switches with Buffers(8*4,90MHz,帶AV=2V/V輸出緩沖器,交叉視頻開關矩陣) |
| MAX4610ASD | Low-Voltage, Quad, SPST CMOS Analog Switches |
| MAX4611ASD | Low-Voltage, Quad, SPST CMOS Analog Switches |
| MAX4611AUD | Low-Voltage, Quad, SPST CMOS Analog Switches |
| MAX4612ASD | Low-Voltage, Quad, SPST CMOS Analog Switches |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX4580CAE | 功能描述:模擬開關 IC RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX4580CAE+ | 功能描述:模擬開關 IC 1.25Ohm Dual SPST Analog Switch RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX4580CAE+T | 功能描述:模擬開關 IC 1.25Ohm Dual SPST Analog Switch RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX4580CAE-T | 功能描述:模擬開關 IC RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX4580CPE | 功能描述:模擬開關 IC RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
發布緊急采購，3分鐘左右您將得到回復。