參數資料
型號: MAX1885
廠商: Maxim Integrated Products, Inc.
元件分類: DC/DC變換器
英文描述: Quad-Output TFT LCD DC-DC Converters with Buffer
中文描述: 四路輸出、TFT LCD DC-DC轉換器,帶有緩沖器
文件頁數: 22/38頁
文件大小: 1051K
代理商: MAX1885
M
Quad-Output TFT LCD DC-DC
Converters with Buffer
22
______________________________________________________________________________________
Negative Charge Pump
During the first half-cycle, the P-channel MOSFET turns
on, and flying capacitor C
X(NEG)
charges to V
SUPN
minus a diode drop (Figure 4). During the second half-
cycle, the P-channel MOSFET turns off, and the N-
channel MOSFET turns on, level shifting C
X(NEG)
. This
connects C
X(NEG)
in parallel with reservoir capacitor
C
OUT(NEG)
. If the voltage across C
OUT(NEG)
minus a
diode drop is greater than the voltage across C
X(NEG)
,
charge flows from C
OUT(NEG)
to C
X(NEG)
until the diode
(D5) turns off. The amount of charge transferred to the
output is controlled by the variable N-channel on-resis-
tance.
Low-Dropout Linear Regulator (MAX1778/
MAX1881/MAX1883/MAX1884 Only)
The MAX1778/MAX1881/MAX1883/MAX1884 contain a
low-dropout linear regulator (Figure 5) that uses an
internal PNP pass transistor (Q
P
) to supply loads up to
40mA. As illustrated in Figure 5, the 1.25V reference is
connected to the error amplifier, which compares this
reference with the feedback voltage and amplifies the
difference. If the feedback voltage is higher than the
reference voltage, the controller lowers the base cur-
rent of Q
P
, which reduces the amount of current to the
output. If the feedback voltage is too low, the device
increases the pass transistor base current, which
allows more current to pass to the output and increases
the output voltage. However, the linear regulator also
includes an output current limit to protect the internal
pass transistor against short circuits.
The low-dropout linear regulator monitors and controls
the pass transistor
s base current, limiting the output
current to 130mA (typ). In conjunction with the thermal
overload protection, this current limit protects the out-
put, allowing it to be shorted to ground for an indefinite
period of time without damaging the part.
VCOM Buffer
The MAX1778/MAX1880
MAX1885 include a VCOM
buffer, which uses an operational transconductance
amplifier (OTA) to provide a current output that is ideal
for driving capacitive loads, such as the backplane of a
TFT LCD panel. The unity-gain bandwidth of this cur-
rent-output buffer is:
GBW = gm/C
OUT
where gm is the amplifier
s transconductance. The
bandwidth is inversely proportional to the output
capacitor, so large capacitive loads improve stability;
however, lower bandwidth decreases the buffer
s tran-
sient response time. To improve the transient response
SUPL
C
SUPL
V
4.5V TO 15V
C
LDOOUT
LDOOUT
V
LDOOUT
1.25V TO (V
SUPL
- 0.3V)
FBL
V
REF
1.25V
ERROR
AMPLIFIER
GND
R8
R7
Q
P
CURRENT
LIMIT
THERMAL
SENSOR
V
LDOOUT
=
(
1 + R7
)
V
REF
V
REF
= 1.25V
R8
MAX1778
MAX1881
MAX1883
MAX1884
Figure 5. Low-Dropout Linear Regulator Block Diagram
相關PDF資料
PDF描述
MAX1883EUP Replaced by TMS320C6211B : Fixed-Point Digital Signal Processor 256-BGA 0 to 0
MAX1884EUP Fixed-Point Digital Signal Processor 256-BGA
MAX1885EUP Fixed-Point Digital Signal Processor 256-BGA
MAX1778EUG Quad-Output TFT LCD DC-DC Converters with Buffer
MAX1880EUG Quad-Output TFT LCD DC-DC Converters with Buffer
相關代理商/技術參數
參數描述
MAX1885EUP 功能描述:LCD 驅動器 Quad-Output TFT LCD DC-DC Converter with Buffer RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube
MAX1885EUP-T 功能描述:LCD 驅動器 Quad-Output TFT LCD DC-DC Converter with Buffer RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube
MAX1886ESA+ 制造商:Maxim Integrated Products 功能描述:HIGH-CURRENT VCOM DRIVE BUFFER - Rail/Tube
MAX1886EUK 制造商:Maxim Integrated Products 功能描述:HIGH-CURRENT VCOM DRIVE BUFFER - Rail/Tube
MAX1886EUK+T 功能描述:運算放大器 - 運放 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel