- 您現在的位置：買賣IC網 > PDF目錄383398 > MAX4315EEE (MAXIM INTEGRATED PRODUCTS INC) High-Speed, Low-Power, Single-Supply, Multichannel, Video Multiplexer-Amplifiers PDF資料下載
參數資料
| 型號： | MAX4315EEE |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 運動控制電子 |
| 英文描述： | High-Speed, Low-Power, Single-Supply, Multichannel, Video Multiplexer-Amplifiers |
| 中文描述： | 8-CHANNEL, VIDEO MULTIPLEXER, PDSO16 |
| 封裝： | 0.150 INCH, QSOP-16 |
| 文件頁數： | 12/20頁 |
| 文件大小： | 404K |
| 代理商： | MAX4315EEE |
M
High-S peed, Low-Power, S ingle-S upply,
Multic hannel, Video Multiplexer-Amplifiers
12
______________________________________________________________________________________
_______________Detailed Desc ription
The MAX4310/MAX4311/MAX4312 combine 2-channel,
4-channel, or 8-channel multiplexers, respectively, with
an adjustable-gain output amplifier optimized for
closed-loop gains of +1V/V (0dB) or greater. The
MAX4313/MAX4314/MAX4315 combine 2-channel, 4-
channel, or 8-channel multiplexers, respectively, with a
+2V/V (6dB) fixed-gain amplifier, optimized for driving
back-terminated cables. These devices operate from a
single supply voltage of +4V to +10.5V, or from dual
supplies of ±2V to ±5.25V. The outputs may be placed
in a high-impedance state and the supply current mini-
mized by forcing the
SHDN
pin low. The input multi-
plexers feature short 40ns channel-switching times and
small 10mVp-p switching transients. The input capaci-
tance remains constant at 1pF whether the channel is
on or off, providing a predictable input impedance to
the signal source. These devices feature single-supply,
rail-to-rail, voltage-feedback output amplifiers that
achieve up to 540V/μs slew rates and up to 345MHz -3dB
bandwidths. These devices also feature excellent har-
monic distortion and differential gain/phase perfor-
mance.
__________Applic ations Information
Rail-to-Rail Outputs, Ground-S ensing Input
The input common-mode range extends from the nega-
tive supply rail to V
CC
- 2.7V with excellent common-
mode rejection. Beyond this range, multiplexer
switching times may increase and the amplifier output
is a nonlinear function of the input, but does not under-
go phase reversal or latchup.
The output swings to within 250mV of V
CC
and 40mV of
V
EE
with a 10k
load. With a 150
load to ground, the
output swings from 30mV above V
EE
to within 730mV of
the supply rail. Local feedback around the output stage
ensures low open-loop output impedance to reduce
gain sensitivity to load variations. This feedback also
produces demand-driven bias current to the output
transistors for ±95mA drive capability while constrain-
ing total supply current to only 6.1mA.
Feedbac k and Gain Resistor S elec tion
(MAX 4310/MAX 4311/MAX 4312)
Select the MAX4310/MAX4311/MAX4312 gain-setting
feedback (R
F
) and input (R
G
) resistors to fit your applica-
tion. Large resistor values increase voltage noise and
interact with the amplifier’s input and PC board capaci-
tance. This can generate undesirable poles and zeros,
and can decrease bandwidth or cause oscillations. For
example, a noninverting gain of +2V/V configuration (R
F
= R
G
) using 1k
resistors, combined with 2pF of input
capacitance and 1pF of PC board capacitance, causes
a pole at 159MHz. Since this pole is within the amplifier
bandwidth, it jeopardizes stability. Reducing the 1k
resistors to 100
extends the pole frequency to
1.59GHz, but could limit output swing by adding 200
in
parallel with the amplifier’s load resistor.
Table 1 shows suggested R
F
and R
G
values for the
MAX4310/MAX4311/MAX4312 when operating in the
noninverting configuration (shown in Figure 1). These
values provide optimal AC response using surface-
mount resistors and good layout techniques, as dis-
cussed in the Layout and Power-Supply Bypassing
section.
Stray capacitance at the FB pin causes feedback resis-
tor decoupling and produces peaking in the frequency-
response curve. Keep the capacitance at FB as low as
possible by using surface-mount resistors and by
avoiding the use of a ground plane beneath or beside
these resistors and the FB pin. Some capacitance is
unavoidable; if necessary, its effects can be neutralized
by adjusting R
F
. Use 1% resistors to maintain consis-
tency over a wide range of production lots.
MAX4310
R
T
75
8
OUT
7
FB
IN0
IN1
A0
4
5
1
R
T
75
R
G
R
F
75
CABLE
R
T
75
R
T
75
75
CABLE
75
CABLE
Figure 1. MAX4310 Noninverting Gain Configuration
Table 1. Bandwidth and Gain with
Suggested Gain-Setting Resistors
(MAX4310/MAX4311/MAX4312)
GAIN
(V/V)
GAIN
(dB)
R
F
(
)
R
G
(
)
-3dB BW
(MHz)
0.1dB BW
(MHz)
80
20
10
280
500
120
56
∞
500
500
500
0
6
0
1
2
5
14
20
4
2
10
30
60
相關PDF資料 |
PDF描述 |
|---|---|
| MAX4315ESE | High-Speed, Low-Power, Single-Supply, Multichannel, Video Multiplexer-Amplifiers |
| MAX4310 | High-Speed, Low-Power, Single-Supply, Multichannel, Video Multiplexer-Amplifiers |
| MAX4310-MAX4315 | High-Speed, Low-Power, Single-Supply, Multichannel, Video Multiplexer-Amplifiers |
| MAX4311 | High-Speed, Low-Power, Single-Supply, Multichannel, Video Multiplexer-Amplifiers |
| MAX4311EEE | High-Speed, Low-Power, Single-Supply, Multichannel, Video Multiplexer-Amplifiers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX4315EEE+ | 功能描述:視頻放大器 MultiCh Video MUX-Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX4315EEE+T | 功能描述:視頻放大器 MultiCh Video MUX-Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX4315EEE-T | 功能描述:視頻放大器 RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX4315ESE | 功能描述:視頻放大器 Integrated Circuits (ICs) RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX4315ESE+ | 功能描述:視頻放大器 MultiCh Video MUX-Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。