- 您現在的位置：買賣IC網 > PDF目錄383324 > MAX1515ETG (MAXIM INTEGRATED PRODUCTS INC) Low-Voltage, Internal Switch, Step-Down/DDR Regulator PDF資料下載
參數資料
| 型號： | MAX1515ETG |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | Low-Voltage, Internal Switch, Step-Down/DDR Regulator |
| 中文描述： | 4.7 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, QCC24 |
| 封裝： | 4 X 4 MM, 0.8 MM HEIGHT, MO-220-WGGD, TQFN-8 |
| 文件頁數： | 17/24頁 |
| 文件大小： | 504K |
| 代理商： | MAX1515ETG |
M
Low-Voltage, Internal Switch,
Step-Down/DDR Regulator
______________________________________________________________________________________
17
resistive divider between REF and ground (Figure 5).
Regulation is maintained for adjustable output voltages
when V
FB
= V
REFIN
. Use 100k
Ω
for R
B
. R
A
is given by
the equation:
where V
REF
= 1.1V.
The preset output voltages use an internally trimmed
resistor-divider network that sets the output voltage to
the correct level when REFIN is connected to REF.
Connecting REFIN to other voltage levels while using
the preset voltage modes results in a ratiometrically
scaled output voltage.
Output Voltage in DDR Mode
In DDR mode (MODE = V
CC
), the MAX1515 regulates
FB to the voltage set at REFIN. For DDR applications,
the termination supply must track to exactly half the
memory supply voltage. Figure 1 shows the MAX1515
configured for DDR applications.
Reference Buffer (REFOUT)
A unity-gain amplifier provides a buffered output for the
reference input (V
REFIN
) when MODE = V
CC
. This
transconductance amplifier must be compensated with
a 0.47μF or greater ceramic capacitor. Larger capaci-
tor values decrease the amplifier’s bandwidth, thereby
increasing the response time to dynamic input-voltage
changes. The buffer allows this dynamic reference to
remain within ±20mV of the input voltage (V
REFIN
) even
when loaded with ±5mA. The input voltage range of the
amplifier is 0.5V to 1.5V. The reference buffer shuts
down when MODE = GND.
Power-Good Output (PGOOD)
PGOOD is the open-drain output for a window compara-
tor that continuously monitors the output. PGOOD is
actively held low in shutdown and during soft-start. After
soft-start terminates, PGOOD becomes high impedance
as long as the respective output voltage is within ±10%
of the nominal regulation voltage. When the output volt-
age drops 10% below or rises 10% above the nominal
regulation voltage, the MAX1515 pulls the power-good
output (PGOOD) low by turning on the MOSFET (Figure
2). For logic-level output voltages, connect an external
pullup resistor between PGOOD and V
CC
. A 100k
Ω
resistor works well in most applications.
Thermal Shutdown
The MAX1515 features a thermal fault-protection circuit.
When the junction temperature rises above +165
°
C, a
thermal sensor shuts down the MAX1515 regardless of
V
SHDN
. The MAX1515 is reactivated after the junction
temperature cools to +150
°
C.
Thermal Resistance
Junction-to-ambient thermal resistance,
θ
JA
, is highly
dependent on the amount of copper area connected to
the exposed backside pad. Airflow over the board sig-
nificantly reduces
θ
JA
. For heatsinking purposes, evenly
distribute the copper area connected at the IC among
the high-current pins. Refer to the Maxim website
(www.maxim-ic.com) for QFN thermal considerations.
Power Dissipation
Power dissipation in the MAX1515 is dominated by
conduction losses in the two internal power switches.
Power dissipation due to supply current in the control
section and average current used to charge and dis-
charge the gate capacitance of the internal switches
(i.e., switching losses—PSL) is approximately:
PSL = C x V
IN
2
x f
SW
V
V
R
R
R
FB
REF
B
+
A
B
=
LOAD
CURRENT
INDUCTOR
CURRENT
OUTPUT
VOLTAGE
LX
VOLTAGE
V
REFIN
V
IN
V
OUT
GND
0
-2A
0
-2A
t
OFF
MAX1515
LX
GND
FB
PGND
V
OUT
FBSEL1
FBSEL0
MODE
REFIN
REF
R
B
R
A
C
OUT
L
Figure 4. Sink-Mode Waveforms
Figure 5. Setting VOUTwith a Resistive Voltage-Divider at REFIN
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1516 | TFT-LCD DC-DC Converters with Operational Amplifiers |
| MAX1516ETJ | TFT-LCD DC-DC Converters with Operational Amplifiers |
| MAX1517 | TFT-LCD DC-DC Converters with Operational Amplifiers |
| MAX1517ETJ | TFT-LCD DC-DC Converters with Operational Amplifiers |
| MAX1518 | TFT-LCD DC-DC Converters with Operational Amplifiers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1515ETG+ | 功能描述:直流/直流開關調節器 3A 1MHz Step-Down DDR Regulator RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| MAX1515ETG+T | 功能描述:直流/直流開關調節器 3A 1MHz Step-Down DDR Regulator RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| MAX1515ETG-T | 功能描述:直流/直流開關調節器 RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| MAX1515EVKIT | 制造商:Maxim Integrated Products 功能描述:3A 1MHZ LOW-VOLTAGE INTERNAL SWI - Rail/Tube |
| MAX15166EWE+ | 制造商:Maxim Integrated Products 功能描述:HIGH-EFFICIENCY, 4A, STEP-DOWN DC-DC REGULATOR WITH INTERNAL - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。