- 您現在的位置：買賣IC網 > PDF目錄383324 > MAX1517ETJ (MAXIM INTEGRATED PRODUCTS INC) TFT-LCD DC-DC Converters with Operational Amplifiers PDF資料下載
參數資料
| 型號： | MAX1517ETJ |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | TFT-LCD DC-DC Converters with Operational Amplifiers |
| 中文描述： | 1.6 A SWITCHING REGULATOR, 1380 kHz SWITCHING FREQ-MAX, PQCC32 |
| 封裝： | 5 X 5 MM, 0.80 MM HEIGHT, MO-220-WHHD2, TQFN-32 |
| 文件頁數： | 16/26頁 |
| 文件大?。?/td> | 919K |
| 代理商： | MAX1517ETJ |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
M
TFT-LCD DC-DC Converters with
Operational Amplifiers
16
______________________________________________________________________________________
Gate-Off Linear-Regulator Controller, REG N
The gate-off linear-regulator controller (REG N) is an
analog gain block with an open-drain p-channel output.
It drives an external npn pass transistor with a 6.8k
base-to-emitter resistor (Figure 1). Its guaranteed base-
drive source current is at least 1mA. The regulator
including Q2 in Figure 1 uses a 0.47μF ceramic output
capacitor and is designed to deliver 50mA at -8V. Other
output voltages and currents are possible with the proper
pass transistor and output capacitor (see the
Pass-
Transistor Selection
and
Stability Requirements
sections).
REG N is typically used to provide the TFT-LCD gate
drivers’ gate-off voltage. A negative voltage can be
produced using a charge-pump circuit as shown in
Figure 1. REG N is enabled after the voltage on REF
exceeds 1.0V. Each time it is enabled, the control goes
through a soft-start routine that ramps down its internal
reference DAC from V
REF
to 250mV in 128 steps.
Operational Amplifiers
The MAX1518 has five operational amplifiers, the
MAX1517 has three operational amplifiers, and the
MAX1516 has one operational amplifier. The operational
amplifiers are typically used to drive the LCD backplane
(VCOM) or the gamma-correction divider string. They
feature
±
150mA output short-circuit current, 13V/μs slew
rate, and 12MHz bandwidth. The rail-to-rail input and
output capability maximizes system flexibility.
Short-Circuit Current Limit
The operational amplifiers limit short-circuit current to
approximately
±
150mA if the output is directly shorted to
SUP or to BGND. If the short-circuit condition persists, the
junction temperature of the IC rises until it reaches the
thermal-shutdown threshold (+160
°
C typ). Once the junc-
tion temperature reaches the thermal-shutdown threshold,
an internal thermal sensor immediately sets the thermal
fault latch, shutting off all the IC’s outputs. The device
remains inactive until the input voltage is cycled.
Driving Pure Capacitive Load
The operational amplifiers are typically used to drive
the LCD backplane (VCOM) or the gamma-correction
divider string. The LCD backplane consists of a distrib-
uted series capacitance and resistance, a load that can
be easily driven by the operational amplifier. However,
if the operational amplifier is used in an application with
a pure capacitive load, steps must be taken to ensure
stable operation.
As the operational amplifier’s capacitive load increases,
the amplifier’s bandwidth decreases and gain peaking
increases. A 5
to 50
small resistor placed between
OUT_ and the capacitive load reduces peaking but also
reduces the gain. An alternative method of reducing
peaking is to place a series RC network (snubber) in par-
allel with the capacitive load. The RC network does not
continuously load the output or reduce the gain. Typical
values of the resistor are between 100
and 200
, and
the typical value of the capacitor is 10nF.
MAX1516
MAX1517
MAX1518
DRVP
FBP
V
MAIN
FROM CHARGE-PUMP
OUTPUT
NPN CASCODE
TRANSISTOR
PNP PASS
TRANSISTOR
V
GON
Figure 4. Using Cascoded npn for Charge-Pump Output
Voltages >28V
MAX1516
MAX1517
MAX1518
DRVP
FBP
V
GON
35V
LX
V
MAIN
13V
0.22
μ
F
0.1
μ
F
0.1
μ
F
0.47
μ
F
267k
1%
10.0k
1%
6.8k
Q1
Figure 5. The linear regulator controls the intermediate charge-
pump stage.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1518 | TFT-LCD DC-DC Converters with Operational Amplifiers |
| MAX1518ETJ | TFT-LCD DC-DC Converters with Operational Amplifiers |
| MAX151AENG | LJT 18C 18#20 SKT PLUG |
| MAX151BCNG | 300kHz 10-Bit A/D Converter with Refrence and T/H |
| MAX151BENG | 300kHz 10-Bit A/D Converter with Refrence and T/H |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1517ETJ+ | 功能描述:LCD 驅動器 TFT-LCD DC-DC Conv w/Op Amps RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| MAX1517ETJ+G104 | 功能描述:LCD 驅動器 TFT-LCD DC-DC Converters with Operational Amplifiers RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| MAX1517ETJ+T | 功能描述:LCD 驅動器 TFT-LCD DC-DC Conv w/Op Amps RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| MAX1517ETJ+TG104 | 功能描述:LCD 驅動器 TFT-LCD DC-DC Converters with Operational Amplifiers RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| MAX1517ETJ-T | 功能描述:LCD 驅動器 RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。