參數資料
型號: MAX349EAP
廠商: MAXIM INTEGRATED PRODUCTS INC
元件分類: 運動控制電子
英文描述: Serially Controlled, Low-Voltage, 8-Channel/Dual 4-Channel Multiplexers
中文描述: 8-CHANNEL, SGL ENDED MULTIPLEXER, PDSO20
封裝: 5.30 MM, 0.65 MM PITCH, SSOP-20
文件頁數: 16/20頁
文件大?。?/td> 301K
代理商: MAX349EAP
M
S erially Controlled, Low-Voltage,
8-Channel/Dual 4-Channel Multiplexers
16
______________________________________________________________________________________
SCLK
DIN
DOUT
CS
SK
SO
SI
I/O
MICROWIRE
PORT
MAX349
MAX350
THE DOUT-SI CONNECTION IS NOT REQUIRED FOR WRITING TOTHE
MAX349/MAX350, BUT MAY BE USED FOR DATA-ECHOPURPOSES.
Figure 3. Connections for MICROWIRE
DOUT
DIN
SCLK
CS
MISO
MOSI
SCK
I/O
SPI
PORT
MAX349
MAX350
THE DOUT-MISOCONNECTION IS NOT REQUIRED FOR WRITING TOTHE
MAX349/MAX350, BUT MAY BE USED FOR DATA-ECHOPURPOSES.
CPOL = 0, CPHA = 0
Figure 4. Connections for SPI and QSPI
SCLK
DIN
CS
MAX349
MAX350
SCLK
DIN
CS
MAX349
MAX350
SCLK
DIN
CS
MAX349
MAX350
DOUT
DOUT
DOUT
SCLK
DIN
CS
TOOTHER
SERIAL DEVICES
Figure 5. Daisy-Chained Connection
Dual, Differential 4-Channel Multiplexer
The MAX350 can be programmed normally, with only
one differential channel selected for every eight clock
pulses, or it can be programmed in a fast mode, where
channel changing occurs on each clock pulse.
In fast mode, select the channels by sending two high
pulses, spaced four clock pulses apart (corresponding
to the two selected channels) at DIN, and a corre-
sponding CS low pulse for each of the first eight clock
pulses. As SCLK clocks this through the register, each
switch sequences one differential channel at a time,
starting with channel 0. Repeat this process for subse-
quent channel sequencing after the first eight bits have
been sent. For even faster channel sequencing, send
only one DIN high pulse and one CS low pulse for
every four clock pulses.
Reset Func tion
RESET is the internal reset pin. It is usually connected
to a logic signal or V+. Drive RESET low to open all
switches and set the contents of the internal shift regis-
ter to zero simultaneously. When RESET is high, the
part functions normally and DOUT is sourced from V+.
RESET must not be driven beyond V+ or GND.
相關PDF資料
PDF描述
MAX349EWN KJA SERIES III
MAX3510EEP Upstream CATV Amplifier
MAX3510 2X2 1.5 Gbps LVDS Crosspoint Switch 16-SOIC -40 to 85
MAX352EJE Precision, Quad, SPST Analog Switches
MAX351EJE Precision, Quad, SPST Analog Switches
相關代理商/技術參數
參數描述
MAX349EAP+ 功能描述:多路器開關 IC 8:1 Low Voltage MUX RoHS:否 制造商:Texas Instruments 通道數量:1 開關數量:4 開啟電阻(最大值):7 Ohms 開啟時間(最大值): 關閉時間(最大值): 傳播延遲時間:0.25 ns 工作電源電壓:2.3 V to 3.6 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UQFN-16
MAX349EAP+T 功能描述:多路器開關 IC 8:1 Low Voltage MUX RoHS:否 制造商:Texas Instruments 通道數量:1 開關數量:4 開啟電阻(最大值):7 Ohms 開啟時間(最大值): 關閉時間(最大值): 傳播延遲時間:0.25 ns 工作電源電壓:2.3 V to 3.6 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UQFN-16
MAX349EAP-T 功能描述:多路器開關 IC RoHS:否 制造商:Texas Instruments 通道數量:1 開關數量:4 開啟電阻(最大值):7 Ohms 開啟時間(最大值): 關閉時間(最大值): 傳播延遲時間:0.25 ns 工作電源電壓:2.3 V to 3.6 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UQFN-16
MAX349EPN 功能描述:多路器開關 IC RoHS:否 制造商:Texas Instruments 通道數量:1 開關數量:4 開啟電阻(最大值):7 Ohms 開啟時間(最大值): 關閉時間(最大值): 傳播延遲時間:0.25 ns 工作電源電壓:2.3 V to 3.6 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UQFN-16
MAX349EPN+ 功能描述:多路器開關 IC 8:1 Low Voltage MUX RoHS:否 制造商:Texas Instruments 通道數量:1 開關數量:4 開啟電阻(最大值):7 Ohms 開啟時間(最大值): 關閉時間(最大值): 傳播延遲時間:0.25 ns 工作電源電壓:2.3 V to 3.6 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UQFN-16