參數資料
型號: MAX221ECAE+
廠商: Maxim Integrated Products
文件頁數: 7/8頁
文件大?。?/td> 0K
描述: IC TXRX RS-232 5V 16-SSOP
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 76
類型: 收發器
驅動器/接收器數: 1/1
規程: RS232
電源電壓: 4.5 V ~ 5.5 V
安裝類型: 表面貼裝
封裝/外殼: 16-SSOP(0.209",5.30mm 寬)
供應商設備封裝: 16-SSOP
包裝: 管件
產品目錄頁面: 1400 (CN2011-ZH PDF)
Applications Information
Using
INVALID
INVALID indicates when an RS-232 signal is present at
the receiver input, and therefore when the port is in use.
INVALID can be used in alternative shutdown control
schemes where it relieves the processor from constantly
polling the port for activity.
Capacitor Selection
The capacitor type used for C1–C4 is not critical for
proper operation; either polarized or nonpolarized
capacitors are acceptable. If polarized capacitors are
used, connect polarity as shown in the
Typical Operating
Circuit. The charge pump requires 0.1F capacitors.
Increasing the capacitor values (e.g., by a factor of 2)
reduces ripple on the transmitter output and slightly
reduces power consumption. C2, C3, and C4 can be
increased without changing C1’s value. However, do not
increase C1’s value without also increasing the values of
C2, C3, and C4 to maintain the proper ratios (C1 to the
other capacitors).
When using the minimum 0.1F capacitors, make sure
the capacitance does not degrade excessively with
temperature. If in doubt, use capacitors with a larger
nominal value. The capacitor’s equivalent series resis-
tance (ESR) usually rises at low temperatures and influ-
ences the amount of ripple on V+ and V-.
Power-Supply Decoupling
In most circumstances, a 0.1F VCC bypass capacitor
is adequate. In applications that are sensitive to power-
supply noise, use a capacitor of the same value as the
charge-pump capacitor C1. Connect bypass capaci-
tors as close to the IC as possible.
Transmitter Output when
Exiting Shutdown
Figure 5 shows the transmitter output when exiting shut-
down mode. The transmitter is loaded with 3k
in paral-
lel with 2500pF. The transmitter output displays no
ringing or undesirable transients as the MAX221 comes
out of shutdown. Note that the transmitter is enabled only
when the magnitude of V- exceeds approximately 3V.
High Data Rates
The MAX221 maintains the RS-232 ±5.0V minimum
transmitter output voltage even at high data rates.
Figure 6 shows a transmitter loopback test circuit.
Figure 7 shows the loopback test result at 120kbps,
and Figure 8 shows the same test at 250kbps.
MAX221
+5V, 1A, Single RS-232 Transceiver
with AutoShutdown
_______________________________________________________________________________________
7
FORCEON
MASTER SHDN LINE
0.1
F1M
FORCEOFF
MAX221
POWER-
MANAGEMENT
UNIT
Figure 4. AutoShutdown with Initial Turn-On to Wake Up a
Mouse or Another System
V-
VCC
0
V+
0
VCC
tINVL
tWU
INVALID
REGION
RECEIVER
INPUT
VOLTAGE
(V)
INVALID
OUTPUT
(V)
tINVH
TRANSMITTER ENABLED, INVALID HIGH
RECEIVER
INPUT
LEVEL
AUTOSHUTDOWN, TRANSMITTER DISABLED,
1
A SUPPLY CURRENT, INVALID LOW
TRANSMITTER ENABLED, INVALID HIGH
-2.7V
-0.3V
+2.7V
+0.3V
0
INDETERMINATE
b)
a)
Figure 3. AutoShutdown Trip Levels
相關PDF資料
PDF描述
MAX244CQH-D IC 2DVR/2RCVR RS232 5V 44-PLCC
MAX251ESD IC DVR/RCVR DUAL RS232 5V 14SOIC
MAX253ESA IC XFRMR DRIVER RS485 8-SOIC
MAX262BENG+ IC FILTER ACT MPU PROG 24-DIP
MAX264BEPI+ IC FILTER BANDPASS PROG 28-DIP
相關代理商/技術參數
參數描述
MAX221ECAE+ 功能描述:RS-232接口集成電路 15kV ESD-Protected 5V 1uA RS-232 Trx RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝:
MAX221ECAE+ 制造商:Maxim Integrated Products 功能描述:SEMICONDUCTOR ((NW))
MAX221ECAE+T 功能描述:RS-232接口集成電路 15kV ESD-Protected 5V 1uA RS-232 Trx RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝:
MAX221ECAE-T 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝:
MAX221ECUE 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: