- 您現在的位置：買賣IC網 > PDF目錄383366 > MAX3389EEUG (MAXIM INTEGRATED PRODUCTS INC) 2.5V, 【15kV ESD-Protected RS-232 Transceivers for PDAs and Cell Phones PDF資料下載
參數資料
| 型號： | MAX3389EEUG |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 通用總線功能 |
| 英文描述： | 2.5V, 【15kV ESD-Protected RS-232 Transceivers for PDAs and Cell Phones |
| 中文描述： | DUAL LINE TRANSCEIVER, PDSO24 |
| 封裝： | 4.40 MM, 0.65 MM PITCH, MO-153AE, TSSOP-24 |
| 文件頁數： | 8/11頁 |
| 文件大?。?/td> | 276K |
| 代理商： | MAX3389EEUG |
The Air-Gap test involves approaching the device with a
charged probe. The contact discharge method connects
the probe to the device before the probe is energized.
Machine Model
The Machine Model for ESD tests all pins using a
200pF storage capacitor and zero discharge resis-
tance. Its objective is to emulate the stress caused by
contact that occurs with handling and assembly during
manufacturing. All pins require this protection during
manufacturing, not just RS-232 inputs and outputs.
Therefore, after PC board assembly, the Machine
Model is less relevant to I/O ports.
__________Applications Information
Capacitor Selection
The capacitor type used for C1
–
C4 is not critical for
proper operation; polarized or nonpolarized capacitors
can be used. The charge pump requires 0.1μF capacitors
for 2.5V operation (Table 2). Do not use values smaller
than those listed in Table 2. Increasing the capacitor
values (e.g., by a factor of 2) reduces ripple on the
transmitter outputs and slightly reduces power con-
sumption. C2, C3, and C4 can be increased without
changing C1
’
s value. However, do not increase C1
without also increasing the values of C2, C3, and C4 to
maintain the proper ratios (C1 to the other capacitors).
When using the minimum required capacitor values,
make sure the capacitor value does not degrade
excessively with temperature. If in doubt, use capacitors
with a larger nominal value. The capacitor
’
s equivalent
series resistance (ESR), which usually rises at low tem-
peratures, influences the amount of ripple on V+ and V-.
Power-Supply Decoupling
In most circumstances, a 0.1μF bypass capacitor is
adequate. In applications that are sensitive to power-
supply noise, decouple V
CC
to ground with a capacitor of
the same value as charge-pump capacitor C1. Connect
bypass capacitors as close to the IC as possible.
Transmitter Outputs when
Exiting Shutdown
Figure 2 shows two transmitter outputs when exiting
shutdown mode. As they become active, the two
transmitter outputs are shown going to opposite RS-232
levels (one transmitter input is high; the other is low).
Each transmitter is loaded with 3k
in parallel with
1000pF. The transmitter outputs display no ringing or
undesirable transients as they come out of shutdown.
Note that the transmitters are enabled only when the
magnitude of V- exceeds approximately 2.5V.
M
2.5V, ±15kV ESD-Protected RS-232
Transceivers for PDAs and Cell Phones
8
_______________________________________________________________________________________
CHARGE-CURRENT
LIMIT RESISTOR
DISCHARGE
RESISTANCE
STORAGE
CAPACITOR
Cs
150pF
R
50M
to 100M
R
D
330
HIGH-
VOLTAGE
DC
SOURCE
DEVICE
UNDER
TEST
Figure 4a. IEC 1000-4-2 ESD Test Model
tR = 0.7ns to 1ns
30ns
60ns
t
100%
90%
10%
I
P
I
Figure 4b. IEC 1000-4-2 ESD Generator Current Waveform
Table 2. Minimum Required Capacitor
Values
V
CC
(V)
C1–C4
(μF)
2.5 to 3.0
0.1
相關PDF資料 |
PDF描述 |
|---|---|
| MAX3388E | Dual LVDS Receiver 8-MSOP -40 to 85 |
| MAX3388ECUG | Dual LVDS Receiver 8-MSOP-PowerPAD -40 to 85 |
| MAX3389ECUG | Dual LVDS Receiver 8-MSOP-PowerPAD -40 to 85 |
| MAX3441EAPA | 【15kV ESD-Protected, 【60V Fault-Protected, 10Mbps, Fail-Safe RS-485/J1708 Transceivers |
| MAX3442EAPA | 【15kV ESD-Protected, 【60V Fault-Protected, 10Mbps, Fail-Safe RS-485/J1708 Transceivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX3389EEUG+T | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3389EEUG-T | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX338C/D | 功能描述:多路器開關 IC RoHS:否 制造商:Texas Instruments 通道數量:1 開關數量:4 開啟電阻（最大值）:7 Ohms 開啟時間（最大值）: 關閉時間（最大值）: 傳播延遲時間:0.25 ns 工作電源電壓:2.3 V to 3.6 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UQFN-16 |
| MAX338C/D DIE | 制造商:Maxim Integrated Products 功能描述: |
| MAX338CEE | 功能描述:多路器開關 IC RoHS:否 制造商:Texas Instruments 通道數量:1 開關數量:4 開啟電阻（最大值）:7 Ohms 開啟時間（最大值）: 關閉時間（最大值）: 傳播延遲時間:0.25 ns 工作電源電壓:2.3 V to 3.6 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UQFN-16 |
發布緊急采購，3分鐘左右您將得到回復。