- 您現在的位置：買賣IC網 > PDF目錄2158 > MAX4451ESA+T (Maxim Integrated Products)IC OP AMP R-R DUAL 210MHZ 8-SOIC PDF資料下載
參數資料
| 型號： | MAX4451ESA+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 14/15頁 |
| 文件大小： | 0K |
| 描述： | IC OP AMP R-R DUAL 210MHZ 8-SOIC |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,500 |
| 放大器類型： | 電壓反饋 |
| 電路數： | 2 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 485 V/µs |
| -3db帶寬： | 210MHz |
| 電流 - 輸入偏壓： | 6.5µA |
| 電壓 - 輸入偏移： | 4000µV |
| 電流 - 電源： | 6.5mA |
| 電流 - 輸出 / 通道： | 70mA |
| 電壓 - 電源，單路/雙路(±)： | 4.5 V ~ 11 V，±2.25 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁
Note: RL = RO + RTO; RTIN and RTO are calculated for 50
Ω applications. For 75Ω systems, RTO = 75Ω; calculate RTIN from the
following equation:
0.1F capacitor as close to the pin as possible. If operat-
ing with dual supplies, bypass each supply with a 0.1F
capacitor.
Maxim recommends using microstrip and stripline tech-
niques to obtain full bandwidth. To ensure that the PC
board does not degrade the amplifier’s performance,
design it for a frequency greater than 1GHz. Pay care-
ful attention to inputs and outputs to avoid large para-
sitic capacitance. Whether or not you use a constant-
impedance board, observe the following design guide-
lines:
Don’t use wire-wrap boards; they are too inductive.
Don’t use IC sockets; they increase parasitic capaci-
tance and inductance.
Use surface-mount instead of through-hole compo-
nents for better high-frequency performance.
Use a PC board with at least two layers; it should be
as free from voids as possible.
Keep signal lines as short and as straight as possi-
ble. Do not make 90° turns; round all corners.
Rail-to-Rail Outputs,
Ground-Sensing Input
The input common-mode range extends from
(VEE - 200mV) to (VCC - 2.25V) with excellent common-
mode rejection. Beyond this range, the amplifier output
is a nonlinear function of the input, but does not under-
go phase reversal or latchup.
The output swings to within 55mV of either power-
supply rail with a 2k
Ω load. The input ground sensing
and the rail-to-rail output substantially increase the
dynamic range. With a symmetric input in a single +5V
application, the input can swing 2.95VP-P and the out-
put can swing 4.9VP-P with minimal distortion.
Output Capacitive Loading and Stability
The MAX4450/MAX4451 are optimized for AC perfor-
mance. They are not designed to drive highly reactive
loads, which decrease phase margin and may produce
excessive ringing and oscillation. Figure 2 shows a cir-
cuit that eliminates this problem. Figure 3 is a graph of
the optimal isolation resistor (RS) vs. capacitive load.
Figure 4 shows how a capacitive load causes exces-
sive peaking of the amplifier’s frequency response if
the capacitor is not isolated from the amplifier by a
resistor. A small isolation resistor (usually 20
Ω to 30Ω)
placed before the reactive load prevents ringing and
oscillation. At higher capacitive loads, AC performance
is controlled by the interaction of the load capacitance
and the isolation resistor. Figure 5 shows the effect of a
27
Ω isolation resistor on closed-loop response.
Coaxial cable and other transmission lines are easily
driven when properly terminated at both ends with their
characteristic impedance. Driving back-terminated
transmission lines essentially eliminates the line’s
capacitance.
Table 1. Recommended Component Values
MAX4450/MAX4451
Ultra-Small, Low-Cost, 210MHz, Single-Supply
Op Amps with Rail-to-Rail Outputs
8
_______________________________________________________________________________________
-25
+25
-10
+10
-5
+5
-2
+2
-1
+1
49.9
10
∞
0
50
1200
GAIN (V/V)
49.9
5
49.9
—
20
500
49.9
15
∞
0
50
500
49.9
11
49.9
—
56
500
49.9
25
100
0
100
500
49.9
25
49.9
—
124
500
49.9
50
62
0
250
500
49.9
95
49.9
—
500
49.9
RTO (
Ω)
100
210
Small-Signal -3dB Bandwidth (MHz)
56
49.9
RTIN (
Ω)
0
—
RS (
Ω)
COMPONENT
500
∞
RG (
Ω)
500
24
RF (
Ω)
R
=
75
1-
75
R
TIN
G
Ω
相關PDF資料 |
PDF描述 |
|---|---|
| MAX4454ESD+T | IC OPAMP SNGL R-R OUT 14-SOIC |
| MAX4460EUT#TG16 | IC INSTR AMP SGL R-R SOT-23-6 |
| MAX4472EUD+T | IC OP AMP QUAD R-R 9KHZ 14-TSSOP |
| MAX4475AUT#TG16 | IC OP AMP R-R LN 10MHZ SOT23-6 |
| MAX4483AUD+ | IC OP AMP GP QUAD R-R 14-TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX4452ESA | 制造商:Maxim Integrated Products 功能描述:SC70, LOW-COST, ULTRA-LOW-POWER, +3V/+5V, 200 - Rail/Tube |
| MAX4452ESA+ | 制造商:Maxim Integrated Products 功能描述:OP AMP SGL GP R-R O/P 5.25V 8SOIC N - Rail/Tube |
| MAX4452ESA+T | 制造商:Maxim Integrated Products 功能描述:OP AMP SGL GP R-R O/P 5.25V 8SOIC N - Tape and Reel |
| MAX4452ESA-T | 制造商:Maxim Integrated Products 功能描述:SC70, LOW-COST, ULTRA-LOW-POWER, +3V/+5V, 200 - Tape and Reel |
| MAX4452EUK | 制造商:Maxim Integrated Products 功能描述:SC70 LOW-COST ULTRA-LOW-POWER +3 - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。