- 您現在的位置：買賣IC網 > PDF目錄383410 > MAX4560 (Maxim Integrated Products, Inc.) 【15kV ESD-Protected, Low-Voltage, CMOS Analog Multiplexers/Switches PDF資料下載
參數資料
| 型號： | MAX4560 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | 【15kV ESD-Protected, Low-Voltage, CMOS Analog Multiplexers/Switches |
| 中文描述： | ±15kV ESD保護、低電壓、CMOS模擬多路復用器開關 |
| 文件頁數： | 10/16頁 |
| 文件大小： | 305K |
| 代理商： | MAX4560 |
M
ES D T est Conditions
ESD performance depends on several conditions.
Contact Maxim for a reliability report that documents
test setup, methodology, and results.
Human Body Model
Figure 6 shows the Human Body Model, and Figure 7
shows the current waveform it generates when dis-
charged into a low impedance. This model consists of
a 100pF capacitor charged to the ESD voltage of inter-
est, which is then discharged into the test device
through a 1.5k
resistor.
Power-S upply Considerations
The MAX4558/MAX4559/MAX4560 are typical of most
CMOS analog switches. They have three supply pins:
V
CC
, V
EE
, and GND. V
CC
and V
EE
drive the internal
CMOS switches and set the limits of the analog voltage
on every switch. Internal reverse ESD-protection diodes
connect between each analog signal pin and both V
CC
and V
EE
. If any analog signal exceeds V
CC
or V
EE
, one
of these diodes conducts. The only currents drawn
from V
CC
or V
EE
during normal operation are the leak-
age currents of these ESD diodes.
Although the ESD diodes on a given signal pin are
identical and therefore fairly well balanced, they are
reverse biased differently. Each is biased by either V
CC
or V
EE
and the analog signal. Their leakage currents
vary as the signal varies. The difference in the two
diode leakages to the V
CC
and V
EE
pins constitutes the
analog signal-path leakage current. All analog leakage
current flows between each input and one of the supply
terminals, not to the other switch terminal. This is why
both sides of a given switch can show leakage currents
of either the same or opposite polarity.
V
CC
and GND power the internal logic and logic-level
translators, and set the input logic limits. The logic-level
translators convert the logic levels into switched V
CC
and V
EE
signals to drive the gates of the analog switch.
This drive signal is the only connection between the
logic supplies and logic signals and the analog sup-
plies. V
CC
and V
EE
have ESD-protection diodes to
GND.
The logic-level thresholds are TTL/CMOS compatible
when V
CC
is +5V. As V
CC
rises, the threshold increases
slightly. When V
CC
reaches +12V, the threshold is
about 3.1V (above the TTL-guaranteed high-level mini-
mum of 2.4V, but still compatible with CMOS outputs).
High-Frequenc y Performanc e
In 50
systems, signal response is reasonably flat up
to 50MHz (see Typical Operating Characteristics).
Above 20MHz, the on response has several minor
peaks that are highly layout dependent. The problem is
not turning the switch on, but turning it off. The off-state
switch acts like a capacitor and passes higher frequen-
cies with less attenuation. At 1MHz, off-isolation is
about -68dB in 50
systems, becoming worse (approx-
imately 20dB per decade) as the frequency increases.
Higher circuit impedance also degrades off-isolation.
Adjacent channel attenuation is about 3dB above that
of a bare IC socket and is entirely due to capacitive
coupling.
±15kV ES D-Protec ted, Low-Voltage, CMOS
Analog Multiplexers/S witc hes
10
______________________________________________________________________________________
相關PDF資料 |
PDF描述 |
|---|---|
| MAX4560CEE | 【15kV ESD-Protected, Low-Voltage, CMOS Analog Multiplexers/Switches |
| MAX4560CPE | 【15kV ESD-Protected, Low-Voltage, CMOS Analog Multiplexers/Switches |
| MAX4560CSE | 【15kV ESD-Protected, Low-Voltage, CMOS Analog Multiplexers/Switches |
| MAX4560EEE | 8-Bit Microcontroller 68-PLCC |
| MAX4560EPE | 【15kV ESD-Protected, Low-Voltage, CMOS Analog Multiplexers/Switches |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX4560C/D | 功能描述:模擬開關 IC Low-Voltage CMOS Analog Multiplexers/Switches with +-15kV ESD Protection RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX4560CEE | 功能描述:模擬開關 IC RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX4560CEE+ | 功能描述:模擬開關 IC 3Ch SPDT Low V Analog Switch RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX4560CEE+T | 功能描述:模擬開關 IC 3Ch SPDT Low V Analog Switch RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX4560CEE-T | 功能描述:模擬開關 IC RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
發布緊急采購，3分鐘左右您將得到回復。