- 您現在的位置：買賣IC網 > PDF目錄385529 > MAX4299EWP (MAXIM INTEGRATED PRODUCTS INC) Ultra-High PSRR Stereo Drivers + Microphone Amp + 100mA Linear Regulator PDF資料下載
參數資料
| 型號： | MAX4299EWP |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 消費家電 |
| 英文描述： | Ultra-High PSRR Stereo Drivers + Microphone Amp + 100mA Linear Regulator |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PDSO20 |
| 封裝： | 0.300 INCH, MS-013AC, SOIC-20 |
| 文件頁數： | 9/14頁 |
| 文件大?。?/td> | 311K |
| 代理商： | MAX4299EWP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁
M
Ultra-High PS RR S tereo Drivers +
Mic rophone Amp + 100mA Linear Regulator
_______________________________________________________________________________________
9
Regulator (MAX 4299)
The MAX4299 also has an additional 100mA low-
dropout (LDO) regulator to provide clean analog power
for other sensitive analog circuitry on the PC board,
such as a typical PC99 audio codec or microphone
biasing. It is designed to provide good AC line regula-
tion. The nominal output voltage of REG is 3.3V, and is
adjustable between 1.2V and 4.5V by connecting a
resistor-divider from REG to GND. Connect FB to the
junction of the resistor-divider. The input impedance at
FB is typically 7k
, which should be considered in out-
put voltage calculations. REG should be bypassed to
GND with at least 10μF.
Applications Information
Capacitor Selection and
Regulator Stability
Normally, use a 10μF capacitor on REG (MAX4299 only)
and a 1μF capacitor on C
BYPASS
. Larger capacitor val-
ues and lower ESRs provide better supply-noise rejec-
tion and line-transient response. Reduce noise and
improve load-transient response, stability, and power-
supply rejection by using larger capacitors. For stable
operation over the full temperature range and load cur-
rents up to 100mA, a minimum of 10μF (REG) and 1μF
(C
BYPASS
) is recommended.
Use a 1μF bypass capacitor on BIAS to ensure a fully
clickless/popless power-up sequence. Smaller capacitor
values may be used here to decrease the power-up
time, but may cause the power-up transient to become
audible. Larger bypass capacitors are not necessary to
reduce noise and/or improve AC power-supply rejection.
SV
CC
is the standby power supply. If using an external
diode for charging, a 220μF reservoir capacitor on
SV
CC
provides standby power for the clickless power-
down sequence. Smaller capacitors here may cause an
audible output transient on power-down; 220μF or high-
er provides enough energy when C
BIAS
= 1μF. For larg-
er values of C
BIAS
, increase the reservoir capacitor
accordingly.
Mic Biasing (MAX 4299)
Common microphone elements require resistive biasing
to power their internal circuitry. A 2k
resistor is typical-
ly used, and the microphone is AC-coupled to the
microphone amplifier. If the microphone element allows
low-voltage operation, biasing to the REG output pro-
vides excellent power-supply rejection.
Power S upply and Bypassing
The excellent PSRR of the MAX4298/MAX4299 allows
them to operate from noisy power supplies. In most
applications, a 0.1μF capacitor from V
CC
to GND is suf-
ficient. This bypass capacitor should be placed close
to the V
CC
pin.
Layout
Good layout improves performance by decreasing the
amount of stray capacitance and noise at the power
amplifier
’
s inputs and output. To decrease stray capaci-
tance, minimize PC board trace lengths and resistor
leads, and place external components as close to the
pins as possible.
Power Dissipation
The first equation below indicates the maximum power
dissipation point for a package that has two power
amplifiers operating at identical known supply voltages
and loads with sine wave inputs:
P
IC(DISS)
= (V
CC
)
2
/ (
π
2
R
L
) [W]
For example, with a 5V power supply and a load of 16
,
the maximum power dissipation of the amplifiers alone
is 317mW.
The additional power dissipation due to the 100mA reg-
ulator operating at maximum current is nominally
170mW, but will increase if the output is reduced exter-
nally from its nominal 3.3V. The regulator power con-
sumption is given by:
P
REG
= (V
CC
- V
REG
) x 100mA [W]
To avoid thermal shutdown the sum of the regulator and
amplifier power dissipation must not exceed the absolute
maximum power-dissipation rating of the package.
Short-Circuit Protection and
Thermal Shutdown
The MAX4298/MAX4299 have short-circuit current pro-
tection on all outputs. They also have a thermal shut-
down function designed to protect the chip from junction
temperatures in excess of +150
°
C that may arise from
temporary short circuits or operation beyond the power
dissipation limit of the package. The driver amplifier out-
puts limit at around ±220mA, the regulator at 150mA,
and the microphone amplifier at +1.5mA/-12mA.
USB Applications
Universal serial bus (USB) interfaces are an increasingly
popular method of interfacing medium-speed (up to
12Mbps) PC peripherals. One of the great benefits of
the USB interface is the inclusion of a +5V supply. While
this supply works well for a mouse or keyboard, its sus-
ceptibility for noise pickup can be unsuitable for high-
fidelity audio applications. The MAX4298/MAX4299s
’
excellent PSRR make them ideal candidates for USB
applications due to their insensitivity to the supply noise.
Of particular interest is an Internet-Protocol (IP) phone.
This PC peripheral uses the local internet service
provider as a free long-distance phone. The MAX4299,
with its integral microphone amp, headphone driver,
and linear regulator, can be a key element in the imple-
mentation of an IP phone that interfaces to the PC
through the USB.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX4304 | 740MHz, Low-Noise, Low-Distortion Op Amps in SOT23-5 |
| MAX4305 | 740MHz, Low-Noise, Low-Distortion Op Amps in SOT23-5 |
| MAX4309 | 400MHz, Ultra-Low-Distortion Op Amps(400MHz,高速,超低失真雙電源/射頻運放) |
| MAX4350 | Ultra-Small, Low-Cost, 210MHz, Dual-Supply Op Amps with Rail-to-Rail Outputs |
| MAX4356ECD | 16x16 Nonblocking Video Crosspoint Switch with On-Screen Display Insertion and I/O Buffers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX4299EWP+ | 功能描述:音頻放大器 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX4299EWP+T | 功能描述:音頻放大器 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX4299EWP-T | 功能描述:音頻放大器 RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX4300 | 制造商:MAXIM 功能描述:SEMICONDUCTOR |
| MAX4304ESA | 功能描述:運算放大器 - 運放 740MHz Low-Noise ow-Distortion RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。