- 您現在的位置：買賣IC網 > PDF目錄383366 > MAX3388EEUG (MAXIM INTEGRATED PRODUCTS INC) 2.5V, 【15kV ESD-Protected RS-232 Transceivers for PDAs and Cell Phones PDF資料下載
參數資料
| 型號： | MAX3388EEUG |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 通用總線功能 |
| 英文描述： | 2.5V, 【15kV ESD-Protected RS-232 Transceivers for PDAs and Cell Phones |
| 中文描述： | DUAL LINE TRANSCEIVER, PDSO24 |
| 封裝： | 4.40 MM, 0.65 MM PITCH, MO-153AE, TSSOP-24 |
| 文件頁數： | 9/11頁 |
| 文件大?。?/td> | 276K |
| 代理商： | MAX3388EEUG |
M
2.5V, ±15kV ESD-Protected RS-232
Transceivers for PDAs and Cell Phones
High Data Rates
The MAX3388E/MAX3389E maintain RS-232-compatible
transmitter output voltages even at high data rates. Figure
5 shows a transmitter loopback test circuit. Figure 6 shows
a loopback test result at 250kbps, and Figure 7 shows the
same test at 460kbps. For Figure 6, all transmitters were
driven simultaneously at 250kbps into RS-232 loads in
parallel with 1000pF. For Figure 7, a single transmitter was
driven at 460kbps, and all transmitters were loaded with
an RS-232 receiver in parallel with 150pF.
Power Switch
The MAX3388E/MAX3389E contain an internal switch
for powering external circuitry. This can be used to
power hot-sync circuitry or other low-power circuitry.
The switch on- resistance is typically 62
. The SWIN
side of the switch is ESD protected to ±15kV.
Logic-Level I/O
In addition to the traditional RS-232 I/O, the
MAX3388E/MAX3389E have a logic-level transceiver
from the RS-232 connector side to the CMOS-logic
side. The input impedance is typically 30k
, and the
output is open drain. The logic level I/O is active during
shutdown for the MAX3389E.
This I/O transceiver is useful for hot syncing or other
dedicated communication capability. The input is ESD
protected to ±15kV.
Typical PDA/Cell-Phone Application
The MAX3388E/MAX3389E designed with PDA applica-
tions in mind. Two transmitters and two receivers handle
standard full-duplex communication protocol, while an
extra transmitter allows a ring indicator (RI) signal to alert
the UART on the PC. Without the ring indicator transmit-
ter, solutions for these applications would require soft-
ware-intensive polling of the cradle inputs.
The RI signal is generated when a PDA, cellular phone, or
other
“
cradled
”
device is plugged into its cradle. This
generates a logic-low signal to RI transmitter input, creat-
ing +3.7V at the ring indicate pin. The PC
’
s UART RI input
is the only pin that can generate an interrupt from signals
arriving through the RS-232 port. The interrupt routine for
this UART will then service the RS-232 full-duplex com-
munication between the PDA and the PC.
As cell phone design becomes more like that of PDAs,
cell phones will require similar docking ability and com-
munication protocol. Cell phones operate on a single
lithium-ion (Li+) battery and generate a regulated out-
put voltage of +2.35V to +3V from the phone connector.
The baseband logic coming from the phone connector
can be as low as 1.8V at the transceivers. To prevent
forward biasing of a device internal to the cell phone,
the MAX3388E/MAX3389E come with a logic power-
supply pin (V
L
) that limits the logic levels presented to
MAX3388E
MAX3389E
5k
R_ IN
R_ OUT
C2-
C2+
C1-
C1+
V-
V+
V
CC
C4
C3
C1
C2
0.1
μ
F
V
CC
SHDN
T_ OUT
T_ IN
GND
V
CC
C
L
Figure 5. Loopback Test Circuit
1
μ
s/div
T1IN
T1OUT
2V/div
5V/div
R1OUT
5V/div
C
L
= 1000pF
Figure 6. Loopback Test Results at 250kbps
_______________________________________________________________________________________
9
相關PDF資料 |
PDF描述 |
|---|---|
| MAX3389EEUG | 2.5V, 【15kV ESD-Protected RS-232 Transceivers for PDAs and Cell Phones |
| MAX3388E | Dual LVDS Receiver 8-MSOP -40 to 85 |
| MAX3388ECUG | Dual LVDS Receiver 8-MSOP-PowerPAD -40 to 85 |
| MAX3389ECUG | Dual LVDS Receiver 8-MSOP-PowerPAD -40 to 85 |
| MAX3441EAPA | 【15kV ESD-Protected, 【60V Fault-Protected, 10Mbps, Fail-Safe RS-485/J1708 Transceivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX3388EEUG+ | 功能描述:RS-232接口集成電路 2.5V Transceiver for PDAs & Cells RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3388EEUG+T | 功能描述:RS-232接口集成電路 2.5V Transceiver for PDAs & Cells RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3388EEUG-T | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3389ECUG | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3389ECUG+ | 功能描述:RS-232接口集成電路 2.5V Transceiver for PDAs & Cells RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
發布緊急采購，3分鐘左右您將得到回復。