參數資料
型號: MAX1882EUG
廠商: MAXIM INTEGRATED PRODUCTS INC
元件分類: 穩壓器
英文描述: Quad-Output TFT LCD DC-DC Converters with Buffer
中文描述: 2.05 A SWITCHING REGULATOR, 625 kHz SWITCHING FREQ-MAX, PDSO24
封裝: 4.40 MM, 1.10 MM HEIGHT, MO-153AD, TSSOP-24
文件頁數: 20/38頁
文件大?。?/td> 1051K
代理商: MAX1882EUG
M
Quad-Output TFT LCD DC-DC
Converters with Buffer
20
______________________________________________________________________________________
Main Step-up Controller
During normal pulse-width modulation (PWM) opera-
tion, the MAX1778/MAX1880
MAX1885 main step-up
controllers switch at a constant frequency of 500kHz or
1MHz (see
Selector Guide
), allowing the use of low-
profile inductors and output capacitors. Depending on
the input-to-output voltage ratio, the controller regulates
the output voltage and controls the power transfer by
modulating the duty cycle (D) of each switching cycle:
On the rising edge of the internal clock, the controller
sets a flip-flop when the output voltage is too low, which
turns on the N-channel MOSFET (Figure 2). The induc-
tor current ramps up linearly, storing energy in a mag-
netic field. Once the sum of the feedback voltage error
amplifier, slope-compensation, and current-feedback
signals trip the multi-input comparator, the MOSFET
turns off, the flip-flop resets, and the diode (D1) turns
on. This forces the current through the inductor to ramp
back down, transferring the energy stored in the mag-
netic field to the output capacitor and load. The MOS-
FET remains off for the rest of the clock cycle. Changes
in the feedback voltage-error signal shift the switch-cur-
rent trip level, consequently modulating the MOSFET
duty cycle.
Under very light loads, an inherent switchover to pulse-
skipping takes place (Figure 3). When this occurs, the
controller skips most of the oscillator pulses in order to
reduce the switching frequency and gate charge loss-
es. When pulse-skipping, the step-up controller initiates
a new switching cycle only when the output voltage
drops too low. The N-channel MOSFET turns on, allow-
ing the inductor current to ramp up until the multi-input
comparator trips. Then, the MOSFET turns off and the
diode turns on, forcing the inductor current to ramp
down. When the inductor current reaches zero, the
diode turns off, so the inductor stops conducting cur-
rent. This forces the threshold between pulse-skipping
and PWM operation to coincide with the boundary
between continuous and discontinuous inductor-cur-
rent operation:
I
V
V
V
V
f
L
LOAD CROSSOVER
(
IN
MAIN
MAIN
IN
OSC
)
-
1
2
2
D
V
V
V
MAIN
IN
MAIN
-
MAX1778
MAX1880
MAX1881
MAX1882
MAX1883
MAX1884
MAX1885
V
MAIN
= 1 + R2
V
REF
V
REF
= 1.25V
S
R
I
LIM
Q
C
REF
V
1.25V
g
m
L1
D1
R1
R2
INTG
C
INTG
R
(OPTIONAL)
C
(OPTIONAL)
C
IN
C
OUT
V
(UP TO 13V)
V
(2.7V TO 5.5V)
OSC
(80% DUTY)
REF
GND
LX
FB
PGND
PWM
COMPARATOR
ERROR
AMPLIFIER
ILIM
COMPARATOR
Figure 2. Main Step-Up Converter block Diagram
相關PDF資料
PDF描述
MAX1779 32-Bit Digital Signal Controller with ROM 100-LQFP -40 to 125
MAX1779EUE 32-Bit Digital Signal Controller with ROM 100-LQFP -40 to 125
MAX177CNG 32-Bit Digital Signal Controller with ROM 100-BGA MICROSTAR -40 to 85
MAX177EWG CMOS 10-Bit A/D Converter with Track-and-Hold
MAX177MRG RECTIFIER 6A 600V R-6
相關代理商/技術參數
參數描述
MAX1882EUG-T 功能描述:LCD 驅動器 Quad-Output TFT LCD DC-DC Converter with Buffer RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube
MAX1883EUP 功能描述:LCD 驅動器 Quad-Output TFT LCD DC-DC Converter with Buffer RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube
MAX1883EUP-T 功能描述:LCD 驅動器 Quad-Output TFT LCD DC-DC Converter with Buffer RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube
MAX1884EUP 功能描述:LCD 驅動器 Quad-Output TFT LCD DC-DC Converter with Buffer RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube
MAX1884EUP-T 功能描述:LCD 驅動器 Quad-Output TFT LCD DC-DC Converter with Buffer RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube