- 您現在的位置：買賣IC網 > PDF目錄383333 > MAX1736EUT41-T (MAXIM INTEGRATED PRODUCTS INC) SOT23, Single-Cell Li+ Battery Charger for Current-Limited Supply PDF資料下載
參數資料
| 型號： | MAX1736EUT41-T |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | SOT23, Single-Cell Li+ Battery Charger for Current-Limited Supply |
| 中文描述： | BATTERY CHARGE CONTROLLER, PDSO6 |
| 封裝： | SOT-23, 6 PIN |
| 文件頁數： | 8/8頁 |
| 文件大?。?/td> | 179K |
| 代理商： | MAX1736EUT41-T |
M
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
8
_____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600
2000 Maxim Integrated Products
Printed USA
is a registered trademark of Maxim Integrated Products.
further slow switching edges and prevent transient
spikes.
C
CT
sets the minimum on-time and off-time according
to the following equations:
t
ON(MIN)
= 5
10
5
x C
CT
t
OFF(MIN)
= 1
10
5
x C
CT
Layout Guidelines
The MAX1736 controls the GATE slew rate; conse-
quently, PC board layout is not as sensitive to noise as
a high-frequency switching regulator. In addition, since
cell voltage is sensed both during and between high-
current pulses, the system is insensitive to ground
errors. However, Maxim recommends maintaining large
ground area and large traces for high-current paths.
Refer to the MAX1736EVKIT for a recommended layout
example.
Chip Information
TRANSISTOR COUNT: 1622
0.33
μ
F
0.1
μ
F
100k
0.22
μ
F
CT
BATT
GATE
2.2
μ
F
SINGLE
Li+ CELL
GND
IN
CURRENT-LIMITED
WALL CUBE
(800mA)
FDC638P
PFET
MAX1736
Figure 3. Simple Application Circuit
Package Information
6
SOT23, Single-Cell Li+ Battery Charger
for Current-Limited Supply
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1736EUT42-T | SOT23, Single-Cell Li+ Battery Charger for Current-Limited Supply |
| MAX1737 | Replaced by TMS320VC5506 : Digital Signal Processor 132-BQFP |
| MAX1737EVKIT | MAX1737 Evaluation Kit |
| MAX1737EEI | Stand-Alone Switch-Mode Lithium-Ion Battery-Charger Controller |
| MAX1739 | Wide Brightness Range CCFL Backlight Controllers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1736EUT42 | 制造商:Maxim Integrated Products 功能描述:SOT23, SINGLE-CELL LI+ BATTERY CHARGER FOR CU - Rail/Tube 制造商:Rochester Electronics LLC 功能描述: |
| MAX1736EUT42+T | 功能描述:電池管理 1Cell Li+ Battery Charger RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
| MAX1736EUT42-T | 功能描述:電池管理 1Cell Li+ Battery Charger RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
| MAX1736EUT-T | 功能描述:電池管理 RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
| MAX1737EEI | 功能描述:電池管理 Stand-Alone Switch-M L-Ion Battery Chargr RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。