- 您現在的位置：買賣IC網 > PDF目錄383361 > MAX3222EWN (MAXIM INTEGRATED PRODUCTS INC) 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors PDF資料下載
參數資料
| 型號： | MAX3222EWN |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 通用總線功能 |
| 英文描述： | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| 中文描述： | LINE TRANSCEIVER, PDSO18 |
| 封裝： | SO-18 |
| 文件頁數： | 8/16頁 |
| 文件大?。?/td> | 268K |
| 代理商： | MAX3222EWN |
M
3.0V to 5.5V, Low-Power, up to 1Mbps, True RS-232
Transceivers Using Four 0.1μF External Capacitors
8
_______________________________________________________________________________________
RS -232 Rec eivers
The receivers convert RS-232 signals to CMOS-logic out-
put levels. The MAX3222/MAX3237/MAX3241 receivers
have inverting three-state outputs. In shutdown, the
receivers can be active or inactive (Table 1).
The complementary outputs on the MAX3237 (R1OUTB)
and the MAX3241 (R1OUTB, R2OUTB) are always active,
regardless of the state of
EN
or
SHDN
. This allows for
Ring Indicator applications without forward biasing other
devices connected to the receiver outputs. This is ideal
for systems where V
CC
is set to 0V in shutdown to
accommodate peripherals, such as UARTs (Figure 2).
MAX 3222/MAX 3237/MAX 3241
S hutdown Mode
Supply current falls to less than 1μA in shutdown mode
(
SHDN
= low). When shut down, the device’s charge
pumps are turned off, V+ is pulled down to V
CC
, V- is
pulled to ground, and the transmitter outputs are dis-
abled (high impedance). The time required to exit shut-
down is typically 100μs, as shown in Figure 3. Connect
SHDN
to V
CC
if the shutdown mode is not used.
SHDN
has no effect on R_OUT or R_OUTB.
MAX 3222/MAX 3237/MAX 3241
Enable Control
The inverting receiver outputs (R_OUT) are put into a
high-impedance state when
EN
is high. The complemen-
tary outputs R1OUTB and R2OUTB are always active,
regardless of the state of
EN
and
SHDN
(Table 1).
EN
has no effect on T_OUT.
__________Applic ations Information
Capac itor S elec tion
The capacitor type used for C1–C4 is not critical for
proper operation; polarized or nonpolarized capacitors
can be used. The charge pump requires 0.1μF capaci-
tors for 3.3V operation. For other supply voltages, refer to
Table 2 for required capacitor values. Do not use values
lower than those listed in Table 2. Increasing the capaci-
tor values (e.g., by a factor of 2) reduces ripple on the
transmitter outputs and slightly reduces power consump-
tion. C2, C3, and C4 can be increased without changing
C1’s value. However, do not increase C1 without also
increasing the values of C2, C3, and C4, to maintain the
proper ratios (C1 to the other capacitors).
When using the minimum required capacitor values,
make sure the capacitor value does not degrade exces-
sively with temperature. If in doubt, use capacitors with a
higher nominal value. The capacitor’s equivalent series
resistance (ESR), which usually rises at low tempera-
tures, influences the amount of ripple on V+ and V-.
MAX3237
MAX3241
T1OUT
R1OUTB
Tx
5k
UART
V
CC
T1IN
LOGIC
TRANSITION
DETECTOR
R1IN
R1OUT
EN = V
CC
SHDN = GND
V
CC
TO
μ
P
Rx
PREVIOUS
RS-232
Tx
UART
PROTECTION
DIODE
PROTECTION
DIODE
SHDN = GND
V
CC
V
CC
GND
Rx
5k
a
)
OLDER RS-232: POWERED-DOWN UART DRAWS CURRENT FROM
ACTIVE RECEIVER OUTPUT IN SHUTDOWN.
b
)
NEW MAX3237/MAX3241: EN SHUTS DOWN RECEIVER OUTPUTS (EXCEPT FOR
B OUTPUTS), SONOCURRENT FLOWS TOUART IN SHUTDOWN. B OUTPUTS
INDICATE RECEIVER ACTIVITY DURING SHUTDOWN WITH EN HIGH.
GND
Figure 2. Detection of RS-232 Activity when the UART and
Interface are Shut Down; Comparison of MAX3237/MAX3241
(b) with Previous Transceivers (a).
相關PDF資料 |
PDF描述 |
|---|---|
| MAX3232CWE | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| MAX3222CWN | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| MAX3232CSE | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| MAX3232EPE | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| MAX3232ESE | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX3222EWN+ | 功能描述:RS-232接口集成電路 3-5.5V 235kbps Transceiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3222EWN+T | 功能描述:RS-232接口集成電路 3-5.5V 235kbps Transceiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3222EWN-T | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3222IDB | 功能描述:RS-232接口集成電路 3-5.5V Multichannel Line Drvr/Rcvr RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3222IDBE4 | 功能描述:RS-232接口集成電路 3-5.5V Multichannel Line Drvr/Rcvr RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
發布緊急采購，3分鐘左右您將得到回復。