- 您現在的位置：買賣IC網 > PDF目錄383329 > MAX1633EAI (MAXIM INTEGRATED PRODUCTS INC) Multi-Output, Low-Noise Power-Supply Controllers for Notebook Computers PDF資料下載
參數資料
| 型號： | MAX1633EAI |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | Multi-Output, Low-Noise Power-Supply Controllers for Notebook Computers |
| 中文描述： | SWITCHING CONTROLLER, 300 kHz SWITCHING FREQ-MAX, PDSO28 |
| 封裝： | 5.30 MM, 0.65 MM PITCH, SSOP-28 |
| 文件頁數： | 17/28頁 |
| 文件大小： | 237K |
| 代理商： | MAX1633EAI |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
Remote output-voltage sensing, while not possible in
fixed-output mode due to the combined nature of the
voltage-sense and current-sense inputs (CSL3 and
CSL5), is easy to do in adjustable mode by using the top
of the external resistor divider as the remote sense point.
When using adjustable mode, it is a good idea to
always set the “3.3V output” to a lower voltage than the
“5V output.” The 3.3V output must always be less than
VL, so that the voltage on CSH3 and CSL3 is within the
common-mode range of the current-sense inputs. While
VL is nominally 5V, it can be as low as 4.7V when lin-
early regulating, and as low as 4.2V when automatically
bootstrapped to CSH5.
S ec ondary Feedbac k Regulation Loop
(S ECFB or V
DD
)
A flyback-winding control loop regulates a secondary
winding output, improving cross-regulation when the
primary output is lightly loaded or when there is a low
input-output differential voltage. If V
DD
or SECFB falls
below its regulation threshold, the low-side switch is
turned on for an extra 1μs. This reverses the inductor
(primary) current, pulling current from the output filter
capacitor and causing the flyback transformer to oper-
ate in forward mode. The low impedance presented by
the transformer secondary in forward mode dumps cur-
rent into the secondary output, charging up the sec-
ondary capacitor and bringing V
DD
or SECFB back into
regulation. The secondary feedback loop does not
improve secondary output accuracy in normal flyback
mode, where the main (primary) output is heavily
loaded. In this condition, secondary output accuracy is
determined by the secondary rectifier drop, transformer
turns ratio, and accuracy of the main output voltage. A
linear post-regulator may still be needed to meet strict
output-accuracy specifications.
Devices with a 12OUT linear regulator have a V
DD
pin
that regulates at a fixed 13.5V, set by an internal resis-
tor divider. The MAX1631/MAX1634 have an adjustable
secondary output voltage set by an external resistor
divider on SECFB (Figure 5). Ordinarily, the secondary
regulation point is set 5% to 10% below the voltage nor-
mally produced by the flyback effect. For example, if
the output voltage as determined by turns ratio is 15V,
set the feedback resistor ratio to produce 13.5V.
Otherwise, the SECFB one-shot might be triggered
unintentionally, unnecessarily increasing supply current
and output noise.
12V Linear Regulator Output
(MAX 1630/MAX 1632/MAX 1633/MAX 1635)
The MAX1630/MAX1632/MAX1633/MAX1635 include a
12V linear regulator output capable of delivering 120mA
of output current. Typically, greater current is available
at the expense of output accuracy. If an accurate output
of more than 120mA is needed, an external pass tran-
MAX1631
MAX1634
POSITIVE
SECONDARY
OUTPUT
MAIN
OUTPUT
DH_
V+
SECFB
2.5V REF
R2
R1
1-SHOT
TRIG
DL_
WHERE V
REF
(NOMINAL) = 2.5V
+V
TRIP
= V
REF
(
1 + R2
)
M
Multi-Output, Low-Noise Power-S upply
Controllers for Notebook Computers
______________________________________________________________________________________
17
Figure 5. Adjusting the Secondary Output Voltage with SECFB
MAX1630
MAX1632
MAX1633
MAX1635
V
DD
OUTPUT
+12V OUTPUT
200mA
MAIN
OUTPUT
2N3906
0.1
μ
F
0.1
μ
F
0.1
μ
F
2.2
μ
F
10
μ
F
10
V+
V
DD
12OUT
DH_
DL_
Figure 6. Increased 12V Linear Regulator Output Current
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1634 | Multi-Output, Low-Noise Power-Supply Controllers for Notebook Computers |
| MAX1634CAI | Multi-Output, Low-Noise Power-Supply Controllers for Notebook Computers |
| MAX1634EAI | Multi-Output, Low-Noise Power-Supply Controllers for Notebook Computers |
| MAX1635 | Multi-Output, Low-Noise Power-Supply Controllers for Notebook Computers |
| MAX1635CAI | Multi-Output, Low-Noise Power-Supply Controllers for Notebook Computers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1633EAI-T | 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| MAX1634AEAI | 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| MAX1634AEAI+ | 功能描述:DC/DC 開關控制器 Multi-Out Low-Noise Power-Supply Ctlr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| MAX1634AEAI+T | 功能描述:DC/DC 開關控制器 Multi-Out Low-Noise Power-Supply Ctlr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| MAX1634AEAI-T | 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
發布緊急采購，3分鐘左右您將得到回復。