- 您現在的位置：買賣IC網 > PDF目錄383402 > MAX442EPA (MAXIM INTEGRATED PRODUCTS INC) 3V Full-Duplex RS-485 driver and receiver 14-SOIC -40 to 85 PDF資料下載
參數資料
| 型號： | MAX442EPA |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 運動控制電子 |
| 英文描述： | 3V Full-Duplex RS-485 driver and receiver 14-SOIC -40 to 85 |
| 中文描述： | 2-CHANNEL, VIDEO MULTIPLEXER, PDIP8 |
| 封裝： | 0.300 INCH, PLASTIC, DIP-8 |
| 文件頁數： | 6/8頁 |
| 文件大?。?/td> | 93K |
| 代理商： | MAX442EPA |
M
The Typical Operating Circuit shows the MAX442 dri-
ving a back-terminated 75
video cable. The back-ter-
mination resistor (at the MAX442 output) is included to
match the impedance of the cable’s driven end to the
characteristic impedance of the cable itself. This, plus
the load-termination resistor, eliminates signal reflec-
tions from the cable’s ends. The back-termination resis-
tor forms a voltage divider with the load impedance,
which attenuates the signal at the cable output by one-
half. The amplifier is operated with a 2V/V closed-loop
gain to provide unity gain at the cable’s video output.
Capac itive-Load Driving
Driving large capacitive loads increases the likelihood
of oscillation in most amplifier circuits. This is especial-
ly true for circuits with high loop gains, like voltage fol-
lowers. The amplifier’s output impedance and the
capacitive load form an RC filter that adds a pole to the
loop response. If the pole frequency is low enough, as
when driving a large capacitive load, the circuit phase
margin is degraded and oscillation may occur.
With capacitive loads greater than approximately 50pF
and the MAX442 configured as a unity-gain buffer, use
an isolation resistor in series with the load, as shown in
Figure 2. The resistor removes the pole from the loop
response caused by the load capacitance.
Channel S witc hing T ime/T ransient
When the MAX442 multiplexer is switched from one
channel to another, a small glitch will appear at the out-
put. Figure 3 shows the results of putting a 0V to 5V
pulse 100ns wide into A0.
140MHz, 2-Channel
Video Multiplexer/Amplifier
6
_______________________________________________________________________________________
MAX442
22
C
LOAD
> 50pF
OUT
IN
Figure 2. Capacitive-Load-Driving Circuit
A0 INPUT
5V/div
AMP
OUTPUT
200mV/div
GND
GND
Figure 3. Output Switching Transient when Switching Between
Two Grounded Inputs with R
L
= 100
INPUT
1V/V
CABLE
OUTPUT
1V/V
GND
GND
Figure 5. Pulse Response with R
L
= 100
(50
back-terminated
cable), A
VCL
= +2V/V
INPUT
1V/div
CABLE
OUTPUT
500mV/div
GND
GND
Figure 4. Pulse Response with R
L
= 100
(50
back-terminated
cable), A
VCL
= +1V/V
相關PDF資料 |
PDF描述 |
|---|---|
| MAX442ESA | 3V Full-Duplex RS-485 driver and receiver 14-SOIC -40 to 85 |
| MAX4450EXK-T | Ultra-Small, Low-Cost, 210MHz, Single-Supply Op Amps with Rail-to-Rail Outputs |
| MAX4450-MAX4451 | Ultra-Small, Low-Cost, 210MHz, Single-Supply Op Amps with Rail-to-Rail Outputs |
| MAX4451EKA-T | Ultra-Small, Low-Cost, 210MHz, Single-Supply Op Amps with Rail-to-Rail Outputs |
| MAX4451 | Ultra-Small, Low-Cost, 210MHz, Single-Supply Op Amps with Rail-to-Rail Outputs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX442ESA-T | 功能描述:多路器開關 IC RoHS:否 制造商:Maxim Integrated 通道數量: 開關數量: 開啟電阻（最大值）: 開啟時間（最大值）: 關閉時間（最大值）: 傳播延遲時間: 工作電源電壓:+/- 5 V 工作電源電流:30 mA 最大工作溫度:+ 85 C 安裝風格: 封裝 / 箱體: |
| MAX4430ESA | 功能描述:運算放大器 - 運放 Dual-Supply 180MHz 16-Bit Accurate RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MAX4430ESA+ | 功能描述:運算放大器 - 運放 Dual-Supply 180MHz 16-Bit Accurate RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MAX4430ESA+T | 功能描述:運算放大器 - 運放 Dual-Supply 180MHz 16-Bit Accurate RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MAX4430ESA-T | 功能描述:運算放大器 - 運放 Dual-Supply 180MHz 16-Bit Accurate RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。