- 您現在的位置：買賣IC網 > PDF目錄384656 > MAX2463EAI (MAXIM INTEGRATED PRODUCTS INC) 900MHz Image-Reject Transceivers PDF資料下載
參數資料
| 型號： | MAX2463EAI |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 無繩電話/電話 |
| 英文描述： | 900MHz Image-Reject Transceivers |
| 中文描述： | TELECOM, CELLULAR, RF AND BASEBAND CIRCUIT, PDSO28 |
| 封裝： | 5.30 MM, MO-150, SSOP-28 |
| 文件頁數： | 12/14頁 |
| 文件大小： | 250K |
| 代理商： | MAX2463EAI |
M
900MHz Image-Reject Transceivers
12
______________________________________________________________________________________
coupling of the varactor is a way to reduce the effects
of high-varactor tolerance and increase loaded Q. For a
wider tuning range use larger values for C2 and C3 or a
varactor with a large capacitance ratio. Capacitor C26
is used to trim the tank oscillator frequency. Larger val-
ues for C26 helps negate the effect of stray PCB
capacitance and parasitic inductor capacitance (L3).
Choose a low-tolerance capacitor for C26.
For applications that require a wide tuning range and
low phase noise, a series coupled resonant tank may
be required as shown in Figure 4. This tank uses the
package inductance in series with inductors L1, L2,
and capacitance of varactor D1 to set the net equiva-
lent inductance which resonates in parallel with the
internal oscillator capacitance. Inductors L1 and L2 can
be implemented as microstrip inductors, saving com-
ponent cost. Bias is provided to the tank port through
chokes L3 and L5. R1 and R3 should be chosen large
enough to de-Q the parasitic resonance due to L3 and
L5, but small enough to minimize the voltage drop
across them due to bias current. Values for R1 and R3
should be kept between 0 and 50
. Proper high-fre-
quency bypassing (C1) should be used for the bias
voltage to eliminate power supply noise from entering
the tank.
Oscillator-Tank PC Board Layout
The parasitic PC board capacitance, as well as PCB
trace inductance and package inductance, can affect
oscillation frequency, so be careful in laying out the PC
board for the oscillator tank. Keep the tank layout as
symmetrical, tightly packed, and close to the device as
possible to minimize LO feedthrough. When using a PC
board with a ground plane, a cut-out in the ground
plane (and any other planes) below the oscillator tank
reduces parasitic capacitance.
Using an External Oscillator
If an external 50
LO signal source is available, it can
be used as an input to the TANK or
TANK
pin in place
of the on-chip oscillator (Figure 3). The oscillator signal
is AC coupled into the TANK pin and has a level of
about 0dBm from a 50
source. For proper biasing of
the oscillator input stage, the TANK and
TANK
pins
must be pulled up to the V
CC
supply via 50
resistors.
If the application requires overdriving the internal oscil-
lator, the pull-up resistors can be increased in order to
save power. If a differential LO source such as the
MAX2620 is available, AC couple the inverting output
into
TANK
.
MAX2420
MAX2421
MAX2422
MAX2460
MAX2463
TANK
50
50
EXT LO
EXTERNAL LO LEVEL IS
0dBm FROM A 50
SOURCE.
V
CC
C
BLOCK
0.01
μ
F
V
CC
TANK
Figure 3. Using an External Local Oscillator
MAX2420
MAX2421
MAX2422
MAX2460
MAX2463
TANK
L1
L
T
L
T
L2
L3
L4
L5
R1
R2
R3
C
i
C1
C2
V
CC
V
TUNE
TANK
Figure 4. Series Coupled Resonant Tank for Wide Tuning Range and Low Phase Noise
相關PDF資料 |
PDF描述 |
|---|---|
| MAX2421EAI | 900MHz Image-Reject Transceivers |
| MAX2460EAI | 900MHz Image-Reject Transceivers |
| MAX2420 | Hex Buffers/Drivers With Open-Collector High-Voltage Outputs 14-SO 0 to 70 |
| MAX2422EAI | Hex Buffers/Drivers With Open-Collector High-Voltage Outputs 14-SO 0 to 70 |
| MAX2420EAI | 900MHz Image-Reject Transceivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX2463EAI+ | 功能描述:射頻收發器 Integrated Circuits (ICs) RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| MAX2463EAI+T | 功能描述:射頻收發器 Integrated Circuits (ICs) RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| MAX2463EAI-T | 功能描述:射頻收發器 RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| MAX2463EVKIT-SO | 功能描述:射頻開發工具 RoHS:否 制造商:Taiyo Yuden 產品:Wireless Modules 類型:Wireless Audio 工具用于評估:WYSAAVDX7 頻率: 工作電源電壓:3.4 V to 5.5 V |
| MAX246CPL | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
發布緊急采購，3分鐘左右您將得到回復。